**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 77-86-1 |Tris (hydroxymethyl) aminomethane | 24 | 201-064-4 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Not available.
Potential Health Effects
Eye:
Contact produces irritation, tearing, and burning pain.
Skin:
May cause irritation with burning pain, itching and redness.
Ingestion:
Causes gastrointestinal irritation with nausea, vomiting and
diarrhea.
Inhalation:
May cause respiratory tract irritation.
Chronic:
Prolonged or repeated skin contact may cause defatting and
dermatitis.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid if irritation develops or persists. Flush skin with
plenty of soap and water.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid if cough or other symptoms appear.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use water spray, dry chemical, carbon dioxide, or chemical foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up or absorb material, then place into a
suitable clean, dry, closed container for disposal. Avoid generating
dusty conditions.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Minimize dust
generation and accumulation. Avoid contact with skin and eyes. Keep
container tightly closed. Avoid ingestion and inhalation. Discard
contaminated shoes.
Storage:
Store in a cool, dry place. Store in a cool, dry, well-ventilated
area away from incompatible substances. Keep containers tightly
closed.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use process enclosure, local exhaust ventilation, or other
engineering controls to control airborne levels below recommended
exposure limits.
Exposure Limits
CAS# 77-86-1:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use. Follow the OSHA
respirator regulations found in 29 CFR 1910.134 or
European Standard EN 149. Use a NIOSH/MSHA or
European Standard EN 149 approved respirator if
exposure limits are exceeded or if irritation or
other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: Clear
Odor: none reported
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: Not available.
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: Not available.
Solubility in water: Soluble in water.
Specific Gravity/Density: Not available.
Molecular Formula: Mixture
Molecular Weight: 0
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions. Decarboxylates above 150C.
Conditions to Avoid:
Incompatible materials.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong acids, strong bases.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide, nitrogen oxides (NOx) and ammonia
(NH3).
Hazardous Polymerization: Will not occur.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 77-86-1: TY2900000
LD50/LC50:
CAS# 77-86-1: Oral, rat: LD50 = 5900 mg/kg.
Carcinogenicity:
Tris (hydroxymethyl) aminomethane -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
Other
No information available.
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
No information available.
IMO
No information available.
RID/ADR
No information available.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 77-86-1: 1
Canada
CAS# 77-86-1 is listed on Canada's DSL List.
CAS# 77-86-1 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 77-86-1 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 9/02/1997 Revision #3 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Ligroine (O3386)
| 110-54-3 |
|
Saturated Phenol, pH 6.6/7.9
| 77-86-1 |
|
Saturated Phenol, pH 4.3/4.5
| 108-95-2 |
|
Phenol/Chloroform/Isoamyl Alcohol, pH 4.3
| 67-66-3 |
|
Phenol/Chloroform/Isoamyl Alcohol (pH5.2)
| 67-66-3 |
|
Tris 1 Molar Buffer
| 77-86-1 |
|
Tris 2 Molar Buffer
| 77-86-1 |
|
4-Chloro-alpha-methylstyrene, 96% (GC)
| 1712-70-5 |
|
1,9-Diphenyl-1,3,6,8-nonatetraen-5-one, 98% (uv-vis)
| 622-21-9 |
|
4-Methoxystilbene, 98+%
| 1142-15-0 |
|
Phenoxy resin, average m.w. 85000
| 26402-79-9 |
|
2,3,5-Trimethylanisole, 99%
| 20469-61-8 |
|
4-Methoxybenzylamine, 98%
| 2393-23-9 |
|
4-Nitrophenyl phosphate tris buffer salt, 98% (titr.)
| 52435-04-8 |
|
Picrotoxin, 99%
| 124-87-8 |
|
4-Nitrocatechol, 97%
| 3316-09-4 |
|
Dipentylphthalate, 99%
| 131-18-0 |
|
Ammonium hexachlororuthenate(iv), 99%
| 18746-63-9 |
|
2-Hydroxy-5-Methoxybenzaldehyde, 98%
| 672-13-9 |
|
N-(2-acetamidophenethyl)-1-hydroxy-2-naphthamide
| 5254-41-1 |
|
Anthrone, reagent acs
| 90-44-8 |
|
(-)-cis-Myrtanylamine, 98%
| 38235-68-6 |
|
Tetrakis-(Triphenylphosphine)-Palladium(0), 99%
| 14221-01-3 |
|
N-Phenyl-p-phenylenediamine, 98%
| 101-54-2 |
|
2-Chlorophenothiazine, 97% Contains 3% Mineral Oil
| 92-39-7 |
|
n-Glycyl-l-tyrosine, hydrate, 97%
| 658-79-7 |
|
3,5-Dimethoxybenzoic Acid, 99%
| 1132-21-4 |
|
3-Chlorobenzotrifluoride, 98%
| 98-15-7 |
|
2-Bromo-4'-Phenylacetophenone, Tech.
| 135-73-9 |
|
4-tert-Butyltoluene
| 98-51-1 |
|
2,6-Diformyl-4-Methylphenol, 99%
| 7310-95-4 |
|
3-Acetoxy-2(1h)-pyridone
| 61296-14-8 |
|
N-Formylpiperidine, 99%
| 2591-86-8 |
|
1-Phenyl-1-cyclohexene, 97%
| 771-98-2 |
|
Glycine anhydride, 98%
| 106-57-0 |
|
4-Piperazinoacetophenone, 94%
| 51639-48-6 |
|
Purine, 99%
| 120-73-0 |
|
2,3-Naphthalenedicarboxylic Acid, 95%
| 2169-87-1 |
|
2-Butyl-2-Ethyl-1,3-Propanediol, 97%
| 115-84-4 |
|
4-(2-Iodoacetamido)-TEMPO, free radical
| 25713-24-0 |
|
4-Heptylbenzoyl Chloride, 99+% (Titr.)
| 50606-96-7 |
|
D-Glucosamine Hydrochloride, 98%
| 66-84-2 |
|
2-Amino-5-chlorobenzoic acid, 98%
| 634-95-7 |
|
Cyclopropyl-4-Methoxydiphenylcarbinol, 95%
| 0-00-1 |
|
6,9-Diamino-2-Ethoxyacridine Lactate, 95% (Titr.)
| 1837-57-6 |
|
2,3,5,6-Tetrabromo-4-Methylphenol, 98%
| 37721-75-8 |
|
3-Methylbenzothiazolium Iodide
| 2786-31-4 |
|
P-Tolunitrile, 98%
| 104-85-8 |
|
Trifluoromethanesulfonic Anhydride, 98%
| 358-23-6 |
|
1-Methyl-2-piperidinemethanol, 97+%
| 20845-34-5 |
|
|