SECTION V HEALTH HAZARD DATA
MATERIAL SAFETY DATA SHEET PP 90
Threshold Limited Value
ALDON None established. (ACGIH 1992-93).
1533 W.Henrietta Rd.
PP 90
Avon, New York 14414 MSDS No.
庐
CORPORATION December 31, 1996
Effective Date
(716) 226-6177
Effects of Overexposure
Can produce mechanical irritation to the eye or skin irritation to
hypersensitive personnel in both acute and chronic exposures.
SECTION I NAME 24 HOUR EMERGENCY ASSISTANCE
Exercise appropriate procedures to minimize potential hazards.
Product PERMUTIT CHEMTREC Health 1
800-424-9300
Chemical
Emergency and
Cullex, Cation Exchange Resin
Synonyms 0
Fire
Day 716-226-6177
First Aid Procedures
Formula See Section II. 0
Reactivity SKIN: Flush thoroughly with water, then wash with mild soap and
NFPA
water. EYES: Flush thoroughly with water for at least 15 minutes,
HAZARD RATING HMIS *
Unit Size up to 2.5 Kg.
lifting lower and upper eyelids occasionally. If irritation persists, get
LEAST SLIGHT MODERATE HIGH EXTREME
medical attention.
0 1 2 3 4
C.A.S. No. 69011-22-9
SECTION II INGREDIENTS OF MIXTURES
SECTION VI REACTIVITY DATA
Principal Component(s) % TLV Units
Conditions to Avoid
Stability Unstable Avoid freezing (32掳C), or prolonged storage above
Product contains: Sulfonated copolymer of styrene and 50掳C (122掳F). Excessive temperature and heat.
Stable X
Divinylbenzene in sodium form: (CAS No. 69011-22-9) 50-65% None established. Incompatibility
Strong oxidizing agents such as Nitric acid.
(Materials to Avoid)
Water: (CAS No. 7732-18-5) 35-50% None established.
Hazardous Combustion may produce carbon monoxide, carbon dioxide, styrene,
CAUTION! MAY CAUSE SKIN IRRITATION.
Decomposition Products sulfur dioxide, divinylbenzene.
SECTION III PHYSICAL DATA
Conditions to Avoid
Hazardous Polymerization
Specific Gravity (H2O = 1)
Melting Point (掳F) Decomposes @ 204掳C (400掳F) 1.3
May Occur Will Not Occur Not applicable.
Percent Volatile
Boiling Point (掳F) Decomposes. 35-50% (water)
by Volume (%) X
Evaporation Rate
SECTION VII SPILL OR LEAK PROCEDURES
Vapor Pressure (mm Hg) 17 @ 20掳C (68掳F) water Water 1
=1)
(
Steps to be taken in case
Vapor Density (Air=1) 0.62 (water) Recover for use if not contaminated. Sweep up and place in
material is released or spilled
suitable container. Resin beads under foot can lead to falls.
Solubility in Water Insoluble.
Area of spills can become extremely slippery.
Appearance & Odor Dark spherical beads with no odor.
Discharge, treatment, or disposal may be subject to Federal, State or Local laws.
Waste Disposal Method
SECTION IV FIRE AND EXPLOSION HAZARD DATA These disposal guidelines are intended for the disposal of catalog-size quantities only.
Lower
Flammable Limits in Air Upper
Flash Point
Dispose of in an approved incinerator equipped with an afterburner and
Non-flammable. N/A
% by Volume
(Method Used)
scrubber or in an approved chemical landfill.
Extinguisher
Water spray or fog; dry chemical; carbon dioxide (CO ). SECTION VIII SPECIAL PROTECTION INFORMATION
Media 2
None needed in normal laboratory handling. If dusty conditions prevail, work in
Respiration Protection
ventilation hood or wear a NIOSH/MSHA-approved dust mask or respirator.
(Specify Type)
SPECIAL FIREFIGHTING
Local Exhaust Special
None needed. No.
PROCEDURES Ventilation None needed. No.
Mechanical (General) Other
In fire conditions, wear a NIOSH/MSHA-approved self-contained Protective Gloves Eye Protection
Rubber. Chemical safety glasses.
breathing apparatus and full protective clothing including eye
Other Protective
protection. Lab coat, apron, eye wash station, proper gloves.
Equipment
SECTION IX SPECIAL PRECAUTIONS
Avoid freezing or prolonged storage above 50掳C (122掳F), product contains
Precautions to be Taken
UNUSUAL FIRE AND water that will freeze or evaporate and therefor damage product. Store in a
in Handling & Storing
cool place and keep from drying. If dried add water. Avoid contact with skin
EXPLOSION HAZARDS Keep container tightly closed when not in use.
and eyes. Wash thoroughly after handling.
Fire or excessive heat may produce hazardous decomposition products. Read label on container before using. Do not wear contact lenses when working with chemicals.
Other Precautions
Explosive reactions can occur in the presence of strong oxidizing agents.
Use in keeping with good laboratory practices.
Autoignition occurs at temperatures greater than 500掳C (932掳F). Remove and wash contaminated clothing.
For laboratory use only. Not for drug, food or household use. Keep out of reach of children.
Chemical Safety
Approved
Revision Date 12/31/96
No. 3 Michael Raszeja MR
Coordinator
D.O.T. NON-REGULATED. The information contained herein is furnished without warranty of any kind. Employers should use this information only as a supplement to other information
gathered by them and must make independent determinations of suitability and completeness of information from all sources to assure proper use of these
Approved by U.S. Department of Labor "essentially similar" to form OSHA-20 materials and the safety and health of employees. * Hazardous Materials Industrial Standards. Printed on recycled paper.
|