Search   
MSDS 
:
 3-Trimethoxysilyl-propyl-methacrylate
CAS 
:
 2530-85-0
SYNONYMS 
:
 3-Methacryloxypropyltrimethoxysilane, MEMO
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 2530-85-0 |Methacrylic acid, 3-(trimethoxysilyl)p| 100.0 | 219-785-8 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/38 43

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes and skin. May cause sensitization by skin
contact.

Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
May cause irritation of the digestive tract.
Inhalation:
May cause respiratory tract irritation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Combustible liquid.
Containers may explode when heated.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam. Use water spray to cool fire-exposed
containers. Cool containers with flooding quantities of water until
well after fire is out.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Remove all sources of ignition.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Use with adequate ventilation. Avoid
contact with eyes, skin, and clothing. Empty containers retain
product residue, (liquid and/or vapor), and can be dangerous. Keep
container tightly closed. Keep away from heat, sparks and flame.
Avoid ingestion and inhalation. Do not pressurize, cut, weld, braze,
solder, drill, grind, or expose empty containers to heat, sparks or
open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Use adequate ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 2530-85-0:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to minimize
contact with skin.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Always use
a NIOSH or European Standard EN 149 approved
respirator when necessary.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: colorless
Odor: None reported.
pH: Not available.
Vapor Pressure: 10 mmHg @ 130 C
Viscosity: 2.5 cSt 25 C
Boiling Point: 190 deg C
Freezing/Melting Point: Not available.
Autoignition Temperature: 265 deg C ( 509.00 deg F)
Flash Point: 92 deg C ( 197.60 deg F)
Explosion Limits, lower: .90
Explosion Limits, upper: 5.40
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: Not available.
Molecular Formula: C10H20O5Si
Molecular Weight: 248.2225

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Oxidizing agents
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide, silicon dioxide.
Hazardous Polymerization: May occur.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 2530-85-0: UC0230000
LD50/LC50:
CAS# 2530-85-0: Draize test, rabbit, eye: 500 mg/24H Mild; Draize
test, rabbit, skin: 500 mg/24H Mild; Oral, rat: LD50 = 22600 uL/kg.
Oral,Rat:
Carcinogenicity:
Methacrylic acid, 3-(trimethoxysilyl)propyl ester -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Shipping Name: FLAMMABLE LIQUID, NOS
Hazard Class: 3
UN Number: 1993
Packing Group: II
IMO
Shipping Name: FLAMMABLE LIQUID, NOS
Hazard Class: 3
UN Number: 1993
Packing Group: II
RID/ADR
Shipping Name: FLAMMABLE LIQUID, NOS
Hazard Class: 3
UN Number: 1993
Packing group: II

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/38 Irritating to eyes and skin.
R 43 May cause sensitization by skin contact.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 28 After contact with skin, wash immediately
with...
WGK (Water Danger/Protection)
CAS# 2530-85-0: 1
Canada
CAS# 2530-85-0 is listed on Canada's DSL List.
CAS# 2530-85-0 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 2530-85-0 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 12/12/1997 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Ammonia Solution (~0.88 specific gravity) 1336-21-6
Ammonia Solution (~0.91 specific gravity) 1336-21-6
Ammonia Buffer Solution 60-00-4
Ammonia Reagent 1 139-33-3
Ammonia Monitor First Reagent 139-33-3
Ammonium Benzoate 1863-63-4
Uracil 66-22-8
Ammonia Reagent 2 1310-73-2
Urease Tablets
Uric Acid 69-93-2
Isovaleric Acid 503-74-2
N-Valeric Acid 109-52-4
Ammonia Monitor Second Reagent 1310-73-2
Ammonia Monitor Reagent 637-39-8
Phenol Liquefied (80% Solution in water) 108-95-2
3-Chloro-1H-Indazole, 99% 29110-74-5
Phenolphthalein Solution 64-17-5
beta-Methylphenethylamine, 99% 582-22-9
Vanadium Pentoxide 1314-62-1
Vinyl Acetate Polymerised 9003-20-7
Beeswax 8012-89-3
Tris (Hydroxymethyl) Aminomethane Carbonate 68123-29-5
Triton Kaowool Ceramic Fibre 65997-17-3
Tungsten Metal Powder 7440-33-7
3Thermit 0-00-0
Thermit Ignition Powder 1304-29-6
Iso-Thiocyanato Benzene 103-72-0
Thioacetic Acid 507-09-5
2'-Hydroxypropiophenone, 97% 610-99-1
3,5-Dichlorophenylhydrazine Hydrochloride, 98.0% 63352-99-8
0.1M Trimethylanilinium hydroxide 67-56-1
Magnesium acetate 142-72-3
Mordant Blue 9 3624-68-8
Magnesium Carbonate 12125-28-9
Vanadyl Sulfate Solution 7664-93-9
Tri-n-hexylamine 102-86-3
Trifluoromethane Sulfonic Anhydride 358-23-6
Triethyl Orthoformate 122-51-0
N-Trifluoroacetylimidazole 1546-79-8
Trimethylanilinium hydroxide, 0.1M in methanol 67-56-1
3-Trimethoxysilyl-propyl-methacrylate 2530-85-0
Triethylammonium Chloride 554-68-7
Tridecafluoroheptanoic Acid 375-85-9
Tricaine Methane Sulfonate 886-86-2
Trichlorofluoromethane 75-69-4
o-Toluidine 95-53-4
p-Toluic Acid 99-94-5
o-Toluic Acid 118-90-1
Toluene-4-Sulfonyl Chloride 98-59-9
Tri-Aryl Phosphate Synthetic

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net