AM-66
Material Safety Data Sheet
Issue Date: 10/25/02 Revision Date: 8/25/05 Supersedes: 8/25/05
Product Identification:
Manufacturer鈥檚 Name: Applied Membranes, Inc.
Address: 2325 Cousteau Ct., Vista, CA 92083-8346
Phone No.: (760) 727-3711
Emergency Phone No.: (800) 424-9300
Applied Membranes, Inc. Name: AM-66
Trade Name: Biofoulant Cleaner For CA/CTA Ro Membranes
Emergency Phone Number: For Chemical Emergency, Spill Leak Fire Exposure or
Accident - Call CHEMTREC Day or Night
DOMESTIC NORTH AMERICA 800-424-9300
INTERNATIONAL, CALL 703-527-3887 (collect calls
accepted)
Hazardous Ingredients:
Material Name/CAS no. % OSHA PEL ACGIH TLV
None
First Aid Measures:
Effects of Exposure
Ingestion: Harmful if ingested. Can cause nausea, vomiting, abdominal cramps.
Eye Contact: Can cause redness, irritation, tissue destruction; Irritant on prolonged
contact.
Skin Contact: Irritant. Can cause redness, inflammation, irritation on prolonged
contact.
Inhalation: Low acute inhalation toxicity. Mists may cause upper respiratory
tract irritation.
Emergency First Aid
Ingestion: If victim is conscious and alert, give 1-2 glasses of water to drink. Do
not give anything by mouth to an unconscious person. Seek medical
attention. Do not leave victim unattended.
Eye Contact: Hold eyelids open and flush with a steady, gentle stream of water for
at least 15 minutes. Seek immediate medical attention.
Page 1 of 3
Applied Membranes, Inc. assumes no liability for results obtained or damages incurred through the improper application of the above
information and data.
Revised 10/18/2005
AM-66 MSDS (continued)
Skin Contact: In case of contact, immediately wash with plenty of soap and water
for at least 5 minutes. Seek medical attention. Remove
contaminated clothing and shoes. Clean contaminated clothing and
shoes before re-use.
Inhalation: Inhalation is not an expected route of exposure. Remove victim from
immediate source of exposure and assure that the victim is breathing.
If breathing is difficult, administer oxygen, if available. If victim is
not breathing, administer CPR (cardio-pulmonary resuscitation). Seek
medical attention.
Fire Fighting Measures:
Flash Point/Method: > 93 掳C (200 掳F). Flammability Class: Will
Burn
Extinguishing Media: Recommended (small fires): carbon dioxide,
dry chemical. Recommended (large fire):
alcohol foam, universal foam, water spray.
Special Fire Fighting Procedures: Firefighters should wear NIOSH/MSHA
approved self-contained breathing apparatus,
and full protective clothing.
Unusual Fire and Explosion Hazards: Hazardous Decomposition Materials (under
fire conditions):
- Oxides of sulfur
- Oxides of carbon
Upper Explosive Limit (UEL): No data.
Lower Explosive Limit (LEL): No data.
Accidental Release Measures:
Spill or Leak Procedures:
Caution: Spilled material may make floor slippery. Do not leave traces of product on
floors, ladders, etc. as this may present a slipping hazard. Clean up spill using
absorbent materials such as earth, sand, or clay. Scrape up and place in appropriate
closed container. Clean up residual material by washing area with water.
Waste Disposal:
Dispose of waste in accordance with federal, state and local regulations.
Handling and Storage:
Precautions To Be Taken In Handling And Storing:
Handling:
Avoid breathing vapors and mists. Avoid direct or prolonged contact with skin and eyes.
In cold weather, this product may stratify and freeze. This does not damage the
product. If freezing occurs, thaw and remix before using. Frozen material may be
Page 2 of 3
Applied Membranes, Inc. assumes no liability for results obtained or damages incurred through the improper application of the above
information and data.
Revised 10/18/2005
AM-66 MSDS (continued)
thawed in a warm room. Avoid localized overheating. Vent drums while heating. Mix
thoroughly to ensure homogeneity.
Storage:
Store in closed containers. Store in an area that is dry, well-ventilated, away from
ignition sources, away from incompatible materials. Expected shelf life if stored at
recommended temperatures: 6 months.
Exposure Control/ Personal Protection:
Respiratory Protection: Not normally required. Use NIOSH/MSHA approved
respirator if conditions warrant.
Ventilation: Standard Industrial ventilation.
Protective Clothing: Skin contact should be minimized through use of
gloves and suitable long-sleeved clothing.
Eye Protection: Appropriate ANSI Z87 approved equipment should
be selected for the particular use intended for this
material. Use safety glasses. Have eye washes
available.
Physical and Chemical Properties:
Appearance and Odor at room temperature: Brown, liquid, odorless.
Solubility in Water: Soluble.
pH (3% soln.): 7-8.5.
Boiling Point: 100 掳C (212掳F) at 760 mmHg
Melting Point: Not applicable.
Freezing Point: Not applicable.
Vapor Pressure (mm. Hg.): < 23 mmHg @ 25 掳C (77 掳F)
Percent Volatile by Volume (%) < 78
Stability and Reactivity:
Stability: Stable.
Incompatibility: Strong oxidizing agents.
Hazardous Decomposition Products: Decomposition type: Thermal
- Oxides of sulfur
- Oxides of carbon
Hazardous Polymerization: Will not occur.
Transportation Information:
Shipping Name: NOT D.O.T. regulated.
Page 3 of 3
Applied Membranes, Inc. assumes no liability for results obtained or damages incurred through the improper application of the above
information and data.
Revised 10/18/2005
|