Search   
MSDS 
:
 Bis(N,N-diisopropylamino)methoxyphosphine
CAS 
:
 92611-10-4
SYNONYMS 
:
 None Known
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 92611-10-4 |Bis(N,N-diisopropylamino)methoxyphosph| 100 | unlisted |
| |ine | | |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 14 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Reacts violently with water. Irritating to eyes, respiratory system
and skin.Water-reactive.The toxicological properties of this
material have not been fully investigated.

Potential Health Effects
Eye:
Causes eye irritation. May cause chemical conjunctivitis.
Skin:
Causes skin irritation. Contact with skin causes irritation and
possible burns, especially if the skin is wet or moist. May be
harmful if absorbed through the skin.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. May be harmful if swallowed.
Inhalation:
Causes respiratory tract irritation. May be harmful if inhaled.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse. If water-reactive products are embedded in the skin, no
water should be applied. The embedded products should be covered
with a light oil.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Water
Reactive. Material will react with water and may release a flammable
and/or toxic gas. Combustible liquid and vapor.
Extinguishing Media:
DO NOT USE WATER! Do NOT get water inside containers. Contact
professional fire-fighters immediately. Use dry chemical, carbon
dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Clean up spills immediately,
observing precautions in the Protective Equipment section. Remove all
sources of ignition. Use a spark-proof tool. Provide ventilation. Do
not expose spill to water.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Avoid contact with eyes, skin, and
clothing. Empty containers retain product residue, (liquid and/or
vapor), and can be dangerous. Keep container tightly closed. Avoid
ingestion and inhalation. Use with adequate ventilation. Do not
allow contact with water. Wash clothing before reuse. Do not
pressurize, cut, weld, braze, solder, drill, grind, or expose empty
containers to heat, sparks or open flames. Keep away from heat and
flame.
Storage:
Keep away from sources of ignition. Store in a tightly closed
container. Store in a cool, dry, well-ventilated area away from
incompatible substances. Keep away from water.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Use explosion-proof ventilation equipment. Facilities storing or
utilizing this material should be equipped with an eyewash facility
and a safety shower. Use adequate ventilation to keep airborne
concentrations low.
Exposure Limits
CAS# 92611-10-4:


Personal Protective Equipment

Eyes:
Wear chemical splash goggles.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: Not available.
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 74-75 deg C at 0.45mmHg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 87 deg C ( 188.60 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: 0.91 g/cm3
Molecular Formula: C13H31N2OP
Molecular Weight: 262.37

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Combines vigorously or explosively with water.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, exposure to
moist air or water.
Incompatibilities with Other Materials:
Strong oxidizing agents, water.
Hazardous Decomposition Products:
Phosphine, carbon monoxide, oxides of nitrogen, oxides of phosphorus,
carbon dioxide.
Hazardous Polymerization: Has not been reported

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 92611-10-4 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Bis(N,N-diisopropylamino)methoxyphosphine -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Shipping Name: WATER REACTIVE LIQUID, N.O.S.
Hazard Class: 4.3
UN Number: 3148
Packing Group: III
IMO
Shipping Name: WATER REACTIVE LIQUID, N.O.S.
Hazard Class: 4.3
UN Number: 3148
Packing Group: III
RID/ADR
Shipping Name: WATER REACTIVE LIQUID, N.O.S.
Hazard Class: 4.3
UN Number: 3148
Packing group: III

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 14 Reacts violently with water.
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 7 Keep container tightly closed.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 36/37/39 Wear suitable protective clothing, gloves
and eye/face protection.
WGK (Water Danger/Protection)
CAS# 92611-10-4: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 92611-10-4 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 92611-10-4 is not listed on the TSCA inventory.
It is for research and development use only.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 4/12/2005 Revision #3 Date: 4/12/2005

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
1-Decanethiol, 98% (titr.) 143-10-2
2-Chloroaniline, 98+%
3-Fluoro-4-methylbenzonitrile 170572-49-3
p-Anisic acid, 98%
BS Buffer Solution pH 9.225 1303-96-4
2,4-Difluorobenzaldehyde 1550-35-2
9-Anthracenemethanol, 98% 1468-95-7
2,3,6-Trichlorophenylacetic acid 85-34-7
Phenylhydroquinone Diacetate 58244-28-3
Tris(acetoxyethyl)orthoformate 0-01-1
Diaminoethane tetra-acetic acid trisodium salt solutions (0.01M / 139-33-3
2-Chloro-P-Phenylenediamine Sulfate, 95% 61702-44-1
S-Triazolo(4,3-a)Quinoline 235-06-3
(3,4-Dichlorophenyl)-[(tetrahydro-pyran-2-yloxy)]-acetonitrile 0-01-1
1-Pentanesulfonic acid sodium salt premixed concentrate 67-56-1
1-(Benzofuran-2-yl)-4,4-5,5,5-pentafluoro-1,3-pentanedione 0-01-1
AZ12311148 0-01-1
Bis(N,N-diisopropylamino)methoxyphosphine 92611-10-4
(3,4-Dichloro-phenyl)-trimethylsilanyloxy-acetonitrile 95392-03-3
Ammonium-4-Chloro-7-Sulfobenzofurazan 81377-14-2
2-Bromoethyl-4-bromophenyl ether, 98% 18800-30-1
2-Bromovaleryl chloride 42768-45-6
2-Pyrid-3-yl-4,5-dihydro-1,3-thiazole-4-carboxylic acid 116247-03-1
2,3-Pyridinedicarboxylic acid, 99% 89-00-9
2'-Fluoroacetophenone, 97%
Substituted Alkoxyaminophenylpiperizinylbenzoic acid 0-01-1
Chromic acid mix detergent 7664-93-9
Potassium chromate solution, 5% w/v 7732-18-5
Acetic acid based buffer 64-19-7
N,N'-Dioctadecyloxacarbocyanine p-toluenesulfonate, 99% (uv-vis) 60711-74-2
4-Methoxyindole 4837-90-5
4-Chlorophthalic acid, monosodium salt, tech. 56047-23-5
alpha-D-Glucose pentaacetate, 98% 604-68-2
1-Bromo-2-(2-methoxyethoxy)ethane, 98% 54149-17-6
3,5-Dinitrobenzoic acid, 99% 99-34-3
trans-2,trans-4-Hexadienal, 95% 142-83-6
N-(2-Hydroxyethyl)iminodiacetic acid, 98% 93-62-9
4-Bromobenzo-15-Crown-5, 96% 0-00-1
1-Nitronaphthalene, 99% 86-57-7
Boron Atomic Absorption Standard Solution 1 mg/ml B in Water 7440-42-8
4-Epitetracycline Hydrochloride,"Can be used as Secondary Standard." 23313-80-6
Dowex 50x8-200 Ion-Exchange Resin 11119-67-8
2,3-Dimethylmaleic Anhydride, 97% 766-39-2
D-Raffinose Pentahydrate 512-69-6
Pentaerythritol, 98% 115-77-5
Perfluorooctyl bromide, 99.5+% 423-55-2
Diethyl Iminodiacetate, 99% (GC) 6290-05-7
3-Methylene-2-Norbornanone, 97% 5597-27-3
2-(2-Thienyl)ethanol , 99% 5402-55-1
1,4-Dimethoxyantracene, 98% (uv-vis) 13076-29-4

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net