**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 75-76-3 |Tetramethylsilane | >99.0 | 200-899-1 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: F+
Risk Phrases: 12
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Extremely flammable.Moisture sensitive.The toxicological properties
of this material have not been fully investigated.
Potential Health Effects
Eye:
May cause eye irritation. May cause chemical conjunctivitis and
corneal damage.
Skin:
May cause skin irritation. May cause cyanosis of the extremities.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. The toxicological properties of this substance have not
been fully investigated. Ingestion of large amounts may cause CNS
depression.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated. Aspiration may
lead to pulmonary edema. Vapors may cause dizziness or suffocation.
May cause burning sensation in the chest.
Chronic:
None Effects may be delayed.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of soap and water.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid immediately. Do NOT induce vomiting. If conscious and alert,
rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
Containers can build up pressure if exposed to heat and/or fire. As
in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors may form an explosive mixture with air.
Vapors can travel to a source of ignition and flash back. During a
fire, irritating and highly toxic gases may be generated by thermal
decomposition or combustion. Use water spray to keep fire-exposed
containers cool. Water may be ineffective. Material is lighter than
water and a fire may be spread by the use of water. Flammable liquid
and vapor. Will be easily ignited by heat, sparks or flame.
Extinguishing Media:
For small fires, use dry chemical, carbon dioxide, water spray or
alcohol-resistant foam. Water may be ineffective. Water may spread
fire. If water is the only media available, use in flooding amounts.
Do NOT get water inside containers. For large fires, use water
spray, fog or alcohol-resistant foam. Do NOT use straight streams of
water. Cool containers with flooding quantities of water until well
after fire is out.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Clean up spills immediately,
observing precautions in the Protective Equipment section. Remove all
sources of ignition. Use a spark-proof tool. Provide ventilation. Do
not get water inside containers. A vapor suppressing foam may be
used to reduce vapors.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use only in a well-ventilated area.
Ground and bond containers when transferring material. Use
spark-proof tools and explosion proof equipment. Avoid contact with
eyes, skin, and clothing. Empty containers retain product residue,
(liquid and/or vapor), and can be dangerous. Take precautionary
measures against static discharges. Keep away from heat, sparks and
flame. Avoid ingestion and inhalation. Do not allow contact with
water. Do not pressurize, cut, weld, braze, solder, drill, grind, or
expose empty containers to heat, sparks or open flames. Keep from
contact with moist air and steam.
Storage:
Keep away from sources of ignition. Store in a tightly closed
container. Flammables-area. Storage under a nitrogen blanket has
been recommended. Store protected from moisture.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate general or
local explosion-proof ventilation to keep airborne levels to
acceptable levels.
Exposure Limits
CAS# 75-76-3:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: clear, colorless
Odor: None reported.
pH: Not available.
Vapor Pressure: 560 mmHg @ 20 C
Viscosity: Not available.
Boiling Point: 26.0 - 28.0 deg C @ 760.00mm
Freezing/Melting Point: -99 deg C
Autoignition Temperature: 450 deg C ( 842.00 deg F)
Flash Point: -27 deg C ( -16.60 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: insoluble
Specific Gravity/Density: .6480g/cm3
Molecular Formula: C4H12Si
Molecular Weight: 88.22
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures. May ignite
spontaneously in air by slightly elevating the temperature or
lowering the pressure.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, exposure to
moist air or water.
Incompatibilities with Other Materials:
Moisture.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide, silicon dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 75-76-3 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Tetramethylsilane -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: TETRAMETHYLSILANE
Hazard Class: 3
UN Number: 2749
Packing Group: I
IMO
Shipping Name: TETRAMETHYLSILANE
Hazard Class: 3.1
UN Number: 2749
Packing Group: I
RID/ADR
Shipping Name: TETRAMETHYLSILANE
Hazard Class: 3
UN Number: 2749
Packing group: I
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: F+
Risk Phrases:
R 12 Extremely flammable.
Safety Phrases:
S 7/9 Keep container tightly closed and in a
well-ventilated place.
S 16 Keep away from sources of ignition - No
smoking.
