Search   
MSDS 
:
 Triisopropanolamine,98%
CAS 
:
 122-20-3
SYNONYMS 
:
 1,1',1''-Nitrilotripropan-2-ol; 2-Propanol, 1,1',1''-nitrilotri-;     Triisopropanolamine; Tris(2-hydroxypropyl)amine;     Tris(2-hydroxy-1-propyl)amine
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 122-20-3 |Triisopropanolamine | 98 | 204-528-4 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes.Hygroscopic (absorbs moisture from the air).The
toxicological properties of this material have not been fully
investigated.

Potential Health Effects
Eye:
Causes severe eye irritation.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. Expected to be a low ingestion hazard.
Inhalation:
May cause respiratory tract irritation. Inhalation may be fatal as a
result of spasm, inflammation, edema of the larynx and bronchi,
chemical pneumonitis and pulmonary edema.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Immediately flush skin with plenty of water for at
least 15 minutes while removing contaminated clothing and shoes.
Wash clothing before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use extinguishing media most appropriate for the surrounding fire.
Cool containers with flooding quantities of water until well after
fire is out. In case of fire, use alcohol foam, foam, or dry
chemical.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Remove contaminated clothing and wash before reuse. Minimize dust
generation and accumulation. Avoid breathing dust, vapor, mist, or
gas. Avoid contact with eyes, skin, and clothing. Keep container
tightly closed. Avoid ingestion and inhalation. Use with adequate
ventilation. Wash clothing before reuse.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. Store
protected from moisture.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 122-20-3:

Russia: 5 mg/m3 TWA

Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Solid
Color: white - waxy
Odor: Not available.
pH: Not available.
Vapor Pressure: 1 mbar @ 100 deg C
Viscosity: 138 mPas 60 deg C
Boiling Point: 190 deg C @ 23.00mm Hg
Freezing/Melting Point: 48 - 50 deg C
Autoignition Temperature: 275 deg C ( 527.00 deg F)
Flash Point: 160 deg C ( 320.00 deg F)
Explosion Limits, lower: .80 vol %
Explosion Limits, upper: 5.80 vol %
Decomposition Temperature: >300 deg C
Solubility in water: Freely Soluble.
Specific Gravity/Density: 1.0200
Molecular Formula: C9H21NO3
Molecular Weight: 191.27

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat, exposure to
moist air or water.
Incompatibilities with Other Materials:
Moisture, strong oxidizing agents, strong acids.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, irritating and toxic fumes and
gases, carbon dioxide, cyanides.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 122-20-3: UB8750000
LD50/LC50:
CAS# 122-20-3: Draize test, rabbit, eye: 5 mg Severe; Oral, mouse:
LD50 = 2520 mg/kg; Oral, rabbit: LD50 = 11 gm/kg; Oral, rat: LD50 =
4730 mg/kg.
Carcinogenicity:
Triisopropanolamine -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36 Irritating to eyes.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
WGK (Water Danger/Protection)
CAS# 122-20-3: 1
Canada
CAS# 122-20-3 is listed on Canada's DSL List.
CAS# 122-20-3 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 122-20-3 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 3/15/1999 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Formaldehyde sodium bisulfite addition compound, 95% 870-72-4
1-(1'-Methylethyl)-4-piperidone, 99% 5355-68-0
1,4-Diaminobutane Dihydrochloride, 99+% 333-93-7
(+)-Diisopropyl l-tartrate, 99% 2217-15-4
Europium atomic absorption standard solution, 1 mg/ml Eu in 2% HNO3 7440-53-1
Silver (I) sulfide, 99.9% 21548-73-2
1-Benzyl-3-Methyl-4-Piperidone, 99% 34737-89-8
4-Nitrobenzyl chloride, 98% (hplc) 100-14-1
2,6-Dichlorotoluene, 99+% 118-69-4
N,N-Dimethylallylamine, 98% (GC) 2155-94-4
2-(2-Aminoethylamino)-5-Nitropyridine, 98% 29602-39-9
alpha,alpha'-Dichloro-p-xylene, 98% 623-25-6
3-Nitrobenzenesulfonic acid monohydrate, 95% (titr.) 5337-19-9
2-(Chloromethyl)-quinoline hydrochloride 97% 3747-74-8
4-Chloro-2-Fluorobenzylamine Hydrochloride 94% (Titr.) 0-00-1
3-Chlorobenzylbromide, 98+% 766-80-3
alpha-(Chloromethyl)-2,4-dichlorobenzyl alcohol, 98% 13692-14-3
4,4'-Bis(dimethylamino)benzil 17078-27-2
(S)-(+)-2-Aminobutane, 98% 513-49-5
Trioctanoin, 98% (gc) 538-23-8
(2R,3R)-1,4-Di-O-Tosyl-2,3-O-Isopropylidene-D-Threitol, 99+% 51064-65-4
Ethyl 2-Hydroxyisobutyrate, 99% 80-55-7
D-(-)-Leucinol, 97% (97+% e.e.) 53448-09-2
gamma-(4-Fluorophenyl)-gamma-butyrolactone 98% 51787-96-3
4-Aminobenzotrifluoride, 99% 455-14-1
2-Iodoanisole, 97% 529-28-2
3,5-Dibromosalicylaldehyde, 98% 90-59-5
Hydrocinnamonitrile, 99+% 645-59-0
Crotonylchloride, Tech., 90% 7732-18-5
N,n'-diphenyl-p-phenylenediamine (pract), 97% (titr.) 74-31-7
Methyl (z)-2-benzoylamino-3-dimethylaminopropenoate, 98% 56952-04-6
1,2-Phenylenediacetic acid, 99% 7500-53-0
6-Fluoro-1,2,3,4-Tetrahydro-2-Methyl-Quinoline, 98% 42835-89-2
4-Ethoxycarbonyloxy-3,5-dimethoxybenzoic acid, 96% 18780-67-1
Palmitic Acid 57-10-3
2-Methylbenzselenazole, 99% 2818-88-4
Octanophenone, 99+% 1674-37-9
Samarium(iii) oxide, 99.9% 12060-58-1
Cholesteryl benzoate, 98% 604-32-0
5-Thio-d-glucose, predominantly alpha-anomer 20408-97-3
Trichloromethanesulfonyl Chloride (Pract) 2547-61-7
4,4'-Bis(Heptyloxy)Azoxybenzene 2635-26-9
2-(P-Tolyl)Pyridine, 94% (GC) 4467-06-5
3,3'-Dithiodipropionic Acid, 99% 1119-62-6
n-Butyllithium, 2.5M solution in hexanes 109-72-8
2-Hydroxy-9-fluorenone, 97% 6949-73-1
(S)-Ethyl 2-Pyrrolidone-5-Carboxylate, 99% 7149-65-7
Copper chromite, catalyst 12018-10-9
1-Cyclopenteneacetonitrile, 95% 22734-04-9
Triisopropanolamine,98% 122-20-3

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net