Material Safety Data Sheet
POOL AND TILE
SECTION I - IDENTIFICATION
MANUFACTURER'S NAME ........................................Haviland Consumer Products Incorporated
MANUFACTURER'S ADDRESS ..................................421 Ann St., N.W., Grand Rapids, MI 49504
PHONE NUMBER ......................................................... (616) 361-6691
EMERGENCY PHONE NUMBER.................................CHEMTREC (800) 424-9300
EFFECTIVE DATE........................................................7/7/99
TRADE NAME..............................................................POOL AND TILE
CHEMICAL FAMILY鈥? 鈥? 鈥? 鈥? 鈥? 鈥? 鈥? 鈥? 鈥? 鈥? 鈥? 鈥? 鈥? ...Miscellaneous Blend
SECTION II - HAZARDOUS INGREDIENTS
HAZARDOUS INGREDIENTS OSHA PEL TLV (Units) CAS NUMBER
Sodium Metasilicate 2.0 mg/m3 2.0 mg/m3 (Recommended) 6834-92-0
Recommended
SECTION III - PHYSICAL DATA
BOILING POINT ........................................................ Approximately 212oF
FREEZING POINT ..................................................... Approximately 30oF
VAPOUR PRESSURE................................................. Approximately 17
VAPOUR DENSITY (air=1) ....................................... No Information Available
SOLUBILITY IN H20 ................................................. Completely
ODOUR AND APPEARANCE ................................... Pink Liquid; Detergent Odor
SPECIFIC GRAVITY ................................................. 1.03
pH ............................................................................... Not Established
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
FLASHPOINT AND METHOD OF DETERMINATION ..........Will Not Burn
LOWER EXPLOSIVE LIMIT (% by Volume) Not Applicable
UPPER EXPLOSIVE LIMIT (% by Volume) Not Applicable
MEANS OF EXTINCTION.......................................................As for Surrounding Fires
SPECIAL FIRE FIGHTING PROCEDURES.............................None Currently Known
UNUSUAL FIRE HAZARD......................................................Prolonged contact with aluminum, tin, lead, and zinc may produce
flammable hydrogen gas.
4/29/02 1
Material Safety Data Sheet
SECTION V - HEALTH HAZARD DATA
CARCINOGENICITY, REPRODUCTIVE EFFECTS .......... None
NTP?.................................................................................... No
IARC MONOGRAPHS?....................................................... No
OVER EXPOSURE EFFECTS ............................................. Prolonged contact may cause burns to skin and eyes.
PRIMARY ROUTE(S) OF ENTRY...................................... Skin Contact
SPECIFIC FIRST AID PROCEDURES ................................ In case of contact: Immediately flush eyes and skin with plenty of water
for at least 15 minutes. For eyes, get medical attention. If inhaled:
Remove to fresh air. Ingestion: Do not induce vomiting. Give large
quantities of water, if conscious. Call a Physician Immediately.
EXPOSURE AGGRAVATED MEDICAL None Currently Known
CONDITIONS
SECTION VI - REACTIVITY DATA
CHEMICAL STABILITY ........................................... Stable
CONDITIONS TO AVOID ......................................... Not Applicable
INCOMPATIBLE MATERIALS................................. All acids, oxidizing agents, prolonged contact with aluminum, zinc, tin and
lead.
HAZARDOUS DECOMPOSITION PRODUCTS........ None Currently Known
HAZARDOUS POLYMERIZATION .......................... Will Not Occur
POLYMERIZATION AVOID ..................................... Not Applicable
SECTION VII - SPILL OR LEAK PROCEDURE
LEAK AND SPILL PROCEDURES............................ Contain spill. Absorb on sand or other industrial absorbent. Thoroughly flush
area to remove any residual product.
WASTE DISPOSAL.................................................... Neutralize with dilute acid. Comply with all federal, state and local
regulations.
SECTION VIII - SPECIAL PROTECTION
RESPIRATORY PROTECTION ................................. None Needed for Normal Use
VENTILATION .......................................................... Not Required for Normal Use
PROTECTIVE GLOVES............................................. Rubber or other impervious materials.
EYE PROTECTION.................................................... Chemical splash proof goggles.
OTHER PROTECTIVE EQUIPMENT ........................ A safety shower and eye bath should be available. For operations where spills
or splashing may occur, use an impervious body covering and boots.
HANDLING PROCEDURES AND EQUIPMENT ...... Store away from acids and oxidizing agents.
SECTION IX - SPECIAL PRECAUTIONS
HAZARD CLASS ....................................................... None
DOT SHIPPING NAME.............................................. Not Regulated
UN NUMBER ............................................................. None
REPORTABLE QUANTITY (RQ) .............................. NOT LISTED
REFERENCES ZZ1PLTL
4/29/02 2
|