Personalformulator.com
97 S. Red Willow Rd.
Evanston, WY 82930
US 1-800-426-2457 Ext. 1003
Material Safety Data Sheet
AMP
1. Product Identification 8. First Aid Measures
Product Name: AMP Eyes: Immediately flush eyes with plenty of water for at least 15
INCI Name: Aminomethyl Propanol minutes while holding eyelids wide apart. See a physician.
Chem. N.: No data Skin: In case of contact, immediately flush skin with plenty of water
CAS Number: No data while removing contaminated clothing and shoes. Get medical attention
EINECS Number: No data immediately. Thoroughly wash or discard clothing and shoes before reuse.
Inhalation: Remove to fresh air. If not breathing, give artificial
2. Physical and Chemical Properties respiration. If breathing is difficult, give oxygen. Get immediate medical
attention.
Melting Point: 30 to 31掳F Ingestion: DO NOT INDUCE VOMITING. Dilute stomach contents
Boiling Point: 100 to 165掳C with large amount of water. Neutralize with weak vinegar. See a physician.
Refractive Index: No data 9. Fire Fighting Measures
Evaporation Rate: No data
Specific Gravity: 0.942 at 25掳C (VOC): 100 Flash Point: 188掳F
Solubility in Water: Completely Miscible Auto-ignition Temp: No data
pH Value: 11.3 Extinguishing Media: Water, carbon dioxide, dry chemical, foam
Appearance & Odor: Colorless liquid and faint amine odor Fire Fighting Procedures: Wear self-contained breathing apparatus
to fight fires.
3. Stability and Reactivity
10. Toxicological Information
Chemical Stability: Stable
Acute Oral LD50: No data
Incompatibility: Copper, brass, aluminum
Dermal and Eye Irritation Test: No data
Hazardous Decomposition: Oxides of carbon and nitrogen
Carcinogenicity: Not a listed carcinogen.
Hazardous Polymerization: No
Mutagenicity: Nonmutagenic
4. Handling and Storage
11. Disposal Considerations
Do not get on skin and clothing. Freezes about 30掳C. May be melted in
Neutralize with dilute acid and discharge into an approved waste
drum. Keep container closed to prevent formation of AMP carbonate.
treatment system.
5. Accidental Release Measures
Small spill: Contain spill and recover if possible. Personnel should wear
equipment to prevent skin and eye contact.
Large spill: Neutralize unrecoverable spills with vinegar or other dilute
acid and flush area with water.
Comments: Neutralize with dilute acid and discharge into an approved
waste treatment system.
6. Exposure Controls & Personal Protection
Respiratory Protection: Not generally required
Protective Clothing: Use chemical splash goggles, face shield,
chemical impervious gloves and apron.
Other Protective Measures: Use local exhaust in areas where vapors
are generated, i.e. liquid held at high temperature.
7. Hazards Identification
General: No data
Inhalation: Vapors and/or aerosols which may be formed at elevated
temperatures may be irritating to eyes and respiratory tract.
Eye Contact: Causes eye burns
Skin Contact: Causes severe skin irritation
Ingestion: Harmful if ingested (damaging to mucous membranes)
Important Notice: The information presented herein is based on experimental data submitted by the manufacturers
of the raw materials and is considered scientifically correct; however, no warrant or representation, express or implied, is
made as to the accuracy or suitability of this information for application to the purchaser鈥檚 intended purpose or for
consequences of its use and we assume no responsibility for any loss, damage or expense, direct or consequential, arising
out of its use. Use these materials only as directed. If you have any questions regarding the proper interpretation of this
sheet or the meanings of any terms used, we strongly urge you to speak with your physician. For further information
concerning product safety and proper use, call the number listed on the front of the MSDS.
|