3M GENERAL OFFICES -- PF-5060 3M BRAND PERFORMANCE FLUID
=======================================================
Material Safety Data Sheet
=======================================================
MSDS Num: BSXKD
MSDS NAME: PF-5060 3M BRAND PERFORMANCE FLUID
Responsible Party
Name: 3M GENERAL OFFICES
Address: 3M CENTER
City: ST PAUL MN 55144-1000
Info Phone: 612-733-1110
Emergency Phone Number: 612-733-1110
Published: Y
=======================================================
Contractor Summary
=======================================================
Name: MINNESOTA MINING AND MFG CO, DBA 3M
Address: 3M CENTER BLDG 224-5S-04
City: SAINT PAUL MN 55144-1000
Phone: 866-556 5712 / 612-733-1110
Name: MINNESOTA MINING AND MFG CO ENGINEERING DOCUMENT SYSTEMS DIV
Address: 3M CTR
City: SAINT PAUL MN 55144-1000
Phone: 612-737-4114
=======================================================
Ingredients
=======================================================
Cas: 86508-42-1
Name: PERFLUORO COMPOUNDS C5-18 (PRIMARILY COMPOUNDS W/6 CARBONS)
% Wt: 100
OSHA PEL: N/K (FP N)
ACGIH TLV: N/K (FP N)
------------------------------
RTECS #: 9999999VO
Name: VOLATILE ORGANIC COMPOUNDS
% Wt: 0 G/L
OSHA PEL: N/K (FP N)
ACGIH TLV: N/K (FP N)
-----------------------------
Name: SUPDAT:OF FLUORIDE AS SHORT TERM EXPOS LIM. PERFLUORISOBUTYLENE HAS ACGIH
TLV VALUE OF 0.01 PPM, C OR 0.082 MG/M3, C.
-----------------------------
Name: VENT:APPLICATIONS AT/ABOVE BOILING TEMP. IF INTERFERING AIR CURRENTS ARE
PRESENT, MIN CAPTURE VELOCITY SHOULD BE
-----------------------------
Name: ING 4:AT LEAST 100 LINEAR FEET PER MINUTE.
=======================================================
Health Hazards Data
=======================================================
LD50 LC50 Mixture: NONE SPECIFIED BY MANUFACTURER.
Route Of Entry Inds - Inhalation: YES
Skin: YES
Ingestion: NO
Carcinogenicity Inds - NTP: NO
IARC: NO
OSHA: NO
Effects of Exposure: EYE:NO ADVERSE HLTH EFTS ARE EXPECTED FROM CONT. PROD IS
NOT EXPECTED TO PRDCE SIGNIFICANT IRRIT. AFTER PROD HAS BEEN IN USE, CONTAMS
MAY BE INTRODUCED THAT MAY CAUSE IRRIT:SIGNS/SYMPS INCL REDNESS, S WELL, PAIN
& TEARING. SKIN:NO ADVERSE HLTH EFTS ARE EXPECTED FROM CONT. AFTER PROD
HAS BEEN IN USE, (EFTS OF OVEREXP)
Explanation Of Carcinogenicity: NOT RELEVANT
Signs And Symptions Of Overexposure: HLTH HAZ:CONTAMS MAY BE INTRODUCED THAT
MAY CAUSE IRRIT:SIGNS/SYMPS INCL REDNESS, SWELL & ITCH. INHAL:NO ADVERSE
HLTH EFTS ARE EXPECTED FROM EXPOS. HLTH EFTS ARE NOT EXPECTED UNLESS PROD IS
OVERHEATED & DECOMP OCCURS. INGEST:NO ADVERSE HLTH EFTS ARE EXPECTED
FROM SWALLOWING. CONTAM PROD CAN BE TOX IF INGESTED. (SUPDAT)
Medical Cond Aggravated By Exposure: NONE SPECIFIED BY MANUFACTURER.
First Aid: EYE:IMMEDIATELY FLUSH W/LARGE AMOUNTS OF WATER FOR AT LEAST 15
MINUTES. GET IMMEDIATE MEDICAL ATTENTION. SKIN:WASH AFFECTED AREA W/SOAP
& WATER. INHAL:REMOVE PERSON TO FRESH AIR. IF SIGNS/SYMPTOMS CON TINUE,
CALL MD. INGEST:DRINK TWO GLASSES OF WATER. CALL MD.
=======================================================
Handling and Disposal
=======================================================
Spill Release Procedures: OBSERVE PRECAUTIONS FROM OTHER SECTIONS OF MSDS.
COVER W/INORGANIC ABSORBENT MATERIAL. COLLECT SPILLED MATERIAL. PLACE IN A
CLOSED CONTAINER. 96-HR, LC50, FATHEAD MINNOW (PIMEPHALES PROMELAS) =
>1000 MG/L (OF IMMISCIBLE MIXTURE).
Neutralizing Agent: NONE SPECIFIED BY MANUFACTURER.
Waste Disposal Methods: DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL
REGULATIONS (FP N). TO RECLAIM OR RETURN, CONTACT MFR'S SALES REPRESENTATIVE.
Handling And Storage Precautions: AVOID EYE CONTACT. AVOID PROLONGED BREATHING
OF VAPORS. STORE AT ROOM TEMPERATURE. NO SMOKING WHILE HANDLING THIS
MATERIAL.
