Search   
MSDS 
:
 N-n-Butyldiethanolamine, 98%
CAS 
:
 102-79-4
SYNONYMS 
:
 2,2'-(Butylimino)diethanol; N-Butyldiethanolamine; Ethanol,     2,2'-(butylimino)di-; Bis(beta-hydroxyethyl)butylamine;     N-Butyl-2,2'-iminodiethanol; Butlydiethanolamine
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 102-79-4 |N-n-Butyldiethanolamine | 98 | 203-055-0 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.The toxicological
properties of this material have not been fully investigated.

Potential Health Effects
Eye:
Causes severe eye irritation and possible injury.
Skin:
Causes skin irritation.
Ingestion:
Causes gastrointestinal tract irritation.
Inhalation:
Causes respiratory tract irritation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Water may
be ineffective. Material is lighter than water and a fire may be
spread by the use of water. Vapors may be heavier than air. They
can spread along the ground and collect in low or confined areas.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry
chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Provide
ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Avoid contact with eyes, skin, and clothing. Keep
container tightly closed. Avoid ingestion and inhalation. Use with
adequate ventilation.
Storage:
Keep container closed when not in use. Store in a tightly closed
container. Store in a cool, dry, well-ventilated area away from
incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 102-79-4:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Viscous liquid
Color: pale yellow
Odor: None reported.
pH: Not available.
Vapor Pressure: 1 mm Hg @ 25 C
Viscosity: Not available.
Boiling Point: 273.0 - 275.0 deg C @ 741.00m
Freezing/Melting Point: -70 deg C
Autoignition Temperature: 260 deg C ( 500.00 deg F)
Flash Point: 126 deg C ( 258.80 deg F)
Explosion Limits, lower: 1.10 vol %
Explosion Limits, upper: 6.50 vol %
Decomposition Temperature:
Solubility in water: miscible
Specific Gravity/Density: .9680g/cm3
Molecular Formula: C8H19NO2
Molecular Weight: 161.24

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, strong oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, carbon dioxide, nitrogen.
Hazardous Polymerization: Will not occur.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 102-79-4: KK0525000
LD50/LC50:
CAS# 102-79-4: Oral, rat: LD50 = 4250 mg/kg.
Carcinogenicity:
N-n-Butyldiethanolamine -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 102-79-4: 1
Canada
CAS# 102-79-4 is listed on Canada's DSL List.
CAS# 102-79-4 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 102-79-4 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 10/14/1998 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
3-Hydroxy-2-quinoxalinecarboxylic acid 1204-75-7
(-)-Chloromethyl menthyl ether, 95% (GC), 97+% e.e. 26127-08-2
Ethyl L-Lactate (Pract), 90% (GC) 687-47-8
1,2,3,4-Tetrahydronaphthalene 119-64-2
Methyl sulfide, 99+% 75-18-3
Tetramethylammonium chloride, 98+% 75-57-0
2-Thiophene acetyl chloride, 99% 39098-97-0
Silver Perchlorate Hydrate, 99% 14242-05-8
Triphenyl phosphate, 99+% 115-86-6
4-Aminophthalonitrile 56765-79-8
Nickel Phthalocyanine, 95% (Titr.) 14055-02-8
Methyl P-Toluate 99-75-2
(+)-P-Menth-1-En-9-Ol, 97% 13835-75-1
Tetrapropylammonium hydroxide (25% in water) 4499-86-9
2,4-Dibromoaniline, 98% 615-57-6
Tert.-Butylbenzene, 99% 98-06-6
1,3-Dichloro-2-fluorobenzene, 98+% 2268-05-5
Benzamide (pract) 55-21-0
N-n-Butyldiethanolamine, 98% 102-79-4
Thiosalicylic Acid (Pract), 90% (Titr.) 147-93-3
3-Hydroxypicolinamide, 98+% 933-90-4
Dodecyltrimethylammonium chloride, 98% 112-00-5
Cyclohexene Sulfide, tech., ca.85% 286-28-2
1-(3,4-Dichlorophenyl)-1-Propanone, 99% 6582-42-9
4-Pentylphenol, 99% (GC) 14938-35-3
4-Iodobenzoic acid, 93% (titr.) 619-58-9
Methyl-Beta-D-Glucopyranoside Hemihydrate ,99% 709-50-2
N-Phenylglycine Ethyl Ester, 99% (Titr.) 2216-92-4
1-Phenylpyrazole, 99% (gc) 1126-00-7
2-Amino-3-Nitropyridine, 99% 4214-75-9
Thioacetamide, reagent ACS, 99+% 62-55-5
1-Dimethylamino-2-propanol, 99% 108-16-7
2,5-Dichloro-p-benzoquinone 615-93-0
2,3-Dimethyl-2-Butanol, 98% 594-60-5
Methylmalonic Acid, 96% 516-05-2
5-Aminovaleric Acid, 97% 660-88-8
Palladium on Barium Sulfate (5% Pd) 7440-05-3
Thioglycolic acid 68-11-1
1,3,5-Trimethoxybenzene, 99% 621-23-8
5-Methyl-2-hexanone 99% 110-12-3
Puromycin dihydrochloride hydrate 58-58-2
tert-Butyl ethyl ether, 97% 637-92-3
p-Anisidine 90-04-0
Harmine Hydrochloride Hydrate 343-27-1
3-Nonanone, 98% 925-78-0
N-Ethylcarbazole, 98.5% 86-28-2
(s,s)-jacobsen catalyst, 98% 135620-04-1
Thiourea 62-56-6
2-Chloro-5-Fluoronitrobenzene, 99+% 345-17-5
2,4-Dimethylanisole, 99% 6738-23-4

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net