Personalformulator.com
97 S. Red Willow Rd.
Evanston, WY 82930
US 1-800-426-2457 Ext. 1003
Material Safety Data Sheet
Acrylates/C10-30 Alkyl Acrylate Crosspolymer
Respiratory Protection: if respirable dust exposures exceed 0.05
1. Product Identification
mg/m3 (8-hour TWA), wear a NIOSH-approved respirator equipped with
Product Name: Acrylates/C10-30 Alkyl Acrylate Crosspolymer high efficiency particulate (HEPA) filters.
INCI Name: Acrylates/C10-30 Alkyl Acrylate Crosspolymer Protective Clothing: Eye protection (e.g., goggles) suitable for
Chem. N.: No data keeping dust out of the eyes. Wear protective gloves.
CAS Number: No data Other Protective Measures: No data
EINECS Number: No data 7. Hazards Identification
2. Physical and Chemical Properties General: Powder/dust eye irritation is a physical, not a chemical effect.
Solid particles on the eye (powder/dust) may cause pain and be accompanied
Melting Point: Not applicable by irritation. Dust inhalation may cause coughing, mucous production and
Boiling Point: Not applicable shortness of breath.
Refractive Index: No data Inhalation: Pre-existing respiratory disease(s) may be aggravated by
Evaporation Rate: Not volatile prolonged or repeated inhalation of airborne dust.
Specific Gravity: 1.40 Eye Contact: Solid particles on the eye (powder/dust) may cause pain
Solubility in Water: No data and be accompanied by irritation.
pH Value: 2.5-3.0 @ 1% in H20 Skin Contact: Pre-existing skin problems may be aggravated by
Appearance & Odor: Fluffy powder, white, slight acetic odor prolonged or repeated contact.
Ingestion: No data
3. Stability and Reactivity
8. First Aid Measures
Chemical Stability: Stable
Eyes: Water (moisture) swells this product into a gelatinous film and,
Incompatibility: Ammonia, sodium hydroxide, potassium hydroxide or
when in contact with the eye, may be difficult to remove using only water.
strongly basic amines can generate heat
Immediately flush eyes with plenty of one (1%) physiological saline for five
Hazardous Decomposition: Carbon monoxide, carbon dioxide,
minutes while holding eyelids open; see a physician. If no saline is easily
hydrocarbons, and irritating vapors.
available, flush eyes with plenty of clean water for 15 minutes; see a
Hazardous Polymerization: Will not occur
physician.
4. Handling and Storage Skin: Wash the affected area thoroughly with plenty of water and soap.
Inhalation: If any processing vapors, decomposition products or
Although the risk of a dust explosion is low, as a precaution, implement
particulates are inhaled, remove individual(s) to fresh air. Provide protection
the following safety measures:
before allowing reentry.
Bond, ground and properly vent conveyors, dust control devices and
Ingestion: No ingestion effects known. Treat symptomatically.
other transfer equipment.
9. Fire Fighting Measures
Eliminate ignition sources (e.g., sparks, static buildup, excessive heat,
etc.).
Flash Point: No data
Prohibit flow of polymer, powder or dust through non-conductive ducts,
Auto-ignition Temp: 968F (520 C)
vacuum hoses or pipes, etc.; only use grounded, electrically conductive
Extinguishing Media: Use water spray, dry chemical, or foam.
transfer lines when pneumatically conveying product. Prevent accumulation
Carbon dioxide may be ineffective on larger fires due to a lack of cooling
of dust (e.g., well-ventilated conditions, promptly vacuuming spills, cleaning
capacity which may result in re-ignition.
overhead horizontal surfaces, etc.). Use under well-ventilated conditions.
Fire Fighting Procedures: Avoid hose streams or any method which
Do not get in eyes. Do not ingest, taste, or swallow. Avoid repeated or
will create dust clouds. Wear self-contained breathing apparatus (SCBA)
prolonged skin contact. Avoid routine inhalation of dust of any kind.
equipped with a full face piece and operated in a pressure-demand mode (or
Exercise care when emptying containers, sweeping, mixing or doing other
other positive pressure mode) and approved protective clothing. Personnel
tasks which can create dust. Wash thoroughly after handling this product.
without suitable respiratory protection must leave the area to prevent
Always wash up before eating, smoking or using the facilities. Keep
significant exposure to hazardous gases from combustion, burning or
container closed when not in use. Store in dry area.
decomposition. In an enclosed or poorly ventilated area, wear SCBA during
5. Accidental Release Measures cleanup immediately after a fire as well as during the attack phase of
firefighting operations.
Using care to avoid dust generation, vacuum or sweep into a closed
10. Toxicological Information
container for reuse or disposal. Do not sweep or flush spilled product into
public sewer, streams or other water systems. If inhalation of dust cannot be
Acute Oral LD50: No data
avoided, wear a particulate respirator approved by NIOSH/MSHA.
Dermal and Eye Irritation Test: Negligible
Caution: Contact with water creates a very slippery film. If this occurs, the
Carcinogenicity: No data
film can be broken down for cleanup with detergent solution.
Mutagenicity: No data
6. Exposure Controls & Personal Protection
11. Disposal Considerations
Important Notice: The information presented herein is based on experimental data submitted by the manufacturers
of the raw materials and is considered scientifically correct; however, no warrant or representation, express or implied, is
made as to the accuracy or suitability of this information for application to the purchaser鈥檚 intended purpose or for
consequences of its use and we assume no responsibility for any loss, damage or expense, direct or consequential, arising
out of its use. Use these materials only as directed. If you have any questions regarding the proper interpretation of this
sheet or the meanings of any terms used, we strongly urge you to speak with your physician. For further information
concerning product safety and proper use, call the number listed on the front of the MSDS.
Personalformulator.com
97 S. Red Willow Rd.
Evanston, WY 82930
US 1-800-426-2457 Ext. 1003
Material Safety Data Sheet
Acrylates/C10-30 Alkyl Acrylate Crosspolymer
For waste disposal purposes, this product is not known to be defined or
designated as hazardous by current provisions of the Federal (EPA) Resource
Conservation and Recovery Act (RCRA, 40CFR261). Incinerate or landfill
waste in a properly permitted facility in accordance with federal, state and
local regulations. In appropriate dust/air ratio, dust cloud in air has explosion
potential. Therefore, land disposal must be in closed containers. If disposal
is in bulk form, recognize that this polymer absorbs moisture resulting in a
gelatinous mass that is unable to support human weight.
Important Notice: The information presented herein is based on experimental data submitted by the manufacturers
of the raw materials and is considered scientifically correct; however, no warrant or representation, express or implied, is
made as to the accuracy or suitability of this information for application to the purchaser鈥檚 intended purpose or for
consequences of its use and we assume no responsibility for any loss, damage or expense, direct or consequential, arising
out of its use. Use these materials only as directed. If you have any questions regarding the proper interpretation of this
sheet or the meanings of any terms used, we strongly urge you to speak with your physician. For further information
concerning product safety and proper use, call the number listed on the front of the MSDS.
|