Search   
MSDS 
:
 1,2,3-Trifluorobenzene
CAS 
:
 1489-53-8
SYNONYMS 
:
 None.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 1489-53-8 |1,2,3-Trifluorobenzene | 99 | unlisted |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI F
Risk Phrases: 11 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Highly flammable. Irritating to eyes, respiratory system and skin.

Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
The toxicological properties of this substance have not been fully
investigated.
Inhalation:
Causes respiratory tract irritation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors can travel to a source of ignition and flash
back. Use water spray to keep fire-exposed containers cool. Flammable
liquid and vapor. Vapors may be heavier than air. They can spread
along the ground and collect in low or confined areas.
Extinguishing Media:
For small fires, use dry chemical, carbon dioxide, water spray or
alcohol-resistant foam. For large fires, use water spray, fog, or
alcohol-resistant foam. Use water spray to cool fire-exposed
containers. Water may be ineffective. Cool containers with flooding
quantities of water until well after fire is out.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Remove all sources of ignition.
Provide ventilation. A vapor suppressing foam may be used to reduce
vapors. Water spray may reduce vapor but may not prevent ignition in
closed spaces.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Use with adequate ventilation.
Ground and bond containers when transferring material. Avoid contact
with eyes, skin, and clothing. Empty containers retain product
residue, (liquid and/or vapor), and can be dangerous. Keep container
tightly closed. Keep away from heat, sparks and flame. Do not
pressurize, cut, weld, braze, solder, drill, grind, or expose empty
containers to heat, sparks or open flames. Avoid breathing vapor or
mist.
Storage:
Keep away from sources of ignition. Store in a tightly closed
container. Store in a cool, dry, well-ventilated area away from
incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 1489-53-8:


Personal Protective Equipment

Eyes:
Wear chemical splash goggles.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: clear, colorless to pale yellow
Odor: solvent odor
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 94-95 deg C
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: -3 deg C ( 26.60 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: 1.2800
Molecular Formula: C6H3F3
Molecular Weight: 132.08

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stability unknown.
Conditions to Avoid:
Ignition sources, excess heat, confined spaces.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide, hydrogen fluoride gas.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 1489-53-8 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
1,2,3-Trifluorobenzene -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Shipping Name: FLAMMABLE LIQUID, N.O.S.*
Hazard Class: 3
UN Number: 1993
Packing Group: II
IMO
Shipping Name: FLAMMABLE LIQUID, N.O.S.
Hazard Class: 3.2
UN Number: 1993
Packing Group: II
RID/ADR
Shipping Name: FLAMMABLE LIQUID, N.O.S.
Hazard Class: 3
UN Number: 1993
Packing group: II

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI F
Risk Phrases:
R 11 Highly flammable.
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 16 Keep away from sources of ignition - No
smoking.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 36/39 Wear suitable protective clothing and
eye/face protection.
WGK (Water Danger/Protection)
CAS# 1489-53-8: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 1489-53-8 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 1489-53-8 is not listed on the TSCA inventory.
It is for research and development use only.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 1/30/1998 Revision #4 Date: 3/21/2005

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
1,6-Dihydroxynaphthalene 575-44-0
1-(3-Fluorophenyl)Cyclohexanecarbonitrile, 98% 0-01-1
1-(4-Fluorophenyl)Cyclohexanecarbonitrile, 90 71486-43-6
n-Butylcyclohexane, 99+% 1678-93-9
Ketomalonic Acid Monohydrate, 99% 473-90-5
Deuterium Oxide 100%, Atom % D, Packaged in 0.75 ml. Ampules 7789-20-0
alpha-Bromo-o-xylene, 94% (GC) 89-92-9
5-Methyl-2-Hexanol, 98% 627-42-9
Agmatine Sulfate, 70% 2482-00-0
Ethyl 2-aminobenzoate, 99% 87-25-2
Allyl Phenyl Sulfone, 98% 16212-05-8
Amberlite IRP-69 Ion Exchange Resin 55464-99-8
Aminodiphenylmethane, 97% 91-00-9
Carbon Tetrabromide, Contains 5-10% Water 558-13-4
Cellulose acetate hydrogen phthalate, (17.0-22.0 acetyl content) 9004-38-0
4-Benzyloxy-3-Methoxybenzyl Alcohol, 97% 33693-48-0
HEPES 1M Solution 7365-45-9
O-(Tetrahydro-2H-pyran-2(RS)-yl)hydroxylamine 0-00-0
4-Hydroxybenzaldehyde, 99% (Titr.) 123-08-0
Ammonium Sulfobetaine-3, 5% Solution in Water.
L-tert-Leucine, 99% 20859-02-3
Benzyltriphenylphosphonium borohydride 18117-29-8
3,4-Dichlorobenzyl Alcohol, 98% 1805-32-9
Palmitoyl chloride, 98.0 112-67-4
1-Fluoro-2-methyl-N,N-bis(1-methylethyl)-1-propen-1-amine 0-00-0
Aqualine Anolyte-K 108-32-7
Methylaluminum sesquichloride, 1M solution in toluene 108-88-3
Dimethyl Phosphate 813-78-5
2,5-Dimethoxyphenethylamine 3600-86-0
Butane in Aerosol Container 106-97-8
4-Ethylbenzaldehyde 4748-78-1
Perfluoro-tert-butyl alcohol, 99% 2378-02-1
(+/-)-Indoline-2-carboxylic acid, 97.0 78348-24-0
1-Bromo-2-Methyl-4,4,4-trifluorobutane, 95+% 0-00-0
Chloral Betaine 2218-68-0
Aqualine Anolyte 67-56-1
Aqualine Complete 5, 2, & 1 111-90-0
Aqualine Solvent 67-56-1
Aqualine Titrant 2 67-56-1
Aqualine Catholyte-U 67-48-1
Sorbitan monooleate 1338-43-8
TAE 50X Solution 60-00-4
TAE 10X Solution 60-00-4
PBS 10X Solution 7447-40-7
1,2,3-Trifluorobenzene 1489-53-8
Dichloromethane, HPLC Grade, 99.9% 75-09-2
Selleger's Stain 7553-56-2
4-Hydroxy-7-Methoxycoumarin 17575-15-4
Trifluoroacetic Acid-D 99.5 Atom% D 599-00-8
Xanthone 90-47-1

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net