Other Precautions: FOR INDUSTRIAL USE ONLY. NOT INTENDED FOR USE AS A MEDICAL
DEVICE OR DRUG.
=======================================================
Fire and Explosion Hazard Information
=======================================================
Flash Point Method: SCC
Flash Point Text: NONE
Fire Fighting Procedures: USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT (FP N).
Unusual Fire/Explosion Hazard: TOXIC VAPORS OR GASES ARE POSSIBLE PRODUCTS OF
THERMAL DECOMPOSITION.
=======================================================
Control Measures
=======================================================
Respiratory Protection: AVOID INHAL OF THERMAL DECOMP PRODS. IF THERMAL DECOMP
OCCURS, SELECT ONE OF THE FOLLOWING NIOSH/MSHA APPRVD RESPS BASED ON AIRBORNE
CONC OF CONTAMS & I/A/W OSHA REGS:HALF-MASK SUPPLIED AIR RESP, FULL -FACE
SUPPLIED AIR RESP.
Ventilation: USE W/APPROP LOC EXHST VENT. LOC EXHST VENT W/MIN CAPTURE VELOCITY
OF 50 LINEAR FT/MIN SHOULD BE PROVIDED FOR
Protective Gloves: IMPERVIOUS GLOVES (FP N).
Eye Protection: CHEMICAL SAFETY GOGGLES (FP N).
Other Protective Equipment: NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices: NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health: HAZ DECOMP PROD:OF THERMAL DECOMP. EFTS OF
OVEREXP:IF PROD IS EXPOSED TO EXTREME CNDTN OF HEAT FROM MISUSE/EQUIP
FAILURE, TOX DECOMP PRODS THAT INCL HYDROGEN FLUORIDE &
PERFLUOROISOBUTYLENE CAN OCCUR. HYDROGEN FLUORIDE HAS ACGIH TLV OF 3 PPM, C,
OF FLUORIDE & AN OSHA PEL OF 3 PPM OF FLUORIDE AS 8 HR TWA & 6 PPM
=======================================================
Physical/Chemical Properties
=======================================================
B.P. Text: 133F,56C
Vapor Pres: 232
Vapor Density: 11.7
Spec Gravity: 1.7 (H*2O=1)
Evaporation Rate & Reference: >1 (BUOAC=1)
Solubility in Water: NIL
Appearance and Odor: COLORLESS, CLEAR, ODORLESS LIQUID.
Percent Volatiles by Volume: 100
=======================================================
Reactivity Data
=======================================================
Stability Indicator: YES
Stability Condition To Avoid: NONE SPECIFIED BY MANUFACTURER.
Materials To Avoid: FINELY DIVIDED ACTIVE METALS, ALKALI & ALKALINE EARTH
METALS.
Hazardous Decomposition Products: CARBON MONOXIDE & CARBON DIOXIDE, HYDROGEN
FLUORIDE, PERFLUOOROISOBUTYLENE (PFIB). TOX VAPS/GASES ARE POSS PRODS(SUPDAT)
Hazardous Polymerization Indicator: NO
Conditions To Avoid Polymerization: NOT RELEVANT
=======================================================
Toxicological Information
=======================================================
=======================================================
Ecological Information
=======================================================
=======================================================
MSDS Transport Information
=======================================================
=======================================================
Regulatory Information
=======================================================
=======================================================
Other Information
=======================================================
=======================================================
HAZCOM Label
=======================================================
MSDS NAME: PF-5060 3M BRAND PERFORMANCE FLUID
Company: MINNESOTA MINING AND MFG CO ENGINEERING DOCUMENT SYSTEMS DIV
Street: 3M CTR
City: SAINT PAUL MN
Zipcode: 55144-1000
Health Emergency Phone: 612-733-1110
Label Required IND: Y
Date Of Label Review: 08/27/1993
Status Code: C
Label Date: 08/27/1993
Origination Code: G
Eye Protection IND: YES
Skin Protection IND: YES
Signal Word: WARNING
Respiratory Protection IND: YES
Health Hazard: Moderate
Contact Hazard: Moderate
Fire Hazard: None
Reactivity Hazard: None
Hazard And Precautions: NO SMOKING. FOR INDUSTRIAL USE ONLY. AVOID CONTACT
& BREATHING OF VAPORS. STORE AT ROOM TEMPERATURE. ACUTE:MAY CAUSE EYE
IRRITATION - REDNESS, SWELLING, PAIN & TEARING. MAY CAUSE SKIN IRRITATION
- RED NESS, SWELLING & ITCHING. CAN BE TOXIC IF INGESTED. CHRONIC:NONE
LISTED BY MANUFACTURER.
=======================================================
Disclaimer (provided with this information by the compiling agencies): This
information is formulated for use by elements of the Department of Defense.
The United States of America in no manner whatsoever expressly or implied
warrants, states, or intends said information to have any application, use or
viability by or to any person or persons outside the Department of Defense
nor any person or persons contracting with any instrumentality of the United
States of America and disclaims all liability for such use. Any person
utilizing this instruction who is not a military or civilian employee of the
United States of America should seek competent professional advice to verify
and assume responsibility for the suitability of this information to their
particular situation regardless of similarity to a corresponding Department
of Defense or other government situation.
*** END OF RECORD *** |
|
|