**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 103-54-8 |Cinnamyl Acetate | 99% | 203-121-9 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
The toxicological properties of this material have not been fully
investigated.
Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause moderate skin irritation.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water. Wash mouth out with water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Will burn
if involved in a fire. Vapors may be heavier than air. They can
spread along the ground and collect in low or confined areas. Runoff
from fire control or dilution water may cause pollution.
Extinguishing Media:
Use water spray to cool fire-exposed containers. Use water spray,
dry chemical, carbon dioxide, or chemical foam. Use agent most
appropriate to extinguish fire.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Sweep up
or absorb material, then place into a suitable clean, dry, closed
container for disposal. Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use with adequate ventilation. Avoid
breathing dust, vapor, mist, or gas. Avoid contact with eyes, skin,
and clothing. Keep container tightly closed. Avoid ingestion and
inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 103-54-8:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Clear liquid
Color: colorless to yellow
Odor: Not available.
pH: Not available.
Vapor Pressure: 0.012 mm Hg @25
Viscosity: Not available.
Boiling Point: 262 - 265 deg C @ 760mmHg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 118 deg C ( 244.40 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: Insoluble.
Specific Gravity/Density: 1.054
Molecular Formula: C11H12O2
Molecular Weight: 176.0828
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, excess heat.
Incompatibilities with Other Materials:
Oxidizing agents, strong bases.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 103-54-8: GE2275000
LD50/LC50:
CAS# 103-54-8: Draize test, rabbit, skin: 100 mg/24H Moderate; Oral,
mouse: LD50 = 4750 mg/kg; Oral, rat: LD50 = 3300 mg/kg.
Carcinogenicity:
Cinnamyl Acetate -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 103-54-8: No information available.
Canada
CAS# 103-54-8 is listed on Canada's DSL List.
CAS# 103-54-8 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 103-54-8 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 5/30/2000 Revision #2 Date: 10/05/2004
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
4-Cyanophenyl isothiocyanate, 98%
| 2719-32-6 |
|
Chloro(cyclopentadienyl)(triphenylphosphine)nickel(II)
| 0-01-1 |
|
Chitosan
| 9012-76-4 |
|
Calcium Chloride, Anhydrous Powder, 96%
| 10043-52-4 |
|
1,2-Bis(2-chloroethoxy)ethane, 97%
| 112-26-5 |
|
Bis(pentamethylcyclopentadienyl)chromium
| 74507-61-2 |
|
Bis(benzene)chromium
| 1271-54-1 |
|
1'-Acetonaphthone, 95%
| 941-98-0 |
|
(Ethylcyclopentadienyl)(triphenylphosphine) copper(I)
| 308847-89-4 |
|
1,2,4-Benzenetricarboxylic acid, 98%
| 528-44-9 |
|
[2.2]Paracyclophane, 98%
| 1633-22-3 |
|
Diphenylmethylbismuthine
| 74724-75-7 |
|
P-Tolylacetic Acid, 99%
| 622-47-9 |
|
Tris(2-methoxyphenyl)bismuthine
| 83724-41-8 |
|
Benzophenone
| 119-61-9 |
|
Tris(cyclopentadienyl)cerium
| 1298-53-9 |
|
Tris(cyclopentadienyl)erbium
| 39330-74-0 |
|
Sodium hydroxide, 0.2 N solution
| 1310-73-2 |
|
1-Naphthylacetic acid, 95%
| 86-87-3 |
|
Benzotriazole
| 95-14-7 |
|
Cinnamyl Acetate, 99%
| 103-54-8 |
|
alpha-Ionone, synthetic
| 127-41-3 |
|
4-Aminobenzyl alcohol, 99%
| 623-04-1 |
|
5-Bromo-6-chloro-3-indoxyl-N-acetyl-beta-D-glucosaminide
| 5609-91-6 |
|
5-Bromo-4-chloro-3-indoxyl-N-acetyl-beta-D-glucosaminide
| 4264-82-8 |
|
2,5-Dimethylphenylhydrazine hydrochloride
| 56737-78-1 |
|
2-Bromophenylacetonitrile, 98%
| 19472-74-3 |
|
Hydroethidine
| 38483-26-0 |
|
(R)-(-)-Epichlorohydrin, 99%
| 106-89-8 |
|
(S)-(+)-Epichlorohydrin, 98%
| 106-89-8 |
|
3-Chloro-2-nitrotoluene
| 5367-26-0 |
|
3-Chloro-4-nitrotoluene
| 38939-88-7 |
|
5-Chloro-2-nitrotoluene, 98%
| 5367-28-2 |
|
3,5-Dichlorophenylhydrazine hydrochloride, 93%
| 63352-99-8 |
|
Acriflavine hydrochloride
| 8063-24-9 |
|
Tributylbismuthine
| 3692-81-7 |
|
Dicarbonyl(pentamethylcyclopentadienyl)chromium dimer
| 37299-12-0 |
|
Dicarbonylcyclopentadienylcobalt
| 12078-25-0 |
|
N,N-Dimethyl-p-Phenylenediamine Monohydrochloride, 90-95%
| 2052-46-2 |
|
Merrifield polymer resin, 1% crosslinked with DVB, 1.4-1.7 mmolCl/g,
| 9036-15-1 |
|
Merrifield polymer resin, 1% crosslinked with DVB, 1.9-2.1 mmol Cl/g,
| 9036-15-1 |
|
Merrifield polymer resin, 1% crosslinked with DVB, 2.8-3.0 mmol Cl/g,
| 9036-15-1 |
|
Merrifield polymer resin, 1% crosslinked with DVB, 1.6-1.8 mmol Cl/g,
| 9036-15-1 |
|
Benzoyl chloride
| 98-88-4 |
|
Merrifield polymer resin, 1% crosslinked with DVB, 1.8-2.0 mmol Cl/g,
| 9036-15-1 |
|
Merrifield polymer resin, 1% crosslinked with DVB, 2.5-3.0 mmol Cl/g,
| 9036-15-1 |
|
Merrifield polymer resin, 2% crosslinked with DVB, 0.6-0.8 mmol Cl/g,
| 9036-15-1 |
|
Benzyl acetate, 99+%
| 140-11-4 |
|
Merrifield polymer resin, 2% crosslinked with DVB, 1.4-1.6 mmol Cl/g,
| 9036-15-1 |
|
Merrifield polymer resin, 2% crosslinked with DVB, 2.0-2.2 mmol Cl/g,
| 9036-15-1 |
|
|