=====================  Product Identification  =====================

MSDS NAME:MS-260 SAFEZONE CLEANER FOR PLASTIC, GLASS &METAL
NIIN:01-089-0815
Status Code:A
MSDS Number: CLQQN
=== Responsible Party ===
Company:MILLER-STEPHENSON CHEMICAL CO INC
Address:55 BACKUS AVE/GEORGE WASHINGTON HWY
Box:950
City:DANBURY
State:CT
ZIP:06810
Country:US
Info Phone Num:203-743-4447
Emergency Phone Num:800-424-9300
Preparer's Name:ERNEST CARTER
Chemtrec Ind/Phone:(800)424-9300
CAGE:18598
=== Contractor Identification ===
Company:MILLER-STEPHENSON CHEMICAL CO INC
Address:55 BACKUS AVE/GEORGE WASHINGTON HWY
Box:950
City:DANBURY
State:CT
ZIP:06810
Country:US
Phone:203-743-4447
CAGE:18598

=============  Composition/Information on Ingredients  =============

Name:2-BUTOXYETHANOL
CAS:111-76-2
RTECS #:KJ8575000
= Wt:3.9
OSHA PEL:240 MG/M3;50 PPM
ACGIH TLV:121 MG/M3;25 PPM

Name:ETHYL ALCOHOL
CAS:64-17-5
RTECS #:KQ6300000
Minumum % Wt:10.
Maxumum % Wt:20.
OSHA PEL:1900 MG/M3;1000 PPM
ACGIH TLV:1880 MG/M3;1000 PPM

Name:METHYL ALCOHOL
CAS:67-56-1
RTECS #:PC1400000
= Wt:.8
OSHA PEL:260 MG/M3;200 PPM
ACGIH TLV:262 MG/M3;200 PPM
ACGIH STEL:328 MG/M3;250 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Name:HYDROCARBON PROPELLANT
CAS:68476-85-7
Code:F
RTECS #:SE7545000
Minumum % Wt:1.
Maxumum % Wt:5.
OSHA PEL:1800 MG/M3;1000 PPM
ACGIH TLV:1800 MG/M3;1000 PPM

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Health Hazards Acute and Chronic:THIS PRODUCT CONTAINS 2-BUTOXYETHANOL,
    WHICH HAS CAUSED LIVER AND KIDNEY DAMAGE AND HEMOLYTIC ANEMIA IN
    TEST ANIMALS.
Explanation of Carcinogenicity:NONE OF THE INGREDIENTS ARE LISTED AS A
    CARCINOGEN BY IARC, NTP OR OSHA.
Effects of Overexposure:RESPIRATORY IRRITATION. HIGH CONCENTRATIONS MAY
    PRODUCE HEADACHE, DIZZINESS AND NAUSEA. PROLONGED OR REPEATED SKIN
    CONTACT MAY LEAD TO DRYING, IRRITATION, AND DERMATITIS. POSSIBLE
    SKIN ABSORPTION. EYE  CONTACT MAY CAUSE BURNING AND IRRITATION.

=======================  First Aid Measures  =======================

First Aid:INHALATION: MOVE VICTIM  TO FRESH AIR AND RESTORE BREATHING
    IF NECESSARY.STAY WITH VICTIM UNTIL ARRIVAL OF EMERGENCY MEDICAL
    PERSONNEL.EYE: FLUSH EYES WITH LARGE AMOUNTS  OF WATER FOR AT LEAST
    15 MINU TES, WHILE HOLDING EYELIDS OPEN.GET PROMPT MEDICAL
    ATTENTION.	    SKIN:REMOVE CONTAMINATED CLOTHING AND WASH SKIN
    WITH PLENTY OF WATER.IF IRRITATION PERSISTS, SEEK MEDICAL
    ATTENTION. ORAL: CONTACT LO CAL POISON CONTROL OR PHYSICIAN
    IMMEDIATELY!!!

=====================  Fire Fighting Measures  =====================

Flash Point:=54.4C, 130.F
Lower Limits:1.8%
Upper Limits:9.2%
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL OR FOAM.
Fire Fighting Procedures:CONTAINERS SHOULD BE COOLED WITH WATER TO
    PREVENT VAPOR PRESSURE BUILD UP . USE EQUIPMENT OR SHIELDING, AS
    REQUIRED, TO PROTECT PERSONNEL FROM BURSTING, RUPTURING OR VENTING
    CANS.
Unusual Fire/Explosion Hazard:DO NOT SPRAY NEAR OPEN FLAMES OR WHILE
    SMOKING. AT ELEVATED TEMPERATURES OVER 54 C/130 F CONTAINERS MAY
    VENT, RUPTURE OR BURST.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALLSOURCES OF IGNITION AND VENTILATE
    AREA. SOAK UP SPILL WITH AN INERT ABSORBENT AND PLACE INTO A
    DESIGNATED DISPOSAL CONTAINER. CONSULT LOCAL REGULATORY AGENCY FOR
    PROPER DISPOSITION OF MATERI AL.

======================	Handling and Storage  ======================

Handling and Storage Precautions:DO NOT STORE NEAR SOURCES OF HEAT, IN
    DIRECT SUNLIGHT OR WHERE TEMPERATURES EXCEED 49C/120F. DO NOT
    PUNCTURE OR DAMAGE CONTAINERS.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NO RESPIRATORY PROTECTION IS REQUIRED IF GOOD
    VENTILATION IS MAINTAINED. USE A NIOSH APPROVED RESPIRATOR TO
    PREVENT OVEREXPOSURE. LOCAL EXHAUST IS ADEQUATE UNDER NORMAL
    CONDITIONS. CHEMICAL RESISTANT  GLOVES AND CHEMICAL SAFETY SHOULD
    BE AVAILABLE FOR USE PUT PRUDENT USAGE WOULD NOT REQUIRE THIS
    EQUIPMENT.
Ventilation:LOCAL EXHAUST IS ADEQUATE UNDER NORMAL CONDITIONS. IF
    SPRAYING LARGE AMOUNTS ADEQUATE VENTILATION SHOULD BE USED.
Protective Gloves:CHEMICAL RESISTANT GLOVES.
Eye Protection:AND CHEMICAL SAFETY GLASSES.
Supplemental Safety and Health

==================  Physical/Chemical Properties  ==================

Vapor Pres:140 PSIG AT 130 F
Vapor Density:>1
pH:8.5
Evaporation Rate & Reference:<1.0
Solubility in Water:COMPLETE
Appearance and Odor:WIDE, HOLLOW CONE SPRAY, SEMI-STABLE FORM. WHITE
    FOAM FLORAL FRAGRANCE

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS, HEAT AND OPEN FLAMES.
Stability Condition to Avoid:MATERIAL IS STABLE, HOWEVER, AVOID
    SPRAYING NEAR OPEN FLAMES OR RED HOT COILS.
Hazardous Decomposition Products:COMBUSTION MAY PRODUCE CARBON MONOXIDE
    AND CARBON DIOXIDE, ADDITIONAL TOXIC CHEMICALS MAY BE FORMED IN
    SMALL AMOUNTS.
Conditions to Avoid Polymerization:WILL NOT OCCUR.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DO NOT PUNCTURE OR INCINERATE CONTAINERS. WHEN
    CONTENTS ARE DEPLETED CONTINUE TO DEPRESS BUTTON UNTIL ALL GAS IS
    EXPELLED.DISPOSE  OF CONTAINER IN ACCORDANCE WITH FEDERAL, STATE
    AND LOCAL REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***