=====================  Product Identification  =====================

MSDS NAME:REPRO 10 B SIDE
NIIN:00N091600
Status Code:A
MSDS Number: CJMYH
=== Responsible Party ===
Company:FREEMAN MFG AND SUPPLY CO
Address:1101 MOORE RD
City:AVON
State:OH
ZIP:44011
Country:US
Info Phone Num:440-934-1902
Emergency Phone Num:800-424-9300
CAGE:1F275
=== Contractor Identification ===
Company:FREEMAN MFG AND SUPPLY CO
Address:1101 MOORE RD
Box:City:AVON
State:OH
ZIP:44011
Country:US
Phone:440-934-1902
CAGE:1F275

=============  Composition/Information on Ingredients  =============

Name:DIPHENYLMETHANE DIISOCYANATE (MDI)
CAS:101-68-8
RTECS #:NQ9350000
Minumum % Wt:20.
Maxumum % Wt:25.
OSHA PEL:C0.2 MG/M3;C0.02 PPM
ACGIH TLV:0.051 MG/M3;.005 PPM
EPA Rpt Qty:1 LB
DOT Rpt Qty:1 LB

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:NO
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:EYE & SKIN CONTACT: CAUSE IRRITATION.
    INHALATION: IRRITATE RESPIRATORY TRACT.  VAPOR HARMFUL. INGESTION:
    SWALLOWING CAN CAUSE ABDOMINAL IRRITATION, NAUSEA, VOMITING AND
    DIARRHEA.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:PERSONS WITH SEVERE SKIN PROBLEMS
    SHOULD AVOID USE.

=======================  First Aid Measures  =======================

First Aid:EYE CONTACT: FLUSH WITH PLENTY OF WATER FOR AT LEAST 15
    MINUTES AND GET MEDICAL ATTENTION. SKIN CONTACT: WASH THOROUGHLY
    WITH SOAP AND WATER. REMOVE AND WASH CONTAMINATED CLOTHING BEFORE
    REUSE. INHALA TION: REMOVE TO FRESH AIR. IF BREATHING IS DIFFICULT,
    GIVE OXYGEN AND/OR ARTIFICIAL RESPIRATION. INGESTION: CALL A
    PHYSICIAN IMMEDIATELY. NEVER GIVE ANYTHING BY MOUTH TO AN
    UNCONSCIOUS PERSON.

=====================  Fire Fighting Measures  =====================

Flash Point Method:SCC
Flash Point:=65.6C, 150.F
Lower Limits:NOT EST.
Upper Limits:NOT EST.
Extinguishing Media:FOAM, CO*2, OR DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH APPROVED SCBA & FULL PROTECTIVE
    EQUIPMENT . WATER SPRAY MAY BE INEFFECTIVE ON FIRE BUT CAN PROTECT
    FIRE FIGHTERS AND COOL CLOSED CONTAINERS. USE FOG NOZZLES IF WATER
    IS USED.
Unusual Fire/Explosion Hazard:COMBUSTIBLE! KEEP CONTAINERS TIGHTLY
    CLOSED. ISOLATE FROM OXIDIZERS, HEAT AND OPEN FLAME. AT
    TEMPERATURES GREATER THAN 400F MATERIAL CAN POLYMERIZE AND
    DECOMPOSE WHICH CAN CAUSE PRESSURE BUILD-UP IN C LOSED CONTAINERS.
    CONTAINER RUPTURE IS POSSIBLE. USE COLD WATER TO COOL FIRE EXPOSED
    CONTAINER.

==================  Accidental Release Measures  ==================

Spill Release Procedures:STOP SPILL AT SOURCE. DIKE AREA AND CONTAIN.
    CLEAN UP REMAINDER WITH ABSORBENT MATERIALS SUCH AS SAND OR
    VERMICULITE. MOP UP AND DISPOSE OF.

======================	Handling and Storage  ======================

Handling and Storage Precautions:USE WITH ADEQUATE VENTILATION. AVOID
    PROLONGED BREATHING OF VAPOR. AVOID PROLONGED OR REPEATED CONTACT
    WITH SKIN. WEAR SAFETY GOGGLES OR FACE SHIELD. WEAR GLOVES, APRON &
    FOOTWEAR IMPERVIOUS TO THIS M ATERIAL.
Other Precautions:STORE AT AMBIENT TEMPERATURES OR BELOW 90F. WHEN
    RESEALING CANS, USE A NITROGEN PURGE (MAGIC BLANKET). KEEP
    CONTAINER TIGHTLY CLOSED AND UPRIGHT WHEN NOT IN USE TO PREVENT
    LEAKAGE.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE A NIOSH APPROVED RESPIRATOR OR GAS MASK
    WHERE THE VAPOR CONCENTRATIONS IS ABOVE THE TLV LEVEL.
Ventilation:LOCAL EXHAUST: RECOMMENDED. MECHANICAL (GENERAL):
    ACCEPTABLE. SPECIAL: NONE. OTHER: NONE.
Protective Gloves:PERMEATION RESISTANT GLOVES (BUTYL RUBBER, NITRILE,
    POLYVINYL ALCOHOL).
Eye Protection:ANSI APPROVED CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EMERGENCY EYEWASH AND DELUGE
    SHOWER .  WORK CLOTHES.
Work Hygienic Practices:AVOID SKIN AND EYE CONTACT. WASH THOROUGHLY
    AFTER HANDLING. MAINTAIN A CLEAN WORK ENVIRONMENT, AND CLOTHING.
Supplemental Safety and Health
VAPOR DENSITY: > 1.0 (AIR =1). REACTIVITY IN WATER: SLIGHT REACTION.

==================  Physical/Chemical Properties  ==================

Boiling Pt:=176.7C, 350.F
Vapor Pres:NOT EST.
Vapor Density:SUPDAT
Spec Gravity:1.908 (H*2O = 1)
VOC Grams/Liter:.89
Solubility in Water:REACTS WITH WATER
Appearance and Odor:LIQUID, THAN FOR 10 TAN, DARK TAN FOR 10 BACK: MILD
    ODOR.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
CONTAMINATION BY MOISTURE, ALCOHOL, AMMONIA, AMINES, AND ALKALIES.
Stability Condition to Avoid:CONTAMINATION WITH MATERIALS CONTAINING
    ACTIVE NCO COMPOUNDS.
Hazardous Decomposition Products:CO, CO*2.
Conditions to Avoid Polymerization:WILL NOT OCCUR. CONDITIONS TO AVOID:
     INADVERTENT MIXTURE OF A & B PARTS.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF IN SAFETY CONTAINERS AS A SOLID WASTE
    MATERIAL ACCORDING TO LOCAL, STATE, AND FEDERAL REGULATIONS.

=====================  Regulatory Information  =====================

SARA Title III Information:THIS PRODUCT CONTAINS A TOXIC CHEMICAL
    SUBJECT TO THE REPORTING REQUIREMENTS OF SECTION 313 OF SARA TITLE
    III  OF 1986: 4 4' DIPHENYLMETHANE DIISOCYANATE  7.0-9.0 % CAS #
    101-68-8.
Federal Regulatory Information:TSCA INVENTORY STATUS: CHEMICAL
    COMPONENTS LISTED ON TSCA INVENTORY.

=======================  Other Information  =======================

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***