**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 35444-44-1 |Methyladipoyl Chloride | 98 | 252-569-1 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: C
Risk Phrases: 14 34
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Reacts violently with water. Causes burns.Corrosive.Water-reactive.
Potential Health Effects
Eye:
Causes eye burns.
Skin:
Causes skin burns.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes
gastrointestinal tract burns.
Inhalation:
Causes chemical burns to the respiratory tract.
Chronic:
None
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Get medical aid immediately. Do NOT allow victim to rub eyes or keep
eyes closed. Extensive irrigation with water is required (at least 30
minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of
water for at least 15 minutes while removing contaminated clothing
and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4
cupfuls of milk or water. Never give anything by mouth to an
unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh
air immediately. If not breathing, give artificial respiration. If
breathing is difficult, give oxygen. Do NOT use mouth-to-mouth
resuscitation.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Water Reactive. Material will react with water and
may release a flammable and/or toxic gas. Use water spray to keep
fire-exposed containers cool. Decomposes at high temperatures,
resulting in toxic and corrosive products. Containers may explode in
the heat of a fire. Vapors may be heavier than air. They can spread
along the ground and collect in low or confined areas.
Extinguishing Media:
If water is the only media available, use in flooding amounts. Use
dry chemical to fight fire. DO NOT USE WATER! Cool containers with
flooding quantities of water until well after fire is out.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Absorb spill using an absorbent, non-combustible
material such as earth, sand, or vermiculite. Do not use combustible
materials such as sawdust. Provide ventilation. Do not get water
inside containers.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Keep container tightly closed. Do not get on skin or in eyes. Do not
ingest or inhale. Use with adequate ventilation. Do not allow contact
with water. Discard contaminated shoes.
Storage:
Keep container closed when not in use. Store in a cool, dry,
well-ventilated area away from incompatible substances. Keep away
from water. Corrosives area.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use process enclosure, local exhaust ventilation, or other
engineering controls to control airborne levels below recommended
exposure limits.
Exposure Limits
CAS# 35444-44-1:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to minimize
contact with skin.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: colorless to yellow
Odor: pungent odor
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 119 deg C @ 9mmHg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water: Reacts.
Specific Gravity/Density: 11.217
Molecular Formula: C7H11ClO3
Molecular Weight: 178.5282
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, moisture, acids, excess heat, bases.
Incompatibilities with Other Materials:
Acids (mineral, non-oxidizing, e.g. hydrochloric acid, hydrofluoric
acid, muriatic acid, phosphoric acid), bases.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization:
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 35444-44-1 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Methyladipoyl Chloride -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: CORROSIVE LIQUID, NOS
Hazard Class: 8
UN Number: 1760
Packing Group: II
IMO
Shipping Name: CORROSIVE LIQUID, NOS
Hazard Class: 8
UN Number: 1760
Packing Group: II
RID/ADR
Shipping Name: CORROSIVE LIQUID, NOS
Hazard Class: 8
UN Number: 1760
Packing group: II
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 14 Reacts violently with water.
R 34 Causes burns.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 36/39 Wear suitable protective clothing and
eye/face protection.
WGK (Water Danger/Protection)
CAS# 35444-44-1:
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 35444-44-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 35444-44-1 is not listed on the TSCA inventory.
It is for research and development use only.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 2/04/1998 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|