**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 16587-71-6 |Cyclohexanone, 4-(1,1-Dimethylpropyl)-| 98+ | 240-642-0 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to skin.The toxicological properties of this material
have not been fully investigated.
Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. Low hazard for usual industrial handling.
Inhalation:
Low hazard for usual industrial handling. May cause respiratory
tract irritation.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Get medical aid. Do NOT induce vomiting. If conscious and alert,
rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Vapors may be heavier
than air. They can spread along the ground and collect in low or
confined areas. Containers may explode when heated.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Cool containers with
flooding quantities of water until well after fire is out. Use water
spray, dry chemical, carbon dioxide, or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Avoid runoff into storm sewers and ditches which lead to waterways.
Clean up spills immediately, observing precautions in the Protective
Equipment section. Remove all sources of ignition. Absorb spill using
an absorbent, non-combustible material such as earth, sand, or
vermiculite. Do not use combustible materials such as sawdust.
Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Avoid contact with
eyes, skin, and clothing. Keep container tightly closed. Avoid
ingestion and inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 16587-71-6:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: colorless
Odor: cyclohexane-like
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 124-125 deg C @ 16.00mmHg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 104 deg C ( 219.20 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: .9200g/cm3
Molecular Formula: C11H20O
Molecular Weight: 168.28
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 16587-71-6: GW1960000
LD50/LC50:
CAS# 16587-71-6: Draize test, rabbit, skin: 500 mg/24H; Oral, rat:
LD50 = 4700 mg/kg; Skin, rabbit: LD50 = 4700 mg/kg.
Carcinogenicity:
Cyclohexanone, 4-(1,1-Dimethylpropyl)- -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 38 Irritating to skin.
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 16587-71-6: No information available.
Canada
CAS# 16587-71-6 is listed on Canada's DSL List.
CAS# 16587-71-6 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 16587-71-6 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 5/25/1999 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
(2r,3r)-(+)-2,3-epoxybutan, 97%
| 1758-32-3 |
|
3-Aminopyridine, 99%
| 462-08-8 |
|
2-Amino-6-Hydroxy-8-Mercaptopurine, 97%
| 28128-40-7 |
|
n-Octyl-tetraoxyethylene, 94%
| 19327-39-0 |
|
Ethyl Fluoroacetate, 97%
| 459-72-3 |
|
d-(-)Arginine hydrochloride
| 627-75-8 |
|
1,2-Dibromo-1,2-diphenylethane, 96%
| 5789-30-0 |
|
Chromotrope 2R
| 4197-07-3 |
|
Gluconic acid, potassium salt, 99%
| 299-27-4 |
|
Thioxanthen-9-One, 98%
| 492-22-8 |
|
2-Hydroxyethyl methacrylate, stabilized with 200-700 ppm MEHQ
| 150-76-5 |
|
Poly(ethylene), high density, average m.w. 125000
| 9002-88-4 |
|
4-Tert.-Amylcyclohexanone, 98+%
| 16587-71-6 |
|
1,8-Dibromooctane, 98%
| 4549-32-0 |
|
Methyl nicotinoylacetate
| 54950-20-8 |
|
3-Ethyl-3-pentanol, 98%
| 597-49-9 |
|
Polysulfone Resin, Sec. Stand., Typical M. W. 67000, Typical M.N.
| 25135-51-7 |
|
1,6-Diisocyanatohexane, 99+% (GC)
| 822-06-0 |
|
3,5-Dimethylthiophenol, 98%
| 38360-81-5 |
|
Indium atomic absorption standard solution, 1 mg/ml In in 2% HNO3
| 7440-74-6 |
|
4-Carboxy-2,2,5,5-tetramethyl-3-imidazoline-3-oxide-1-oxyl, free
| |
|
Lidoflazine, 98.5%
| 3416-26-0 |
|
N-(3-Aminopropyl)Methacrylamide Hydro-chloride, 99% (Titr.)
| 72607-53-5 |
|
o-Nitrophenyl-beta-D-galactopyranoside, 99+%
| 369-07-3 |
|
2-Benzylaminopyridine, 98%
| 6935-27-9 |
|
Tribromoacetic Acid, 99%
| 75-96-7 |
|
4-Chlorophenol, 99+%
| 106-48-9 |
|
3-Diethylaminopropylamine, 99+%
| 104-78-9 |
|
2,3-Diphenyl-1-Indenone, 97%
| 1801-42-9 |
|
4-Benzoylpiperidine hydrochloride,98%
| 72034-25-4 |
|
2,6-Dimethylanisole, 98.5%
| 1004-66-6 |
|
Xanthen-9-one
| 90-47-1 |
|
(-)-Carveol 98%, mixture of isomers
| 99-48-9 |
|
Isethionic acid, sodium salt, 98%
| 1562-00-1 |
|
Ethyl Caproate, 99+%
| 123-66-0 |
|
Phenyl Chlorothioformate, 98% (Titr.)
| 13464-19-2 |
|
Ethyl Sulfide, 98%
| 352-93-2 |
|
Poly(2-Acrylamido-2-Methyl-1-Propanesulfonic Acid), 10 Wt% Solution
| 7732-18-5 |
|
4-Aminophenylmercuric Acetate, Tech.
| 6283-24-5 |
|
Dimethyl adipate
| 627-93-0 |
|
Triphenylene, 98%
| 217-59-4 |
|
Niobium (V) Chloride, 99.8%
| 10026-12-7 |
|
Sym.-Diformylhydrazine, 97%
| 628-36-4 |
|
Copper Phthalocyanine Tetrasulfonic Acid Tetrasodium Salt, 60%
| 27360-85-6 |
|
(4R,5R)-4,5-Di(Dimethylaminocarbonyl)-2,2-Dimethyldioxolane, 99+%
| 63126-29-4 |
|
Iron (iii) citrate hydrate
| 17217-76-4 |
|
Naphthochrome Green
| 5715-76-4 |
|
Acetylenedicarboxylic acid, monopotassium salt, 98+ %
| 928-04-1 |
|
2-(4-Iodophenyl)-3-(4-nitrophenyl)-5- phenyltetrazolium chloride
| 146-68-9 |
|
2,2'-Dithiobis(1-aminonaphthalene), (dtan)
| 38262-57-6 |
|
|