Search   
MSDS 
:
 Methyl myristate 99%
CAS 
:
 124-10-7
SYNONYMS 
:
 Methyl tetradecanoate; Metholeneat 2495; Methyl N-tetradecanoate;     Myristic acid, methyl ester; Tetradecanoic acid, methyl ester
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 124-10-7 |Methyl myristate | 99 | 204-680-1 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
The toxicological properties of this material have not been fully
investigated.

Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Water may
be ineffective. Material is lighter than water and a fire may be
spread by the use of water. Vapors may be heavier than air. They
can spread along the ground and collect in low or confined areas.
Extinguishing Media:
This material is lighter than water and insoluble in water. The fire
could easily be spread by the use of water in an area where the water
cannot be contained. Use agent most appropriate to extinguish fire.
Use water spray, dry chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up or absorb material, then place into a
suitable clean, dry, closed container for disposal. Provide
ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Avoid contact with
eyes, skin, and clothing. Keep container tightly closed. Avoid
ingestion and inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 124-10-7:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Clear liquid
Color: colorless
Odor: honey and orris-like
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 323 deg C @ 760.00mmHg
Freezing/Melting Point: 18.4 deg C
Autoignition Temperature: Not available.
Flash Point: > 112 deg C (> 233.60 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: Insoluble.
Specific Gravity/Density: .8550g/cm3
Molecular Formula: C15H30O2
Molecular Weight: 242.40

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, strong oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 124-10-7 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Methyl myristate -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 124-10-7: 1
Canada
CAS# 124-10-7 is listed on Canada's DSL List.
CAS# 124-10-7 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 124-10-7 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 11/21/1998 Revision #2 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Potassium Iodide, 99%, Briquettes 7681-11-0
Potassium Iodide, 99.995% 7681-11-0
Palladium on carbon (10%) (50% wet with water for safety) 7440-05-3
Ruthenium(IV) Oxide, Anhydrous, 99.5+% 12036-10-1
Carbazole, 99% (UV-Vis) 86-74-8
Calcium Carbonate, 98.5% 471-34-1
Calcium Carbonate (Chips), 97% (Titr.) 471-34-1
Ethyl 2-benzylacetoacetate, 97% 620-79-1
2-(4-Nitrophenoxy)tetradecanoyl Chloride, 92% (HPLC) 116526-84-2
Calcium Carbonate, Light Powder 471-34-1
1,5-Difluoro-2,4-dinitrobenzene, 97 % 327-92-4
Calcium Carbonate, Reagent ACS (Powder), 99+% (Titr.) 471-34-1
Calcium Carbonate, P.A. (Precipitated, Heavy) 471-34-1
Calcium Carbonate, Low in Alkalies, Reagent ACS (Powder), 99+% 471-34-1
Calcium Chloride, Anhydrous Powder, 95%, P.A. 10043-52-4
Calcium Chloride Dihydrate 77 - 80% CaCl2 Flakes for Drying Purposes 10035-04-8
Calcium Chloride Dihydrate, P.A. 10035-04-8
Calcium Chloride Dihydrate, Reagent ACS 10035-04-8
Hydrochloric Acid, 0.1 N Solution 7647-01-0
Calcium Fluoride, 99%, Anhydrous 7789-75-5
Benzoyl Chloride, 99% 98-88-4
Deoxycholic acid, sodium salt, 99% 302-95-4
Methyl myristate 99% 124-10-7
Methyltriphenoxyphosphonium iodide 17579-99-6
Copper phthalocyanine-3,4',4",4"'-tetrasul fonic acid,tetrasodium 123439-80-5
Ethylenebis(oxyethylenenitrilo)tetraacetic acid, 97% 67-42-5
Ethylenebis(oxyethylenenitrilo)tetraacetic acid, 99% 67-42-5
Poly(Methyl Methacrylate), Average M.W. 15000(GPC) 9011-14-7
Poly(Methyl Methacrylate), Sec. Stand., M. W. 93300, N.N. 46400, Fine 9011-14-7
Poly(Methyl Methacrylate), Nominal M.W. 38000, Beads 9011-14-7
Poly(Methyl Methacrylate), Average M.W. 500.000 9011-14-7
Heparin Sodium 9041-08-1
Iodine, reagent ACS, 99.8% 7553-56-2
Iodine, resublimed, p.a. 7553-56-2
Iodine, 0.1N Standard Solution 7553-56-2
3,3'-Diethyloxadicarbocyanine Iodide, Laser Grade, 99% (UV-Vis) 14806-50-9
Copper (II) Chloride Dihydrate, Tech., 95% 10125-13-0
Copper (II) Chloride Dihydrate, Reagent (Powder), 99% (Titr.) 10125-13-0
Copper (II) Chloride Dihydrate, P.A. 10125-13-0
Copper (I) Chloride, 95+% 7758-89-6
Copper (I) Chloride, Purified, 99% 7758-89-6
3-Hexyn-1-ol, 98% 1002-28-4
Copper (I) Chloride, 99.99% 7758-89-6
Copper (I) Chloride, P.A. 7758-89-6
Copper (I) Chloride, Reagent ACS (Powder), 90+% (Titr.) 7758-89-6
Cyclohexane, Reagent ACS, Spectro Grade, 99+% (GC) 110-82-7
Cyclohexane, 99+% 110-82-7
Cyclohexane, P.A. 110-82-7
Cyclohexane for HPLC 110-82-7
Ammonium molybdate(VI) tetrahydrate, p.a. 12027-67-7

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net