**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 111-19-3 |Sebacoyl chloride | 99 | 203-843-4 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: C
Risk Phrases: 34
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Causes burns.Corrosive.
Potential Health Effects
Eye:
Contact with liquid is corrosive to the eyes and causes severe
burns.
Skin:
Contact with liquid is corrosive and causes severe burns and
ulceration.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes
gastrointestinal tract burns.
Inhalation:
Causes chemical burns to the respiratory tract.
Chronic:
Prolonged or repeated skin contact may cause dermatitis. Repeated
exposure may cause erosion of teeth.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Get medical aid immediately. Do NOT allow victim to rub eyes or keep
eyes closed. Extensive irrigation with water is required (at least 30
minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of
water for at least 15 minutes while removing contaminated clothing
and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4
cupfuls of milk or water. Never give anything by mouth to an
unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh
air immediately. If not breathing, give artificial respiration. If
breathing is difficult, give oxygen. Do NOT use mouth-to-mouth
resuscitation.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Vapors may be heavier
than air. They can spread along the ground and collect in low or
confined areas. Containers may explode if exposed to fire.
Extinguishing Media:
Substance is nonflammable; use agent most appropriate to extinguish
surrounding fire. Cool containers with flooding quantities of water
until well after fire is out.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Absorb spill using an absorbent, non-combustible
material such as earth, sand, or vermiculite. Do not use combustible
materials such as sawdust. Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Keep container tightly closed. Do not get on skin
or in eyes. Do not ingest or inhale. Use with adequate ventilation.
Discard contaminated shoes.
Storage:
Keep container closed when not in use. Store in a cool, dry,
well-ventilated area away from incompatible substances. Corrosives
area.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 111-19-3:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to minimize
contact with skin.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant a respirator's use. Follow the
OSHA respirator regulations found in 29 CFR 1910.134
or European Standard EN 149. Always use a NIOSH or
European Standard EN 149 approved respirator when
necessary.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: colourless
Odor: Not available.
pH: Not available.
Vapor Pressure: 12 mm Hg
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: -2.5 deg C
Autoignition Temperature: Not applicable.
Flash Point: 110 deg C ( 230.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: Not available.
Solubility in water: Decomposed by water
Specific Gravity/Density: 1.12
Molecular Formula: ClCO(CH2)8COCl
Molecular Weight: 239.0168
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Hydrogen chloride, irritating and toxic gases, hydrogen gas.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 111-19-3: HD8454250
LD50/LC50:
CAS# 111-19-3: Dermal, guinea pig: LD50 = 50 uL/kg; Draize test,
rabbit, eye: 45 uL Severe; Oral, mouse: LD50 = >1600 mg/kg; Oral,
rat: LD50 = 400 mg/kg.
Carcinogenicity:
Sebacoyl chloride -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: CORROSIVE LIQUID, N.O.S.*
Hazard Class: 8
UN Number: 1760
Packing Group: II
IMO
Shipping Name: CORROSIVE LIQUID, N.O.S.
Hazard Class: 8
UN Number: 1760
Packing Group: II
RID/ADR
Shipping Name: CORROSIVE LIQUID, N.O.S.
Hazard Class: 8
UN Number: 1760
Packing group: II
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 34 Causes burns.
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
WGK (Water Danger/Protection)
CAS# 111-19-3: No information available.
Canada
CAS# 111-19-3 is listed on Canada's DSL List.
CAS# 111-19-3 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 111-19-3 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 5/06/1998 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Nuclear Fast Red
| 6409-77-4 |
|
5-Sulfosalicylic acid dihydrate, p.a.
| 5965-83-3 |
|
5-Chloro-1-methyl-4-nitroimidazole
| 4897-25-0 |
|
Ethyl 2-ethylacetoacetate
| 607-97-6 |
|
tert-Butyl isothiocyanate, 99% (gc)
| 590-42-1 |
|
2-(4-Chlorosulfonylphenyl)ethyltrimethoxysilane 50% solution in
| 75-09-2 |
|
Methyl 2-Chloropropionate, 96%
| 17639-93-9 |
|
Sulfur, 99.5+%, Refined
| 7704-34-9 |
|
Sulfuric Acid, 95-98%, C.P.
| 7664-93-9 |
|
3-Octylthiophene, 90%
| 65016-62-8 |
|
7-Methoxycoumarin, 98+%
| 531-59-9 |
|
L-allo-Threonine, 99%
| 28954-12-3 |
|
1-(4-Chloromethylphenyl)-2-phenylethane, 98%
| 80676-35-3 |
|
L-Tartaric Acid, Reagent ACS, 99+%
| 87-69-4 |
|
3-Chloro-4-Fluorophenol, 99%
| 2612-57-9 |
|
2-Chloro-2-methylpropane, 99%
| 507-20-0 |
|
Testosterone, 99+% (tlc)
| 58-22-0 |
|
4-(4-Ethoxyphenylazo)-M-Phenylenediamine Monohydrochloride, 98%
| 2313-87-3 |
|
Tert-Amyl Alcohol, P.A.
| 75-85-4 |
|
Sodium amide
| 7782-92-5 |
|
4-(3-Phenylpropyl)pyridine, 97%
| 2057-49-0 |
|
Tetrachloroethylene
| 127-18-4 |
|
Tetradecane
| 629-59-4 |
|
Tetraethylammonium Bromide, 99+%
| 71-91-0 |
|
Tetrahydrofuran, 99+%, Stabilized with 0.025% BHT
| 109-99-9 |
|
Ethyl 3,5-dimethyl-1H-pyrrole-2-carboxylate, 98%
| 2199-44-2 |
|
Tetrahydroxy-P-Benzoquinone, 97% (Titr.)
| 319-89-1 |
|
1,2,3,4-Tetrahydronaphthalene, 95-98%
| 119-64-2 |
|
BOC-L-Phenylalanine, 99+%
| 13734-34-4 |
|
Antimony
| 7440-36-0 |
|
Tetramethylammonium hydroxide pentahydrate
| 75-59-2 |
|
Tetramethylammonium hydroxide, 25% in water
| 75-59-2 |
|
Thallous acetate, 99% (Titr.)
| 563-68-8 |
|
D-Leucine Methyl Ester Hydrochloride, 98%
| 5845-53-4 |
|
Thiamine hydrochloride
| 67-03-8 |
|
Ethyl 2-oxo-4-phenylbutyrate, 97%
| 64920-29-2 |
|
Mercaptoacetic acid, 80% in water
| 68-11-1 |
|
2-Chloromethyl-3,5-dimethyl-4-methoxypyridine hydrochloride
| 86604-75-3 |
|
Thiourea, P.A.
| 62-56-6 |
|
Sebacoyl Chloride, 99% (titr.)
| 111-19-3 |
|
Sodium Perchlorate Monohydrate, P.A.
| 7791-07-3 |
|
2'-Aminoacetophenone, 97% (GC)
| 551-93-9 |
|
1-Naphthoxyacetic acid, 97%
| 2976-75-2 |
|
2-Amino-4,6-dimethoxpyrimidine, 98%
| 36315-01-2 |
|
Carbamazepine, 99%
| 298-46-4 |
|
R-(+)-3-Pyrrolidnol, 98%
| 2799-21-5 |
|
Trimethylene sulfide, 97%
| 287-27-4 |
|
(S)-3-Pyrrolidinol, 99%
| 100243-39-8 |
|
D-(+)-Phenyllactic Acid, 98%
| 7326-19-4 |
|
Potassium trifluoromethanesulfonate, 99%
| 2926-27-4 |
|
|