SECTION V HEALTH HAZARD DATA
MATERIAL SAFETY DATA SHEET MM 600-1
Threshold Limited Value OSHA Regulation 28CFR 1910.1000; TWA: 5 mg/m3 for oil mist in air.
ALDON 1533 W.Henrietta Rd. None listed ACGIH 1992-93.
MM 600-1
Avon, New York 14414 MSDS No.
庐
CORPORATION June 21, 1996
Effective Date
(716) 226-6177
Effects of Overexposure Not a carcinogen as per OSHA, IARC standards. This product is judged neither "corrosive"
or an "irritant" by OSHA criteria. SKIN: Prolonged or repeated contact cause dermatitis
SECTION I NAME 24 HOUR EMERGENCY ASSISTANCE (skin irritation). EYES: May cause irritation. INGESTION: Product has a low order of
acute oral or dermal toxicity, but minute amounts aspirated into the lungs during ingestion
Product MOTOR OIL, SAE 30 or vomiting may cause mild to severe pulmonary injury and possibly death.
CHEMTREC
1 1
Health
800-424-9300
Chemical
Emergency and
1 0
Petroleum Lubricating Oil EYES: If splashed into the eyes, flush with clear water for 15 minutes or until
Synonyms 1
Fire
Day 716-226-6177
First Aid Procedures irritation subsides. If irritation persists, get medical attention. SKIN: If case of
Formula Complex mixture. 0
Reactivity skin contact, remove any contaminated clothing and wash skin thoroughly with
NFPA
soap and water. INHALATION: Remove victim from exposure and call
HAZARD RATING HMIS *
Unit Size 120 mL. (4 oz.)
physician. If breathing is irregular or has stopped, start resuscitation;
LEAST SLIGHT MODERATE HIGH EXTREME
0 1 2 3 4 administer oxygen, if available. INGESTION: Do NOT induce vomiting; call
C.A.S. No. Not applicable.
physician immediately.
SECTION II INGREDIENTS OF MIXTURES
SECTION VI REACTIVITY DATA
Principal Component(s) % TLV Units
Conditions to Avoid
Stability Unstable Excessive temperature or heat.
Lubricating Oil Base Stock: (CAS No. 64742-54-7 or 64742-65-0) Approx. 90% See Section V.
Stable X
Proprietary Additive (Mixture) >10% Incompatibility
Keep away from strong oxidants such as hydrogen peroxide, bromine and chromic acid.
(Materials to Avoid)
Hazardous
CAUTION! Contact with skin and eyes may cause irritation. Carbon monoxide, carbon dioxide, oxides of phosphorous and sulfur oxides from burning.
Decomposition Products
SECTION III PHYSICAL DATA
Conditions to Avoid
Hazardous Polymerization
Specific Gravity (H2O = 1)
Melting Point (掳F) < -12掳C (10掳F) .86 - .89
May Occur Will Not Occur Not applicable.
Percent Volatile
Boiling Point (掳F) 330掳C (625掳F) N/A X
by Volume (%)
Evaporation Rate
SECTION VII SPILL OR LEAK PROCEDURES
Vapor Pressure (mm Hg) 0 at 20掳C ( n-Butyl Acetate =1) N/A
Steps to be taken in case
Vapor Density (Air=1) Not volatile. Recover free product. Absorb residue with an inert material such as
material is released or spilled sand, earth, vermiculite or other suitable absorbent to spill area. Wash
Solubility in Water 0% at 20掳C spill area with soap and water. Keep product out of sewers and water
courses. Wash spill area with soap and water.
Appearance & Odor Clear, dark amber liquid; mild, bland petroleum odor.
Discharge, treatment, or disposal may be subject to Federal, State or Local laws.
Waste Disposal Method
SECTION IV FIRE AND EXPLOSION HAZARD DATA These disposal guidelines are intended for the disposal of catalog-size quantities only.
Lower
Flammable Limits in Air Upper
Flash Point
> 190掳C (380掳F) COC N/A
% by Volume
(Method Used) Dispose of in an approved incinerator or submit to local gas service station.
Extinguisher Dry chemical, water fog, CO2 or foam.
SECTION VIII SPECIAL PROTECTION INFORMATION
Media
None needed in normal laboratory handling. If misty conditions prevail, work in ventilation
Respiration Protection
(Specify Type) hood or wear a NIOSH/MSHA-approved respirator.
SPECIAL FIREFIGHTING
Do not use water, except as fog. Water or foam may cause frothing. Closed Yes if misty or heated. Special No.
Local Exhaust
PROCEDURES Ventilation
containers exposed to fire may be cooled with water. Water spray may be Mechanical (General) Yes if misty or heated. Other Adequate to maintain below exposure limit.
used to flush spills away from exposures. Minimize breathing gases, vapors,
Protective Gloves Eye Protection
Neoprene type. Chemical safety glasses.
fumes or decomposition products. Use supplied-air breathing equipment for
enclosed or confined spaces or as otherwise needed. Other Protective
Lab coat, apron, eye wash station, proper gloves and fire extinguisher.
Equipment
Autoignition Temperature: Greater than 260掳C (500掳F)
SECTION IX SPECIAL PRECAUTIONS
Precautions to be Taken Do not handle or store at temperatures above 38掳C (100掳F). Use product
UNUSUAL FIRE AND in Handling & Storing with caution around heat, sparks, pilot lights, static electricity and open
EXPLOSION HAZARDS Keep container tightly closed when not in use. flame. Wash thoroughly after handling.
Read label on container before using. Do not wear contact lenses when working with chemicals.
Other Precautions
Decomposition products under fire conditions: Fumes, smoke, carbon
Minimize breathing vapor, mist or fumes. Avoid prolonged or repeated contact
monoxide, sulfur oxides, aldehydes and other decomposition products, in
with skin. Remove contaminated clothing; launder or dry-clean before reuse.
the case of incomplete combustion. Reacts violently with strong oxidizers.
Remove contaminated shoes and thoroughly clean before reuse.
For laboratory use only. Not for drug, food or household use. Keep out of reach of children.
Chemical Safety
Approved
Revision Date
No. 2 6/21/96 Michael Raszeja MR
Coordinator
D.O.T. NON-REGULATED. The information contained herein is furnished without warranty of any kind. Employers should use this information only as a supplement to other information
gathered by them and must make independent determinations of suitability and completeness of information from all sources to assure proper use of these
Approved by U.S. Department of Labor "essentially similar" to form OSHA-20 materials and the safety and health of employees. * Hazardous Materials Industrial Standards. Printed on recycled paper.
|