Search   
MSDS 
:
 Quinaldine, 95% (GC)
CAS 
:
 91-63-4
SYNONYMS 
:
 2-Methylquinoline 020
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 91-63-4 |Quinaldine | 95 | 202-085-1 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XN
Risk Phrases: 21/22 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Harmful in contact with skin and if swallowed. Irritating to eyes,
respiratory system and skin.

Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation. May be harmful if absorbed through the skin.
Ingestion:
Causes gastrointestinal tract irritation. May be harmful if
swallowed.
Inhalation:
Causes respiratory tract irritation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid immediately. Flush skin with plenty of water for at
least 15 minutes while removing contaminated clothing and shoes.
Wash clothing before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid immediately. Do NOT induce vomiting. If conscious and alert,
rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Combustible liquid.
Vapors may be heavier than air. They can spread along the ground and
collect in low or confined areas. Containers may explode when heated.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam. Cool containers with flooding quantities of
water until well after fire is out.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Remove all
sources of ignition. Use a spark-proof tool. Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use only in a well-ventilated area. Avoid contact
with eyes, skin, and clothing. Empty containers retain product
residue, (liquid and/or vapor), and can be dangerous. Keep container
tightly closed. Keep away from heat, sparks and flame. Avoid
ingestion and inhalation. Do not pressurize, cut, weld, braze,
solder, drill, grind, or expose empty containers to heat, sparks or
open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Use adequate ventilation to keep airborne concentrations low. Use
process enclosure, local exhaust ventilation, or other engineering
controls to control airborne levels.
Exposure Limits
CAS# 91-63-4:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Wear a NIOSH/MSHA or European Standard EN 149
approved full-facepiece airline respirator in the
positive pressure mode with emergency escape
provisions. Follow the OSHA respirator regulations
found in 29 CFR 1910.134 or European Standard EN 149.
Use a NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: colorless, oily
Odor: none reported
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 248 deg C @ 760.00mm Hg
Freezing/Melting Point: 0 deg C
Autoignition Temperature: Not available.
Flash Point: 79 deg C ( 174.20 deg F)
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water: practically insoluble
Specific Gravity/Density: 1.0580g/cm3
Molecular Formula: C10H9N
Molecular Weight: 143.19

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Oxidizing agents
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, irritating and toxic fumes and
gases, carbon dioxide, nitrogen.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 91-63-4: UZ9625000
LD50/LC50:
CAS# 91-63-4: Draize test, rabbit, skin: 500 mg/24H Mild; Oral, rat:
LD50 = 1230 mg/kg; Skin, rabbit: LD50 = 1870 uL/kg.
Carcinogenicity:
Quinaldine -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XN
Risk Phrases:
R 21/22 Harmful in contact with skin and if
swallowed.
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 23 Do not inhale gas/fumes/vapour/spray.
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 91-63-4: No information available.
Canada
CAS# 91-63-4 is listed on Canada's DSL List.
CAS# 91-63-4 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 91-63-4 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 4/13/1998 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
(Methyl Sulfoxide)-D6, 99.9 Dtom % Deuterized 2206-27-1
Mucobromic acid, 99+% 488-11-9
Fast blue rr salt - tetrafluoroborate 27766-45-6
Thymol 89-83-8
5-Methyl-3-phenylisoxazole-4-carboxylic acid, 99% 1136-45-4
Tin Metal 7440-31-5
1-Dimethylamino-but-1-en-3-one, 99% (gc) 2802-08-6
Titanium (IV) Oxide Anhydrous 13463-67-7
1,5-Diphenyl-3-pentadienone 538-58-9
Gitoxigenin 545-26-6
Quinaldine, 95% (GC) 91-63-4
Bromelain 9001-00-7
Titanium(IV) chloride 7550-45-0
D,L-selenomethionine, 99+%(tlc) 2578-28-1
4-Phenylpyrimidine, 96% 3438-48-0
6-Methoxy-8-Nitroquinoline, 99% 85-81-4
1-(4'-Bromophenoxy)-1-Ethoxyethane 39255-20-4
4-Fluorophenylhydrazine Hydrochloride, 97% 823-85-8
2,4,6-Trihydroxybenzoic Acid Monohydrate, 95% 83-30-7
4-Amino-2-Butanol, 99+% 39884-48-5
Cobalt(II) Carbonate Hydrate, 47-50% Co (Dry Substance) 513-79-1
N-Fluoro-3,5-Dichloropyridinium Triflate, 90-95% 107264-06-2
1,11-Dibromoundecane, 98+% 16696-65-4
Toluene 108-88-3
Isobutyl nitrite, 94%, stabilized with 0.2% anhydrous potassium 542-56-3
3,4,5-Trimethoxytoluene, 97% 6443-69-2
Benzyltrimethylammonium dichloroiodate, 99% 114971-52-7
Dodecylamine hydrochloride, 99% 929-73-7
5-Chloromethyl-2-Oxazolidinone, 98% 22625-57-6
Malonaldehyde bis(diethyl acetal), 97% 122-31-6
Lithium tri-tert-butoxyaluminohydride, 93- 98% 17476-04-9
5-Norbornene-2,3-dicarboxylic anhydride, 99% (titr.) 826-62-0
3-Carboxy-proxyl, free radical 2154-68-9
4,4-Dimethyl-2-pentanone, 99% 590-50-1
2-(2-Aminothiazole-4-yl)-2-Methoxyiminoacetic Acid, 97% 65872-41-5
3-Fluorobenzaldehyde, 98+% 456-48-4
Nitrobenzene-d5, 99 atom % d 4165-60-0
3-Methoxy-2-nitrobenzoic acid, 99% 4920-80-3
3-Ethyl-2-Methylbenzoxazolium Iodide, 97% (titr.) 5260-37-7
Bicine, 99+% 150-25-4
Dimethylaminoacetonitrile, 98% 926-64-7
Aq 29d
S-Propionylthiocholine Iodide, 98% 1866-73-5
Iodomethane-d3, 99+ atom % D 74-88-4
Tricresyl Phosphate 78-30-8
Tetrahydropyran, 99+% 142-68-7
Methylenediphosphonic acid, 98 % 1984-15-2
Flavine-adenine dinucleotide, 96% (uv-vis) 146-14-5
Biphenyldiisopropylsilyl chloride
Benzyltributylammonium Bromide, 99% 25316-59-0

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net