www.tra-con.com
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Name: Date Printed: 11/29/2005
TRA-COAT 15C One Part Adhesive
Revision Date: 8/11/2005
TRA-CON, INC.
45 Wiggins Avenue Revision: B
Bedford, MA 01730
781-275-6363
1-800-872-2661
Emergency Telephone: 1-800-424-9300 (24 hours, CHEMTREC)
2. COMPOSITION/INFORMATION ON INGREDIENTS
TWA STEL Ceiling
Component CAS Number %
OSHA
ACGIH ppm mg/m3 ppm mg/m3 ppm mg/m3
Acrylic ester -- 20 - 40
Mercaptan ester -- 20 - 40
No hazardous ingredients -- 20 - 40
3. HAZARDS IDENTIFICATION
Effects of Overexposure Repeated contact or breathing of vapors may cause irritation; material is also a strong
sensitizer. Eye and skin contact may cause transient irritation.
Eye May cause irritation
Skin Contact Frequent or prolonged contact can cause severe irritation. May cause skin sensitization,
a partial or whole-body dermatitis rash experienced after exposure, however, minimal
Inhalation Hazards Inhalation of vapor can be harmful.
Ingestion Hazards Harmful if swallowed
4. FIRST AID MEASURES
Eyes Flush eyes with water for at least 15 minutes. Get prompt medical attention.
Skin Wash immediately with soap and water. If irritation persists, seek medical attention
immediately.
Inhalation Remove to fresh air. Get medical attention if irritation persists.
Ingestion No known antidote but give milk or water; do NOT induce vomitting if swallowed; get
medical attention.
5. FIREFIGHTING MEASURES
Flashpoint > 300掳F
Flashpoint Method PMCC
Extinguishing Media Dry chemicals, chemical foam, carbon dioxide, water.
Special Firefighting Measures Avoid breathing smoke. Wear self contained breathing apparatus and appropriate
personal protective equipment to avoid contact.
Fire and Explosion Hazards Toxic gases may be liberated; handle as combustible; store in a cool place.
Flammable Limits N/AV
LEL N/A
UEL N/A
6.ACCIDENTAL RELEASE MEASURES
Spill and Leak Procedures Prevent skin and eye contact. Soak up in absorbent material, or scrape up and transfer
to disposal container. Wipe up remaining residue with solvents, observing solvent
flammability cautions, or use detergents.
QAF-1058 Rev D Date Printed: 11/29/2005 Page 1 of 3 15C One Part Adhesive
7. HANDLING AND STORAGE
Handling and Storage As required to prevent all body contact; eye bath and/or safety shower.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Local Exhaust Use with adequate ventilation. Local exhaust is recommended when appropriate to
control employee exposure.
Mechanical Exhaust Recommended
Eye Protection Requirements Wear safety glasses with side shields.
Glove Requirements Rubber or plastic disposable.
Respirator Requirements Air supplied or organic canister, mask in confined areas.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance and Odor semi viscous, clear liquid; sulfurous odor
Boiling Point (掳F) N/A
Solubility in Water insoluble
Specific Gravity (H2O=1) 1.1
Evaporation Rate (BuAc=1) <1
Vapor Pressure (mm Hg.) < 0.1
Vapor Density (air = 1) >1
Percent Volatile ND
10. STABILITY AND REACTIVITY
Stability Stable
Conditions to Avoid (Stability) Avoid uncontrolled excess heating over long periods; avoid uncontrolled amine reactions.
Incompatibility (Materials to Avoid) Carbon monoxide, carbon dioxide, aldehydes, phenol.
Hazardous Decomposition Products Carbon monoxide, carbon dioxide, aldehydes, nitrogen oxides, phenol.
Hazardous Polymerization Will Not Occur
11. TOXICOLOGICAL INFORMATION
Primary Entry Route(s) Skin, eyes, inhalation
Oral, LD50 > 5 g/kg
Dermal, LD50 > 2 g/kg
12. ECOLOGICAL INFORMATION
Not available
13. DISPOSAL CONSIDERATIONS
Waste Disposal Methods Dispose of as hazardous waste according to local, state and federal regulations. Disposal
method can be land burial or chemical incineration as regulated by all governmental
agencies.
Empty Container Warnings Empty containers may contain product residue; follow MSDS and label warnings even after
they have been emptied.
14. TRANSPORTATION INFORMATION
Not Applicable
15. REGULATORY INFORMATION
TSCA: All components are on the TSCA inventory.
The information given and the recommendations made herein apply to our product(s) alone and are not combined with other product(s). Such are
based on our research and on data from other reliable soruces and are believed to be accurate. no guaranty of accuracy is made. it is the purchaser's
responsibility before using any product to verify this data under their own operating conditions and to determine whether the product is suitable for their
purposes.
16. OTHER INFORMATION
QAF-1058 Rev D Date Printed: 11/29/2005 Page 2 of 3 15C One Part Adhesive
This MSDS applies to all sizes of 15C including but not limited to the following part numbers:
CF-15C CF-WCC2B CG-15C CP-15C
HEUF-15C HEVP-15C HEWU-15C
MSDS Date: 8/11/2005 Revision: B
QAF-1058 Rev D Date Printed: 11/29/2005 Page 3 of 3 15C One Part Adhesive
|