SumTech AQ-320
MATERIAL SAFETY DATA SHEET
Print date: 13-Feb-2007 Revision Number: 4
1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND THE
COMPANY/UNDERTAKING
Product name: SumTech AQ-320
Synonyms: No information available
Chemical characterisation: No data is available on the product itself.
Supplier:
Summit Industrial Products
9010 County Road 2120
Tyler, Texas 75707
Phone: (903) 534-8021
Fax: (903) 581-4376
Emergency telephone number CHEMTREC: 1-800-424-9300
2. COMPOSITION/INFORMATION ON INGREDIENTS
ACGIH (TWA mg/m3 ):
Components CAS-No OSHA:
Mineral Oil 8012-95-1 5 None
Barium Soap Thickener Proprietary None None
3. HAZARDS IDENTIFICATION
Properties affecting health: None.
Principle routes of exposure: Skin.
Skin contact: Substance may cause slight skin irritation.
Eye contact: Avoid contact with eyes. May cause slight irritation.
Inhalation: None..
Ingestion: Ingestion may cause gastrointestinal irritation, nausea, vomiting and diarrhoea
4. FIRST AID MEASURES
General advice: Consult a physician
Skin contact: Wash off immediately with soap and plenty of water.
Inhalation: Move to fresh air in case of accidental inhalation of fumes from overheating or
combustion.
Product name: SumTech AQ-320 1 of 5
Eye contact: Flush eye with water for 15 minutes.
Ingestion: If swallowed, seek medical advice immediately and show this container or label. Do
not induce vomiting without medical advice.
5. FIRE-FIGHTING MEASURES
Suitable extinguishing media:
Carbon dioxide (CO2), Water spray mist or foam
Extinguishing media which must not be used for safety reasons:
No information available.
Special protective equipment for firefighters:
As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full
protective gear.
Specific hazards: Not applicable.
Unusual hazards: No hazards to be especially mentioned
Specific methods: In the event of fire, cool tanks with water spray
Flash point: >570 (掳F)
Method: Cleveland Open Cup
Autoignition temperature: No information available
Flammability Limits in Air:
Lower No information available
Upper No information available
6. ACCIDENTAL RELEASE MEASURES
Personal precautions: No conditions to be specially mentioned.
Environmental precautions: Do not flush into surface water or sanitary sewer system.
Methods for cleaning up: Sweep up and shovel into suitable containers for disposal.
7. HANDLING AND STORAGE
Handling
Technical measures/precautions: No special technical protective measures required.
Safe handling advice: No special precautions required
Storage
Technical measures/storage conditions: Keep tightly closed in a dry and cool place.
Incompatible products: Oxidising and spontaneously flammable products.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering measures to reduce exposure:
Ensure adequate ventilation, especially in confined areas.
Personal Protective Equipment
Respiratory protection: No special protective equipment required
Hand protection: Impervious gloves.
Skin and body protection: Usual safety precautions while handling the product will provide adequate protection
against this potential effect.
Eye protection: Safety glasses
Hygiene measures: Avoid contact with skin, eyes and clothing.
2 of 5
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Solid Appearance: Paste
Color: Beige Odor: Characteristic
Specific gravity: No information available Boiling point/range No information available
Evaporation rate: Not determined Vapor density: Not determined
Vapor pressure: Not determined Solubility: Insoluble
10. STABILITY AND REACTIVITY
Stability: No hazards to be especially mentioned
Polymerization: None under normal processing.
Hazardous decomposition products: None reasonably foreseeable
Materials to avoid: Oxidising agents.
Conditions to avoid: Stable at normal conditions
11. TOXICOLOGICAL INFORMATION
Acute toxicity No data available
12. ECOLOGICAL INFORMATION
Mobility: Not applicable
Bioaccumulative potential: Not determined.
Ecotoxicity effects: No data available.
Aquatic toxicity: No information available.
13. DISPOSAL CONSIDERATIONS
Waste from residues / unused In accordance with local and national regulations.
products:
Contaminated packaging: Empty containers should be taken for local recycling, recovery or waste disposal
14. TRANSPORT INFORMATION
DOT
Proper shipping name: Not Regulated
TDG (Canada)
Proper shipping name: Not determined
IMO / IMDG
Proper shipping name: Not Regulated
ICAO
3 of 5
Proper shipping name: Not Regulated
IATA
Proper shipping name: Not Regulated
15. REGULATORY INFORMATION
International Inventories
PICCS: This product does not comply with phil:
TSCA: Listed in TSCA
DSL: Not listed in DSL
ENCS: This product does not comply with JPENCS
CHINA: This product does not comply with china:
AICS: This product does not comply with AICS
KECL: This product does not comply with korea:
EINECS/ELINCS This product does not comply with EINECS/ELINCS
U.S. Regulations:
Mineral Oil
MARTK: Listed.
NJRTK: Substance no. 1437 Listed.
PARTK: Listed.
RIRTK: Listed.
ILRTK: Listed.
Sara (311, 312) hazard class:
Canada
WHMIS hazard class:
Not determined
16. OTHER INFORMATION
NFPA Health: 1 Flammability: 1 Instability: 0
HMIS Health: 1 Flammability: 1 Physical Hazard: 0
NFPA symbol:
Reason for revision: A component has been added to the formulation. SEE SECTION 2.
Prepared by: Health & Safety
The information and recommendations contained herein are based upon tests believed to be reliable. However, Summit
does not guarantee their accuracy or completeness NOR SHALL ANY OF THIS INFORMATION CONSTITUTE A
WARRANTY, WHETHER EXPRESSED OR IMPLIED, AS TO THE SAFETY OF THE GOODS, THE MERCHANTABILITY
OF THE GOODS, OR THE FITNESS OF THE GOODS FOR A PARTICULAR PURPOSE. Adjustment to conform to
actual conditions of usage maybe required. Your company assumes no responsibility for results obtained or for incidental
or consequential damages, including lost profits arising from the use of these data. No warranty against infringement of
any patent, copyright or trademark is made or implied.
4 of 5
5 of 5
|