AQUA-RESIN庐
Material Safety Data Sheet
庐
Product Identification: Aqua-Resin S3鈩?, P, SF, G, EZG Powder Component
Aqua-Resin庐 PWC-1, SWC-2, P, EZG, 5556, 5550 Powder Additive
_______________________________________________________________________________________________________________
Section I:
Manufacturer's Name: ADM Tronics Unlimited, Inc. Emergency Phone: (201) 767-6040
Address: 224 Pegasus Avenue
Northvale, NJ 07647 Date: August 19, 2002
Supersedes all previous Material Safety Data Sheets
Section II: Composition Information, or Ingredients
Components CAS # OSHA PEL ACGIH TLV
3 3
mg/m mg/m
Proprietary Powdered Polymer 15/5 non-hazardous
Proprietary Cement 15/5 non-hazardous
Proprietary Filler 15/5 non-hazardous
Ammonium Caseinate 9005-42-9 NE NE
Gypsum 7778-18-9 15/5 10
Starch 9005-25-8 15/5 10
Proprietary Stabilizer 15/5 non-hazardous
15/5: 15 total / 5 respirable
_______________________________________________________________________________________________________________
Section III: Physical/Chemical Characteristics
Boiling Point: NA Solubility in Water: Slight
Vapor Pressure (mm Hg): NA Appearance: Powders-whitish to pink.
Vapor Density (Air=1): NA P Powder component-light tan.
Specific Gravity: .82 - 3.2 Additives - reddish brown
0
Odor: slight, agreeable
Melting Point: > 1,100 C.
Evaporation Rate NA
_______________________________________________________________________________________________________________
Section IV: Fire and Explosion Hazard Data
Not flammable when used as intended. Special Fire Fighting
None when used as intended. Method: None
LEL: NA Unusual Fire/Explosion
UEL: NA Hazard: None.
Extinguishing Media: NA
______________________________________________________________________________________________________________
Section V: Reactivity Data
Stability
Unstable: Stable: X Conditions to Avoid: Moisture
Incompatibility: Concentrated acids
Hazardous Decomposition
2 0
or Byproducts: CaO and SO , above 1400 C; others not known
Hazardous Polymerization
May Occur: Will Not Occur: X Conditions to Avoid: N/A
______________________________________________________________________________________________________________
Section VI Health Hazard Data
Routes of Entry Signs and Symptoms of Overexposure
Acute Chronic
Inhalation: When large quantities of dust are present coughing, sneezing None known
and nasal irritation may occur.
Ingestion: This product, if ingested in dry form will harden internally, as None known
it will when mixed with Aqua-Resin liquid components, or
other aqueous solutions. If ingested, consult physician.
1
S3-POWDER 041103
Rev. 5/2/06
AQUA-RESIN庐
Acute Chronic
Eyes: Irritation, if exposed to excess dust. None known
Skin: When mixed with Aqua-Resin liquid components, or None known
other aqueous solutions heat may be generated; avoid contact
with skin.
______________________________________________________________________________________________________________
Carcinogenicity:
NTP: None IARC: None OSHA: None
Medical Conditions Pre-existing upper respiratory and lung diseases.
Generally Aggravated
by Exposure:
Emergency and First Aid
Inhalation: Remove to fresh air.
Ingestion: Consult physician
Eyes: Flush with water for fifteen (15) minutes. Consult physician if irritation persists.
Skin: Rinse off with plain water.
______________________________________________________________________________________________________________
Section VII: Precautions for Safe Handling and Use
Steps to be Taken In Case
Material is Spilled or Sweep or vacuum; dispose using normal means for dry waste. Do not dispose of in drain.
Released:
Waste Disposal Method: Dispose of solid material according to local, state and federal regulations.
Precautions to be Taken in
Storing and Handling: Avoid dusting.
Avoid moisture. Once Aqua-Resin庐 powder components have been reacted with the appropriate
Other Precautions:
liquid component, cured and hardened, if sanding is necessary, wet sanding should be employed to
control dust.
CAUTION: Do not allow an Aqua-Resin庐 mix to harden on, or encase any part of the body. Doing
so, because of the heat generated, the possible expansion of the material, and the difficulty of removal
in a timely manner, may cause serious bodily injury.
______________________________________________________________________________________________________________
Section VIII: Control Measures
Respiratory Protection: Use OSHA approved dust respirator when excess dusting exists.
Ventilation
Local Exhaust: None, unless exposure limits exceeded.
Mechanical (general): None, unless exposure limits exceeded.
Special or Other: N/A
Protective gloves: For mixtures with Aqua-Resin liquids, neoprene gloves recommended
(other gloves may also be suitable).
Eye Protection: Goggles recommended under severe dusting conditions.
Other Protective Equipment
or Clothing: None
Work/Hygiene Practices: Do not eat or smoke while working with this product.
______________________________________________________________________________________________________________
Section IX: Transportation Classification US DOT Hazard Class: Not Regulated
______________________________________________________________________________________________________________
Note: NA 鈥? Not Applicable ND 鈥? Not Determined NE 鈥? Not Established
The information in this MSDS relates only to the specific materials designated, and to the specific ADM Tronics鈥? products identified in our instructions.
It does not relate to use in combination with any other materials or processes. This information is provided in good faith, and as of the date of this
document, is believed to be correct. However, ADM Tronics does not make any representation as to its accuracy or completeness. Users are advised to
make their own determination as to the suitability of this product for their particular purpose. Accordingly, ADM Tronics disclaims responsibility for
damages of any kind resulting from the use of this information.
www.aquaresin.com
2
S3-POWDER 041103
Rev. 5/2/06
|