=====================  Product Identification  =====================

MSDS NAME:ELASTIC CEMENT COMPONENT B
NIIN:00N066957
Kit Part:Y
MSDS Number: CBFCV
=== Responsible Party ===
Company:PERCOL POLYMERICS INC
Address:17435 NEWHOPE ST
City:FOUNTAIN VALLEY
State:CA
ZIP:92708-4220
Country:US
Info Phone Num:714-979-5555
Emergency Phone Num:800-535-5053
CAGE:0PCX4
=== Contractor Identification ===
Company:PERCOL POLYMERICS INC
Address:17435 NEWHOPE ST
Box:City:FOUNTAIN VALLEY
State:CA
ZIP:92708-4220
Country:US
Phone:714-979-5555
CAGE:0PCX4

=============  Composition/Information on Ingredients  =============

Name:GLYCOLS, POLYETHYLENE- POLYPROPYLENE; (POLYETHER POLYOL)
CAS:9003-11-6
RTECS #:MD0911050
OSHA PEL:N/K 
ACGIH TLV:N/K 

Name:DI ISONONYL PHTHALATE; (PHTHALATE ESTER)
CAS:68515-48-0
OSHA PEL:N/K 
ACGIH TLV:N/K 

Name:ORGANO AND ORGANO METALIC CATALYSTS
OSHA PEL:N/K 
ACGIH TLV:N/K 

Name:1,4-BUTANEDIOL; (GLYCOL)
CAS:110-63-4
RTECS #:EK0525000
OSHA PEL:N/K 
ACGIH TLV:N/K 

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:NO
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:EXCESSIVE INHALATION OF VAPORS OR
    MISTS CAN CAUSE IRRITATION OF THE RESPIRATORY TRACT, LOSS OF
    COORDINATION AND EQUILIBRIUM AND REPEATED OR PROLONGED CONTACT CAN
    CAUSE EYE AND SKIN IRRITATION.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:NAUSEA, HEADACHE, DIZZINESS, REDNESS AND
    TEARING OF EYES AND MODERATE IRRITATION OF SKIN.
Medical Cond Aggravated by Exposure:NONE KNOWN.

=======================  First Aid Measures  =======================

First Aid:INGEST: CALL MD IMMEDIATELY . INHAL: REMOVE PERSON TO FRESH
    AIR. IF BREATHING IS DIFFICULT, ADMINISTER OXYGEN. EYES: FLUSH
    IMMEDIATELY WITH WATER FOR AT LEAST 15 MINUTES. SKIN: WASH AFFECTED
    ARE A THOROUGHLY WITH SOAP AND WATER. IF IRRITATION PERSISTS,
    CONSULT MD.

=====================  Fire Fighting Measures  =====================

Flash Point Method:COC
Flash Point:338F,170C
Extinguishing Media:DRY CHEMICAL, CHEMICAL FOAM, CARBON DIOXIDE AND
    WATER SPRAY.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
    PROTECTIVE EQUIPMENT . USE WATER TO COOL FIRE EXPOSED CONTAINERS.
    ELIMINATE ALL SOURCES OF IGNITION.
Unusual Fire/Explosion Hazard:VAPORS ARE HEAVIER THAN AIR & MAY TRAVEL
    ALONG THE GROUND & BE IGNITED BY HEAT, PILOT LIGHTS, SPARKS, ETC,
    AT LOCATIONS DISTANT FROM MATERIAL HANDLING POINTS.

==================  Accidental Release Measures  ==================

Spill Release Procedures:NIOSH/MSHA APPROVED RESPIRATORY PROTECTION
    MUST BE WORN DURING CLEANUP. ABSORB SPILLED MATERIAL W/SAWDUST OR
    VERMICULITE & SWEEP INTO CLOSED CONTAINERS FOR DISPOSAL. AFTER ALL
    VISIBLE TRACES HAVE BEEN  REMOVED THOROUGHLY, WET-VACUUM THE AREA.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE BELOW 120F IN TIGHTLY CLOSED
    CNTNRS. DO NOT USE IN POORLY VENTILATED OR CONFINED SPACES. DO NOT
    STORE IN OPEN, UNLABELED OR MISLABELED CNTNRS.
Other Precautions:WEAR PROTECTIVE EQUIPMENT TO PREVENT EYE AND SKIN
    CONTACT. AVOID UNNECESSARY EXPOSURE TO VAPORS. WASH HANDS BEFORE
    EATING OR SMOKING.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NONE AT NORMAL/AMBIENT CONDITIONS. USE
    NIOSH/MSHA APPROVED RESPIRATOR AT ELEVATED TEMPERATURES.
Ventilation:LOCAL EXHAUST: RECOMMENDED TO MAINTAIN VAPOR CONCENTRATE
    BELOW TLV LIMITS. MECHANICAL (GENERAL): RECOMMENDED.
Protective Gloves:NATURAL RUBBER OR NEOPRENE.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
    LABORATORY COATS OR SUITABLE CLOTHING TO PREVENT SKIN CONTACT.
Work Hygienic Practices:IN ACCORDANCE WITH GOOD HYGIENE AND SAFETY
    PRACTICES. AVOID UNNECESSARY EXPOSURE. USE IN ADEQUATELY VENTILATED
    AREAS.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:464F,240C
Spec Gravity:1.017 (H*2O=1)
Appearance and Odor:CLEAR, ODORLESS LIQUID.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:OPEN FLAME, HOT GLOWING SURFACES AND
    ELECTRIC ARCS.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE AND
    OXIDES OF SULFUR.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH FEDERAL,
    STATE AND LOCAL REGULATIONS . CONTAMINATED SAWDUST OR VERMICULITE
    MUST BE DISPOSED OF IN A PERMITTED, NON-HAZARDOUS WASTE MANAGEMENT
    FACILITY.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***