Arctic Silver Inc. MSDS #ACN1
SECTION 1: CHEMICAL PRODUCT AND COMPANY INFORMATION
Company Address:
2230 West Sunnyside Avenue Suite 6
Visalia, CA 93277 Prepared by: Nevin House
Product Information: 559-740-0912 Emergency: 559-740-0912
Customer Service: 559-740-0912 Revision Date: December 20, 2004
Product Identification
ArctiClean Step 1 Thermal Material Remover
Product Code: ACN1
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
Product Ingredient Information CAS No.
D-Limonene 68647-72-3
Methyl Esters of Soybean Oil 67784-80-9
Non-Ionic Surfactant 68603-25-8
SECTION 3: HAZARD IDENTIFICATION
Emergency Overview: Appearance: Pale Yellow Liquid
Potential Health Effects:
Eyes: May cause irritation.
Skin: May cause slight irritation.
Ingestion: May cause indigestion.
Inhalation: Inhalation may be irritating to the respiratory tract.
Chronic Effects of Over Exposure: No specific information available.
SECTION 4: FIRST AID MEASURES
Eyes: Immediately flush with water holding eyelids apart to rinse the entire surface of the eye.
Skin: Wash skin with soap and water.
Ingestion: Give water or milk. Do not induce vomiting.
Inhalation: In case of discomfort caused by inhaling a high concentration of vapors, get fresh air.
SECTION 5: FIRE FIGHTING MEASURES
Flash Point: 195掳F Autoignition Temperature: >500F
Extinguishing Media: Carbon dioxide, foam, water or dry powder
Fire Fighting Instructions: Remove all ignition sources. Closed containers may rupture due to build-up of pressure when exposed to extreme heat. Fight fire from a
safe distance. As in any fire, wear self-contained breathing apparatus (pressure demand, OSHA/NIOSH approved or equivalent) and full protective gear.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Spills: Absorb spill with absorbent material, then place in a sealed container for proper disposal.
SECTION 7: HANDLING AND STORAGE
Overheating may cause container to rupture. Use explosion proof electrical equipment. Store in a cool dry place. Keep away from heat or sources of ignition. Check
all containers for leaks. Avoid prolonged breathing of vapors or contact with skin.
KEEP OUT OF REACH OF CHILDREN.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guidelines: No Exposure Information Available
NFPA and HMIS Codes:
Health 0
Flammability 1
Reactivity 0
Personal Protection B
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Pale yellow liquid PH: 5.2
Odor: Mild citrus aroma. Solubility in Water: Emulsifies
Evaporation Rate: < 1 (Ether = 1) Specific Gravity: 0.85
Vapor Pressure: < 1 mm Hg @ 18C Boiling Range: 195F
Vapor Density: 4.73 (Air = 1) Percent Volatile: < 80%
SECTION 10: STABILITY AND REACTIVITY INFORMATION
Stability: This product is stable.
Conditions to Avoid: This product is safe under normal storage and handling conditions.
Incompatibility: Strong oxidizing agents.
Products of Decomposition: Fumes produced when heated to decomposition may contain carbon monoxide, carbon dioxide.
Hazardous Polymerization: Will not occur.
Conditions to avoid: NA
SECTION 11: CARCINOGEN INFORMATION
Cancer Information: No ingredients listed as human carcinogens by NTP or IARC
SECTION 12: ECOLOGICAL INFORMATION
Environmental Impact Information
Avoid runoff into storm sewers and ditches that lead to waterways. Water runoff can cause environmental damage.
REPORTING
US regulations require reporting spills of this material that could reach any surface waters. The toll free number for the US Coast Guard National Response Center is:
1-800-424-8802
Page 1 of 2
Arctic Silver Inc. MSDS #ACN1
SECTION 13: DISPOSAL CONSIDERATIONS
Dispose of in accordance with all federal, state and local regulations. Water runoff can cause environmental damage.
SECTION 14: TRANSPORTATION INFORMATION
Air and Ground Shipments: Not Regulated
SECTION 15: OTHER INFORMATION
Do not puncture or incinerate containers.
To the best of our knowledge, the information contained herein is accurate. However, all materials may present unknown hazards and should be used with caution. In
particular, improper use of our products and their inappropriate combination with other products and substances may produce harmful results which cannot be
anticipated. Final determination of the suitability of any material is the sole responsibility of the user. Although certain hazards are described herein, we cannot
guarantee that these are the only hazards that may exist.
Page 2 of 2
|