Personalformulator.com
97 S. Red Willow Rd.
Evanston, WY 82930
US 1-800-426-2457 Ext. 1003
Material Safety Data Sheet
Methylparaben
1. Product Identification 8. First Aid Measures
Product Name: Methylparaben Eyes: In case of contact with eyes rinse thoroughly with plenty of water
INCI Name: Methylparaben and seek medical advice.
Chem. N.: No data Skin: In case of contact with the skin wash off immediately with soap
CAS Number: No data and water. Consult a doctor if skin irritation persists.
EINECS Number: No data Inhalation: Ensure supply of fresh air. In the event of symptoms refer
for medical treatment.
2. Physical and Chemical Properties Ingestion: Rinse out mouth and give plenty of water to drink. Seek
medical advice immediately.
Melting Point: ca. 125 - 128掳C
9. Fire Fighting Measures
Boiling Point: 270 鈥? 2380掳C
Refractive Index: No data Flash Point: Not applicable
Evaporation Rate: No data Auto-ignition Temp: No data
Specific Gravity: No data Extinguishing Media: Water spray jet, dry powder, CO2, Foam DO
Solubility in Water: Difficult to dissolve NOT US Full water jet for safety reasons.
pH Value: 3-4.5 Fire Fighting Procedures: Use breathing apparatus. Special
Appearance & Odor: Crystalline, White, Odorless Exposure Hazards arising from the substance or preparation itself,
combustion products: Risk of formation of toxic pyrolysis products.
3. Stability and Reactivity 10. Toxicological Information
Chemical Stability: No data
Acute Oral LD50: (mouse) >8000 mg/kg
Incompatibility: Reactions with strong alkalis. Accumulation of fine
Dermal and Eye Irritation Test: No data
dust may entail the risk of a dust explosion in the presence of air.
Carcinogenicity: No data
Hazardous Decomposition: No hazardous decomposition products
Mutagenicity: No data
known.
Hazardous Polymerization: No data
11. Disposal Considerations
4. Handling and Storage
Disposal should be in accordance with local, state, or national legislation.
Avoid the formation and deposition of dust. Use only in well-ventilated For recycling, consult manufacturer. Dispose as of hazardous waste.
areas. Provide extraction if dust is raised. Keep only in original container. Contaminated packaging should be emptied as far as possible and after
Provide acid resistant floor. Take precautionary measures against static appropriate cleansing may be take for reuse.
discharges. Dust can form an explosive mixture with air. Keep container in
a well-ventilated place. Keep container tightly closed.
5. Accidental Release Measures
Ensure adequate ventilation. Avoid dust formation. Do not discharge
into the drains/surface, waters/groundwater. Take up mechanically. Avoid
raising dust. Dispose of absorbed material in accordance with the
regulations.
6. Exposure Controls & Personal Protection
Respiratory Protection: Breathing apparatus in event of high
concentrations. Short term: filter apparatus, Filter P1
Protective Clothing: Protective gloves, protective goggles
Other Protective Measures: Avoid contact with eyes and skin. Do
not inhale dust. Wash hands before breaks and after work. Use barrier skin
cream.
7. Hazards Identification
General: No particular hazards known. Non-Hazardous Material.
Inhalation: Non-Hazardous Material.
Eye Contact: Non-Hazardous Material.
Skin Contact: Non-Hazardous Material.
Ingestion: Non-Hazardous Material.
Important Notice: The information presented herein is based on experimental data submitted by the manufacturers
of the raw materials and is considered scientifically correct; however, no warrant or representation, express or implied, is
made as to the accuracy or suitability of this information for application to the purchaser鈥檚 intended purpose or for
consequences of its use and we assume no responsibility for any loss, damage or expense, direct or consequential, arising
out of its use. Use these materials only as directed. If you have any questions regarding the proper interpretation of this
sheet or the meanings of any terms used, we strongly urge you to speak with your physician. For further information
concerning product safety and proper use, call the number listed on the front of the MSDS.
|