MATERIAL SAFETY DATA SHEET
SECTION 1 PRODUCT IDENTIFICATION
PRODUCT NAME: ALUMA BRITE conc
QwicClean Brand
PRODUCT CODE: 16220
1827 Auger Drive
Tucker, Georgia 30084
NFPA acute hazard rating:
NFPA hazard codes:
Emergency Phone: (800) 552-3787
0 = Least 3 = High Health: 3
Prepared on 07/07/2005
1 = Slight 4 = Extreme Flammability: 0
2 = Moderate Reactivity: 2
SECTION 2 CHEMICAL COMPOSITION
Note: List all CERCLA hazardous substances at 1% or greater and CARCINOGENS at 0.1% or greater.
TLV / STEL /
INGREDIENT (chemical name) CAS# % range PEL TWA Ceiling Skin
Hydrofluoric Acid 7664-39-3 <10 3 ppm Air 3 ppm 6 ppm *
Nonylphenol ethoxylate 9016-45-9 <2 N/A N/A N/A
Phosphoric Acid 7664-38-2 <10 1mg/m 3 1mg/m 3 3mg/m 3 2-
Note: Hydrofluoric and Phosphoric Acid are SARA TITLE III SECTION 313 materials subject to reporting by user within the manufacturing section.
Hydrofluoric Acid are SARA TITLE III SECTION 302 reporting for inventories of this product exceeding 800 pounds.
Hydrofluoric,and Phosphoric Acid are SARA TITLE III SECTION 304 materials subject to reporting by user within the manufacturing section.
* OHSA requires skin protection to prevent or reduce exposure to this product.
SECTION 3 EMERGENCY & FIRST AID PROCEDURES
EMERGENCY FIRST AID: EYES: All exposures are considered severe. Immediately flush with large amounts of water for at least 15 minutes, Irrigate
with 600 to 1000cc's of calcium gluconate 1% in saline solution while holding eyelids open, lifting upper and lower lids occasionally. Get immediate medical
attention. SKIN: Affected area should be SHOWERED/DRENCHED with water for several minutes, remove all contaminated clothing. Do not remove goggles
until decontamination has occurred. NOTE THE TIME. Initiate the applying of calcium gluconate 2.5% gel to the effected area. Alternative treatment, soak
exposed area with an iced solution of AQUEOUS ZEPHIRAN. Get immediate medical attention. INHALATION: Initiate oxygen administration at a 2 to
6 L per minute flow and nebulize a solution of calcium gluconate at 2.5% concentration until medical help is reached. INGESTION: Do not induce vomiting.
If victim is conscious, give orally high amounts of any calcium based antacid. Get immediate medical attention.
NOTE TO PHYSICIAN: Contains Hydrofluoric & Phosphoric Acid.
SECTION 4 PHYSIOLOGICAL EFFECTS
PRIMARY ROUTE(S) OF ENTRY INTO BODY: Eyes, Skin contact, Inhalation, Ingestion.
ACUTE EFFECTS: IMMEDIATE ACUTE HEALTH HAZARD: Eyes: Conjunctivitis, Corneal Burns, Blindness. Skin: Severe
Burns with Ulceration. Inhalation: Cough, Spitting blood, Dyspnea, Shock, Muscle Spasms. Ingestion: Nausea, Vomiting,
HHGGGGGGASSas & Corrosion of Mouth, Espophagus, Stomach & Small Bowel.
Abdominal Pain, Burns
CHRONIC EFFECTS: Death, Lung Damage, Pulmonary Adema, Severe Liver & Kidney Damage.
SECTION 5 OCCUPATION CONTROL PROCEDURES
VENTILATION: Local exhaust.
PERSONAL PROTECTION:
Respirator type: None required if concentration is below TLV/PEL. Otherwise use NIOSH approved CCROV or better
respirator.
Gloves: Chemical resistant gloves required.
Eye Protection: Chemical splash goggles with face shield.
SECTION 6 PHYSICAL DATA
Appearance/odor: Clear / astringent pH concentrate: 0-1.0
Physical state: Liquid 1% pH dilution: 0-1.5
Boiling Point: 180潞 F Solubility in water: Complete
Freeze Point: 30潞 F Vapor pressure: 50 mmHg
Specific Gravity: 1.08 Vapor density (air=1): >1
Evaporation rate (water = 1): <1
MATERIAL SAFETY DATA SHEET
SECTION 7 FIRE & EXPLOSION DATA
Flash point: None.
Method: T.C.C.
Flammable (explosive) limits in air: N/A.
Suitable extinguishing media: Water / foam.
Hazardous combustion bi-products: Heat, fluorine gas and hydrogen fluoride fumes.
Recommended fire fighting procedures: Firefighters should wear waterproof protective clothing and self-contained positive
ventilation respiratory protection to prevent exposure to toxic and corrosive fumes and mist.
Unusual fire & explosive hazards: Corrosive hydrofluoric acid fumes (hydrogen gas) may be present.
SECTION 8 REACTIVITY DATA
Stability: Stable.
Conditions to avoid: Extreme heat.
Hazardous decomposition products: Heat, fluorine gas and hydrogen fluoride fumes.
Hazardous polymerization: Will not occur.
Incompatibility:
Material to avoid: Strong alkalines, glass, ceramic, oxidizable materials.
Corrosive action on material: Metals.
SECTION 9 STORAGE & HANDLING PRECAUTIONS
Storage: Store at temperatures below 120潞 F. Do not allow to freeze.
Handling: Wear proper gloves, boots, eye and face protection when handling.
Precautionary labeling: Corrosive, Toxic
SECTION 10 ENVIRONMENTAL INFORMATION
Spill or leak procedures:
Small spill/leak: Neutralize with sodium carbonate or sodium bicarbonate. Collect solution in containers for disposal.
Do not flush to sewer or discharge to natural waterways as this product may be toxic to aquaticorganisms.
Large spill/leak: Neutralize with sodium carbonate or sodium bicarbonate. Collect solution in containers for disposal.
Do not flush to sewer or discharge to natural waterways as this product may be toxic to aquatic organisms.
Spill reportable quantity: 1000 pounds or more.
Waste disposal method: Consign to waste facility approved by federal, state, and local regulations. Do not flush to
sewer or discharge to natural waterways as this product may be toxic to aquatic organisms.
RCRA or appropriate waste classification: U-134 for Hydrofluoric Acid.
Procedures for handling empty containers: Triple rinse.
Environmental toxicity data: Surfactants are biodegradable.
Other regulatory controls:
Is material classified under the CLEAN WATER ACT (USA) or appropriate water regulations as:
Toxic pollutant? Yes
Hazardous substance (SECTION 302)? Yes.
If yes, reportable quantity (R.Q.). 1000 pounds.
Is material classified under the CLEAN AIR ACT (USA) or appropriate CLEAN AIR regulations as:
Hazardous air pollutant (SECTION 12)? No.
SECTION 11 PRODUCT IDENTIFICATION
Indicate country/regulatory agency which specifies requirements: USA-DOT/ IMO
Proper shipping name: Corrosive Liquids, Toxic, n.o.s.(containing Hydrofluoric, Phosphoric Acids)
Hazard class: 8 (6.1)
Identification number: UN2922 PRODUCT NAME: ALUMA BRITE conc
Packing Group: II PRODUCT CODE: 16220
Labels required: Product, Corrosive, Toxic PREPARED:Revised 07/07/2005
|