**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 16212-05-8 |Allyl Phenyl Sulfone | 98 | 240-338-8 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
The toxicological properties of this material have not been fully
investigated.
Potential Health Effects
Eye:
May cause eye irritation. The toxicological properties of this
material have not been fully investigated.
Skin:
May cause skin irritation. The toxicological properties of this
material have not been fully investigated.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. The toxicological properties of this substance have not
been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of soap and water for at
least 15 minutes while removing contaminated clothing and shoes. Wash
clothing before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure to fresh air immediately. If not breathing,
give artificial respiration. If breathing is difficult, give oxygen.
Get medical aid.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Containers may explode in
the heat of a fire. Vapors may be heavier than air. They can spread
along the ground and collect in low or confined areas.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Cool containers with
flooding quantities of water until well after fire is out. Use water
spray, dry chemical, carbon dioxide, or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up or absorb material, then place into a
suitable clean, dry, closed container for disposal. Provide
ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use with adequate ventilation. Avoid
contact with eyes, skin, and clothing. Keep container tightly closed.
Avoid ingestion and inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use adequate ventilation to keep airborne concentrations low.
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29CFR
1910.134 or European Standard EN 149. Always use a
NIOSH or European Standard EN 149 approved respirator
when necessary.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Appearance: pale yellow viscous
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 110-113C @ 0.5mmHg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: > 110 deg C (> 230.00 deg F)
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: 1.1890
Molecular Formula: C9H10O2S
Molecular Weight: 182.1288
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, excess heat, oxidizers.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, oxides of sulfur, irritating and toxic fumes and
gases, carbon dioxide.
Hazardous Polymerization: Has not been reported
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 16212-05-8: WR2400000
LD50/LC50:
Not available.
Carcinogenicity:
Allyl Phenyl Sulfone -
Not listed by ACGIH, IARC, NIOSH, NTP, or OSHA.
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 16212-05-8: No information available.
United Kingdom Occupational Exposure Limits
Canada
CAS# 16212-05-8 is listed on Canada's NDSL List.
CAS# 16212-05-8 is not listed on Canada's Ingredient Disclosure List.
Exposure Limits
US FEDERAL
TSCA
CAS# 16212-05-8 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 6/15/1998 Revision #1 Date: 8/02/2000
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
1,6-Dihydroxynaphthalene
| 575-44-0 |
|
1-(3-Fluorophenyl)Cyclohexanecarbonitrile, 98%
| 0-01-1 |
|
1-(4-Fluorophenyl)Cyclohexanecarbonitrile, 90
| 71486-43-6 |
|
n-Butylcyclohexane, 99+%
| 1678-93-9 |
|
Ketomalonic Acid Monohydrate, 99%
| 473-90-5 |
|
Deuterium Oxide 100%, Atom % D, Packaged in 0.75 ml. Ampules
| 7789-20-0 |
|
alpha-Bromo-o-xylene, 94% (GC)
| 89-92-9 |
|
5-Methyl-2-Hexanol, 98%
| 627-42-9 |
|
Agmatine Sulfate, 70%
| 2482-00-0 |
|
Ethyl 2-aminobenzoate, 99%
| 87-25-2 |
|
Allyl Phenyl Sulfone, 98%
| 16212-05-8 |
|
Amberlite IRP-69 Ion Exchange Resin
| 55464-99-8 |
|
Aminodiphenylmethane, 97%
| 91-00-9 |
|
Carbon Tetrabromide, Contains 5-10% Water
| 558-13-4 |
|
Cellulose acetate hydrogen phthalate, (17.0-22.0 acetyl content)
| 9004-38-0 |
|
4-Benzyloxy-3-Methoxybenzyl Alcohol, 97%
| 33693-48-0 |
|
HEPES 1M Solution
| 7365-45-9 |
|
O-(Tetrahydro-2H-pyran-2(RS)-yl)hydroxylamine
| 0-00-0 |
|
4-Hydroxybenzaldehyde, 99% (Titr.)
| 123-08-0 |
|
Ammonium Sulfobetaine-3, 5% Solution in Water.
| |
|
L-tert-Leucine, 99%
| 20859-02-3 |
|
Benzyltriphenylphosphonium borohydride
| 18117-29-8 |
|
3,4-Dichlorobenzyl Alcohol, 98%
| 1805-32-9 |
|
Palmitoyl chloride, 98.0
| 112-67-4 |
|
1-Fluoro-2-methyl-N,N-bis(1-methylethyl)-1-propen-1-amine
| 0-00-0 |
|
Aqualine Anolyte-K
| 108-32-7 |
|
Methylaluminum sesquichloride, 1M solution in toluene
| 108-88-3 |
|
Dimethyl Phosphate
| 813-78-5 |
|
2,5-Dimethoxyphenethylamine
| 3600-86-0 |
|
Butane in Aerosol Container
| 106-97-8 |
|
4-Ethylbenzaldehyde
| 4748-78-1 |
|
Perfluoro-tert-butyl alcohol, 99%
| 2378-02-1 |
|
(+/-)-Indoline-2-carboxylic acid, 97.0
| 78348-24-0 |
|
1-Bromo-2-Methyl-4,4,4-trifluorobutane, 95+%
| 0-00-0 |
|
Chloral Betaine
| 2218-68-0 |
|
Aqualine Anolyte
| 67-56-1 |
|
Aqualine Complete 5, 2, & 1
| 111-90-0 |
|
Aqualine Solvent
| 67-56-1 |
|
Aqualine Titrant 2
| 67-56-1 |
|
Aqualine Catholyte-U
| 67-48-1 |
|
Sorbitan monooleate
| 1338-43-8 |
|
TAE 50X Solution
| 60-00-4 |
|
TAE 10X Solution
| 60-00-4 |
|
PBS 10X Solution
| 7447-40-7 |
|
1,2,3-Trifluorobenzene
| 1489-53-8 |
|
Dichloromethane, HPLC Grade, 99.9%
| 75-09-2 |
|
Selleger's Stain
| 7553-56-2 |
|
4-Hydroxy-7-Methoxycoumarin
| 17575-15-4 |
|
Trifluoroacetic Acid-D 99.5 Atom% D
| 599-00-8 |
|
Xanthone
| 90-47-1 |
|
|