Search   
MSDS 
:
 Dicyanobis(1,10-Phenanthroline) Iron, Trihydrate, 99% (Titr.)
CAS 
:
 14768-11-7
SYNONYMS 
:
 None.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 14768-11-7 |Iron,bis(cyano-c)bis(1,10-phenanthroli| 99 | 238-833-9 |
| |ne-n1,n10)- | | |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XN
Risk Phrases: 20/21/22

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Harmful by inhalation, in contact with skin and if swallowed.The
toxicological properties of this material have not been fully
investigated.

Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Get medical aid. Do NOT induce vomiting. If conscious and alert,
rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry
chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Minimize dust
generation and accumulation. Avoid contact with eyes, skin, and
clothing. Keep container tightly closed. Avoid ingestion and
inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 14768-11-7:

Belgium - TWA: (listed as iron salts (soluble)): 1 mg/m3 VLE (as
Malaysia: (listed as iron salts (soluble)): 1 mg/m3 TWA (as Fe)
Netherlands: (listed as iron salts (soluble)): 1 mg/m3 MAC (as Fe
Spain: (listed as iron salts (soluble)): 1 mg/m3 VLA-ED (as Fe)

Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Solid
Color: Not available.
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: Not available.
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density:
Molecular Formula: C26H16FeN6.3H2O
Molecular Weight: 522.34

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Hydrogen cyanide, carbon monoxide, irritating and toxic fumes and
gases, carbon dioxide, sulfur oxides (SOx), including sulfur oxide
and sulfur dioxide.
Hazardous Polymerization: Has not been reported

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 14768-11-7 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Iron,bis(cyano-c)bis(1,10-phenanthroline-n1,n10)- -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XN
Risk Phrases:
R 20/21/22 Harmful by inhalation, in contact with
skin and if swallowed.
Safety Phrases:
S 28A After contact with skin, wash immediately with
plenty of water.
S 36/37 Wear suitable protective clothing and
gloves.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 14768-11-7: No information available.
Canada
CAS# 14768-11-7 is listed on Canada's NDSL List.
CAS# 14768-11-7 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 14768-11-7 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 6/28/1999 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
1-Oxododecyl-beta-D-maltoside, 99+% 0-01-1
Ethyl methoxyacetate, 98% 3938-96-3
4,4-Bis(Methylthio)-2-Phenyl-But-1,3-Dien- 1,1-Dicarbonitrile, 98% 0-00-1
2-Ethyl-3-methylpyrazine, 99% 15707-23-0
2,2-Diphenylethylamine, 96% 3963-62-0
1,3-Dioxolane, 99%, Stab. With 50ppm BHT and 100ppm Triethylamine 646-06-0
3,9-Divinyl-2,4,8,10-Tetraoxaspiro 5.5 Undecane, 98% 78-19-3
Ammonium hexafluorotitanate(IV), 99.99% 16962-40-6
Trans, Trans-2,4-Heptadienal, Tech. 85-90% (GC, Total Isomers) 4313-03-5
Picolinic acid, 99% 98-98-6
2-Dodecen-1-Ylsuccinic Anhydride, Mixture of Isomers, Tech. CA 95% 26544-38-7
Anthracene-d10, 99+ atom % d 1719-06-8
3-Fluoroanisole, 99% 456-49-5
(S)-(+)-sec-Butanol, 99% 78-92-2
Acid Blue 80 4474-24-2
Dimethyl 3-Methyl-Trans-1,2-Cyclopropanedicarboxylate, 99% 28363-79-3
1-Butaneboronic acid, 99+% 4426-47-5
1-Methylcyclopentanol, 98% 1462-03-9
2-Amino-2-Methyl-1-Propanol, 99% 124-68-5
Yttrium(III) chloride hexahydrate 10025-94-2
Oxazine 4 Perchlorate, Laser Grade, 99% (UV-Vis) 41830-81-3
exo-2-Norbornyl formate, 99% 41498-71-9
Isobutyryl chloride, 98% 79-30-1
1,2,3-Trimethoxybenzene, 98% 634-36-6
Cobalt(II) chloride, anhydrous, 97% 7646-79-9
Benzyl-d7 chloride, 99+ atom % D 100-44-7
Tetrapentylammonium Chloride, 97% (Titr.) 4965-17-7
[tris(trimethylsilyl)]phosphine, 98% 15573-38-3
Quinoxaline, 99% 91-19-0
Tribromoacetaldehyde, 97% 115-17-3
Dihydro-5-phenyl-5-propyl-4,6(1h.5h)- pyrimidinedione, 99+% 59026-31-2
2-(Trifluoromethyl)benzyl alcohol, 97% 346-06-5
2,3-Dibromobutyric Acid, 98% 600-30-6
N-Tosylpyrrolidone 10019-95-1
1,2,4-Triazole, sodium derivative, tech., 90% 41253-21-8
1,3-Cyclopentanedione, 99% 3859-41-4
2-Phenylbenzothiazole, 97% 883-93-2
Diethylaminosulfur Trifluoride 38078-09-0
Chloro-dimethyl-(pentafluorophenyl)-silane , 98% 20082-71-7
Dicyanobis(1,10-Phenanthroline) Iron, Trihydrate, 99% (Titr.) 14768-11-7
(2-(1,3-Dioxan-2-yl)ethyl)triphenylphosphonium Bromide, 98% 69891-92-5
Diethyl 1,2-Cyclopropanedicarboxylate, 97% 20561-09-5
Isopropenyl chloroformate, 99% (stabilized with 50-100 ppm BHT) 57933-83-2
Crotonic acid, 98% 107-93-7
2'-(Trifluoromethyl)acetophenone, 99% 17408-14-9
4'-Iodoacetophenone, 98% 13329-40-3
Cyclooctane, 99+% 292-64-8
4-Bromo-2-Fluorocinnamic Acid, 97% (GC) 149947-19-3
Nonanoic Acid, 98+% (GC) 112-05-0
Selenium(iv) oxide, 99.999% 7446-08-4

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net