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 75-76-3: No information available.
Canada
CAS# 75-76-3 is listed on Canada's DSL List.
CAS# 75-76-3 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 75-76-3 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 4/20/1998 Revision #3 Date: 10/05/2004
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
4-tert.-Butylbenzoic acid, 99%
| 98-73-7 |
|
Sodium bisulfite, powder, p.a.
| 7446-09-5 |
|
1,2-Dibromoethane, 99%
| 106-93-4 |
|
1,2-Dichloroethane, 99.8+% (GC)
| 107-06-2 |
|
1,2-Dichloroethane, laser grade
| 107-06-2 |
|
1,2-Dichloroethane, reagent ACS
| 107-06-2 |
|
1,2-Dichloroethane, reagent ACS, spectro grade, 99+%
| 107-06-2 |
|
HEPES, Sodium Salt, 99%
| 75277-39-3 |
|
n-Butyl Lactate, 99% (GC)
| 138-22-7 |
|
Ethylenediamine
| 107-15-3 |
|
4-Chlorophenyl isocyanate
| 104-12-1 |
|
Iron (III) Chloride, Anhydrous, 98%
| 7705-08-0 |
|
N-(2-Chloroethyl)-Morpholine Hydrochloride, 99%
| 3647-69-6 |
|
Iron(iii) chloride hexahydrate, granulated, c.p.
| 10025-77-1 |
|
Iron(iii) chloride hexahydrate, p.a.
| 10025-77-1 |
|
Iron(iii) chloride hexahydrate, reagent acs
| 10025-77-1 |
|
4-(Trifluoromethyl)Benzophenone, 97%
| 728-86-9 |
|
s-(4-Nitrobenzyl)-6-thioinosine
| 38048-32-7 |
|
2,6-Dichlorobenzyl Alcohol, 99%
| 15258-73-8 |
|
Iron(III) nitrate nonahydrate, p.a.
| 7782-61-8 |
|
Isopropyl Acetate, 99%
| 108-21-4 |
|
Iron(II) sulfate heptahydrate, p.a.
| 7720-78-7 |
|
Florisil, 100-200 mesh
| 1343-88-0 |
|
Tetramethylsilane, 99.9+% ,NMR Grade
| 75-76-3 |
|
Diphosphorus Tetraiodide, 95%
| 13455-00-0 |
|
Epichlorohydrin
| 106-89-8 |
|
Formamide, 99.5+%
| 75-12-7 |
|
Formamide, polarographic and nonaqueous, titration grade
| 75-12-7 |
|
Formamide, spectro grade
| 75-12-7 |
|
Formamide, reagent ACS
| 75-12-7 |
|
Patent blue vf, indicator grade
| 129-17-9 |
|
Acid Fuchsin, High Purity Biological Stain
| 3244-88-0 |
|
Fumaric acid, 99%
| 110-17-8 |
|
Phenyl dichlorophosphate, 99%
| 770-12-7 |
|
2-Furaldehyde, 99%
| 98-01-1 |
|
D-(+)-Galactose, 99+%
| 59-23-4 |
|
1-Tetradecanol, 99+%
| 112-72-1 |
|
Gallic Acid, Monohydrate, C.P.
| 149-91-7 |
|
Metanil yellow, 98% (TLC)
| 587-98-4 |
|
Crystal Violet, Indicator
| 548-62-9 |
|
Sodium triethylborohydride, 1M solution in tetrahydrofuran
| 109-99-9 |
|
Crystal Violet (Cert), Reagent ACS
| 548-62-9 |
|
Glycerol, 99+%
| 56-81-5 |
|
Glycerol, 83.5-88.5 Wt % Aqueous Solution
| 56-81-5 |
|
Glycerol, Reagent ACS
| 56-81-5 |
|
Glycerol, 86-88%, P.A.
| 56-81-5 |
|
Glycine, 98%
| 56-40-6 |
|
Phthalic Anhydride, 99%
| 85-44-9 |
|
Phthalic Anhydride, Reagent acs
| 85-44-9 |
|
n-Decylamine 96%
| 2016-57-1 |
|
|