Search   
MSDS 
:
 2-(2-Hydroxyethyl)Pyridine, 99%
CAS 
:
 103-74-2
SYNONYMS 
:
 2-Pyridineethanol
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 103-74-2 |2-(2-Hydroxyethyl)Pyridine | 99 | 203-140-2 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.Hygroscopic (absorbs
moisture from the air).The toxicological properties of this material
have not been fully investigated.

Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation. May be absorbed through the skin. The
toxicological properties of this material have not been fully
investigated.
Ingestion:
Causes gastrointestinal irritation with nausea, vomiting and
diarrhea. The toxicological properties of this substance have not
been fully investigated.
Inhalation:
Causes respiratory tract irritation. The toxicological properties of
this substance have not been fully investigated.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Combustible liquid.
Vapors may be heavier than air. They can spread along the ground and
collect in low or confined areas. Containers may explode when heated.
Extinguishing Media:
Use water spray to cool fire-exposed containers. Do NOT get water
inside containers. Use water spray, dry chemical, carbon dioxide, or
appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Remove all
sources of ignition. Provide ventilation. Do not get water inside
containers.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Remove contaminated clothing and wash before reuse. Avoid contact
with eyes, skin, and clothing. Empty containers retain product
residue, (liquid and/or vapor), and can be dangerous. Keep container
tightly closed. Keep away from heat, sparks and flame. Avoid
ingestion and inhalation. Use with adequate ventilation. Do not allow
contact with water. Do not pressurize, cut, weld, braze, solder,
drill, grind, or expose empty containers to heat, sparks or open
flames. Keep from contact with moist air and steam.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. Store
protected from moisture.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 103-74-2:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: yellow
Odor: None reported.
pH: Not available.
Vapor Pressure: 10 mbar @ 105 C
Viscosity: 40 mPa 20.00 deg C
Boiling Point: 114.0 - 116.0 deg C @ 9.00mmH
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 92 deg C ( 197.60 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: >150 deg C
Solubility in water: soluble
Specific Gravity/Density: 1.0930g/cm3
Molecular Formula: C7H9NO
Molecular Weight: 123.15

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, ignition sources, moisture, excess heat,
strong oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong acids, strong bases.
Hazardous Decomposition Products:
Carbon monoxide, oxides of nitrogen, irritating and toxic fumes and
gases, carbon dioxide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 103-74-2: UT2970450
LD50/LC50:
CAS# 103-74-2: Oral, mouse: LD50 = 7750 mg/kg; Oral, rat: LD50 =
9500 mg/kg.
Carcinogenicity:
2-(2-Hydroxyethyl)Pyridine -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****

Other
No information available.

**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
WGK (Water Danger/Protection)
CAS# 103-74-2: 2
Canada
CAS# 103-74-2 is listed on Canada's DSL List.
CAS# 103-74-2 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 103-74-2 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 12/30/1998 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Ytterbium, 99,9%, -12 mm 7440-64-4
5-Chloro-1-indanone, 98% 42348-86-7
2-Methyl-1-butanethiol, 95% 1878-18-8
2-Methyl-3-Nitrobenzyl Chloride 60468-54-4
3-Methoxypropylamine, 99+% 5332-73-0
Eicosane, 99% 112-95-8
3-Benzylpyridine, 97% 620-95-1
Chloro-(chloromethyl)-dimethylsilane, 98% 1719-57-9
Rhodium on 1/8-inch alumina pellets ( 0.5% rh)
3-Methyl-1-hexene, 99% 3404-61-3
4-Fluorobenzimidazole-2-carboxylic acid 83431-74-7
(S)-(-)-5-(Hydroxymethyl)-2(5H)-furanone, 99% (99% e.e.) 78508-96-0
2-Acetylthiophene, 98%, Balance Mainly 3-Acetylthiophene 88-15-3
Phenylphosphinic acid sodium salt (50% aqueous solution), 46% (titr.) 4297-95-4
m-(Hydrazinosulfonyl)benzoic acid, 99% 7385-52-6
2-Hydroxyquinoline, 99% (UV-VIS) 59-31-4
Acrylamido Glycolic Acid, Anhydrous, 98% 6737-24-2
Naphthalene-d8, 98+ atom % D 1146-65-2
N-Ethyl-m-toluidine, 99+% 102-27-2
Thiazole, 99% 288-47-1
Ferrozine Iron Reagent, Monohydrate, 95+% (UV-Vis) 69898-45-9
1-(4-Methoxyphenyl)-2-methylpiperazine 35947-12-7
7-(2-Chloroethyl)-Theophylline, 97% 5878-61-5
Ammonium Hexabromoplatinate(IV), 99.99% 17363-02-9
2,3-Dibromopropanol, 96% 96-13-9
4-(Methylamino)butyric acid hydrochloride, 99% 6976-17-6
1,3-Propanediol, 98% 504-63-2
2-Fluorobenzylamine, 96% 89-99-6
L-Arabinose 5328-37-0
4-N,N-Dimethylaminoazobenzene-4'-isothiocyanate 7612-98-8
DL-aspartic acid magnesium salt tetrahydrate, 98% 215528-79-3
2-(Diisopropylamino)ethyl Chloride Hydro-Chloride, 97% 4261-68-1
5-Methoxysalicylic Acid, 98% 2612-02-4
1,2-Benzisoxazole, 95% 271-95-4
2,2'-(1,2-Ethenediyldi-4,1-Phenylene)- Bisbenzoxazole 1533-45-5
6,7-Dimethoxy-1,2,3,4-Tetrahydroisoquinoline-1-Thione, 99% 24456-59-5
3,3'-Dichloropivalic Acid, 99% 67329-11-7
3-Indoleacrylic acid, 99% 1204-06-4
1,2,3,6,7,8-Hexahydropyrene,98% 1732-13-4
9H-fluorene-4-carboxylic acid, 96% 6954-55-8
Methylamine Hydrochloride, P.A. 593-51-1
Potassium superoxide (chunks) 12030-88-5
N-Methyl-N-(trimethylsilyl)acetamide, 99% 7449-74-3
1-[4,4-Bis(4-fluorophenyl)butyl]piperazine 5631-35-6
2-(2-Hydroxyethyl)Pyridine, 99% 103-74-2
Scandium(iii)nitrate hydrate, 99.9%
9,10-Diphenylanthracene, 99% 1499-10-1
Nocodazole 99+% 31430-18-9
1-Octanesulfonic Acid Sodium Salt, 99+%, HPLC Grade anhydrous 5324-84-5
Barium perchlorate, anhydrous, 99% 13465-95-7

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net