MATERIAL SAFETY DATA SHEET
Revised/ Reviewed: July 23, 2007
INSTRUMENT PREP ENZYME SPRAY (REF 3-760)
A ready-to-use enzymatic foaming spray for pre-cleaning of soiled of surgical and dental instruments.
Section 1- Product and Company Information
Manufacturer: Miltex, Inc; 589 Davies Drive, York, PA 17402
Information: 717-840-9335, 717-840-9347 (fax)
Chemical Name & Synonyms: --
Chemical Formula: --
Section 2 鈥? Composition/ Information on Ingredients
All ingredients are considered non-hazardous according to the Federal Hazard Communication
Standard (29 CFR 1910.1200) and DOT (19 CFR 171-180). Contains Proteinase Subtilisin (CAS #
9014-01-1).
Section 3 - Health Identification
Primary Route(s) of Entry: Inhalation, skin, and ingestion.
Health Hazards (Acute and Chronic): None known. Not expected to be toxic via inhalation, skin, or
ingestion. Repeated inhalation of enzyme spray or mist may cause allergic reaction in susceptible
persons. The material can be an eye irritant in concentrated form.
Carcinogen: No known carcinogenic effects.
Signs and Symptoms of Exposure: Skin- dermatitis. Eyes- irritation/ reddening. Inhalation- asthma
type. Ingestion- may cause mild nausea or diarrhea.
Medical Conditions Aggravated by Exposure: Asthma and dermatitis.
Section 4 - First Aid Measures
Eyes: Flush with tepid water for at least 15 minutes. As needed, seek medical attention.
Skin: Wash affected area with copious of water. Treat as any mild irritant.
Ingestion: Do not induce vomiting. As needed, seek medical attention.
Inhalation: Remove person to fresh air. As needed, seek medical attention.
Section 5 鈥? Fire Fighting Measures
Material is non-flammable.
Section 6 - Physical and Chemical Properties
Physical State: Liquid at ambient temperature.
Appearance and Odor: Golden, clear liquid with a characteristic odor.
Boiling Point (掳C): 100
Specific Gravity (H2O=1): 1.00 鈥? 1.08
Vapor Pressure (mm Hg): As water
Vapor Density (Air=1): 1
Evaporation Rate (butyl acetate=1): As water
Solubility in Water: Infinite pH: 6.5 鈥? 7.5
Page 1 of 2 Instrument Prep Enzyme Spray MSDS
Section 7 鈥? Stability and Reactivity
Stability: Stable
Conditions to Avoid: None known.
Incompatibility/ Materials to Avoid: Oxidizing agents
Hazardous Polymerization: Will not occur
Hazardous Decomposition Products: None known.
Section 8 鈥? Accidental Release, Disposal, and Ecological Information
Spill Response: Flush to sewage or any disposal system.
Waste Disposal Method: Dispose of in accordance with all applicable federal, state, and local
regulations. Generally, the material can be flushed to any disposal system.
Ecological, General: This material is not expected to be harmful to the environment.
Section 9 鈥? Exposure Controls/ Personal Protection
Eye Protection: Goggles or lab safety glasses are recommended when working with concentrate.
Respiratory Protection: NIOSH-approved mask if mist likely.
Ventilation Recommendations: Normal
Skin Protection: Wear impervious gloves.
Other: Observe general good housekeeping practices
Section 10 鈥? Storage and Handling
Storage: Product efficacy may be lost if temperatures exceed 130掳F (55掳C) or if pH exposure is below
2.5 or above 9.5.
Handling: None
Section 11 鈥? Miscellaneous
Toxicological Information: --
Transportation Information: Not a DOT hazardous material.
Other: --
Liability Disclaimer: MSDS information is provided based on OSHA鈥檚 Hazardous Communication Regulation and for use of the persons
required to receive this information under this regulation. The information is neither designed nor recommended for any other use or for
use by any other person, including compliance with other laws. Miltex does not warrant the suitability for use of this MSDS for any
other material or product not specifically identified herein. Miltex does not warrant the accuracy or authenticity of this MSDS unless it
has been obtained directly from Miltex, or posted or viewed on a Miltex website. This MSDS is based on information that is believed to
be reliable, but may be subject to change as new information becomes available. Because it is not possible to anticipate all conditions of
use, additional safety precautions may be required. Since the use of this material is not under Miltex鈥檚 control, each user is responsible
for making their own determination as to the safe and proper handling of this material in their own particular use of this material. Miltex
makes no representation or warranty, either express or implied, including as to merchantability or fitness for a particular purpose.
Page 2 of 2 Instrument Prep Enzyme Spray MSDS
|