**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 16941-11-0 |Ammonium Hexafluorophosphate | 99.5 | 241-009-1 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: C
Risk Phrases: 34
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Causes burns.Hygroscopic (absorbs moisture from the air).Corrosive.
Potential Health Effects
Eye:
Causes eye burns.
Skin:
Causes skin burns.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes
gastrointestinal tract burns.
Inhalation:
May cause severe irritation of the respiratory tract with sore
throat, coughing, shortness of breath and delayed lung edema. Causes
chemical burns to the respiratory tract.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Get medical aid immediately. Do NOT allow victim to rub eyes or keep
eyes closed. Extensive irrigation with water is required (at least 30
minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of
water for at least 15 minutes while removing contaminated clothing
and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4
cupfuls of milk or water. Never give anything by mouth to an
unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh
air immediately. If not breathing, give artificial respiration. If
breathing is difficult, give oxygen. Do NOT use mouth-to-mouth
resuscitation.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Vapors may
be heavier than air. They can spread along the ground and collect
in low or confined areas.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam. Do NOT get water inside containers.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up, then place into a suitable container for
disposal. Avoid generating dusty conditions. Provide ventilation. Do
not get water inside containers.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash hands before eating. Keep container tightly closed. Do not get
on skin or in eyes. Do not ingest or inhale. Use with adequate
ventilation. Wash clothing before reuse. Discard contaminated shoes.
Keep from contact with moist air and steam.
Storage:
Keep container closed when not in use. Store in a cool, dry,
well-ventilated area away from incompatible substances. Corrosives
area.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 16941-11-0:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to minimize
contact with skin.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Crystalline powder
Color: white
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: 198 deg C
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water: 74.8 g/100ml (20 c)
Specific Gravity/Density: 2.1800g/cm3
Molecular Formula: H4F6NP
Molecular Weight: 163.00
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat, oxidizers.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Phosphine, oxides of phosphorus, hydrogen fluoride gas, ammonia
and/or derivatives.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 16941-11-0 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Ammonium Hexafluorophosphate -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: CORROSIVE SOLID, ACIDIC, INORGANIC, N.O.S.*
Hazard Class: 8
UN Number: 3260
Packing Group: II
IMO
Shipping Name: CORROSIVE SOLID, ACIDIC, INORGANIC, N.O.S.
Hazard Class: 8
UN Number: 3260
Packing Group: II
RID/ADR
Shipping Name: CORROSIVE SOLID, ACIDIC, INORGANIC, N.O.S.
Hazard Class: 8
UN Number: 3260
Packing group: II
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 34 Causes burns.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
WGK (Water Danger/Protection)
CAS# 16941-11-0: No information available.
Canada
CAS# 16941-11-0 is listed on Canada's NDSL List.
CAS# 16941-11-0 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 16941-11-0 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 9/11/1998 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
3-Ethyl-3-methylglutaric anhydride, 97%
| 6970-57-6 |
|
2-Aminonicotinic Acid, 98%
| 5345-47-1 |
|
4,4'-Bis(Dimethylamino)Thiobenzophenone, 98% (UV-VIS)
| 1226-46-6 |
|
Benzoyl chloride-d5, 99+ atom% d
| 43019-90-5 |
|
1-Propanethiol, 98%
| 107-03-9 |
|
Diethyl Ethoxymethylenemalonate, 99+%
| 87-13-8 |
|
1,2-O-Isopropylidene-D-glucofuranose, 98%
| 18549-40-1 |
|
Podophyllotoxin, 95%(tlc)
| 518-28-5 |
|
S-Acetylthiocholine Bromide, 99%
| 25025-59-6 |
|
Ethyl p-dimethylaminobenzoate, 99+%
| 10287-53-3 |
|
1,7-Octadiyne, 99%
| 871-84-1 |
|
2,3-Dichlorobenzoic acid, 98%
| 50-45-3 |
|
1,2-O-Cyclohexylidene-Alpha-D-Xylopentodi- Aldo-1,4-Furanose, 98%
| 15356-27-1 |
|
Ethylenediaminetetraacetic acid, tetrasodium salt dihydrate
| 64-02-8 |
|
2,3,5-Trichlorophenol, 99%
| 933-78-8 |
|
(2S)-(+)-Glycidyl tosylate, 99+%
| 70987-78-9 |
|
(-)-alpha-Amino-gamma-butyrolactone hydroiodide, 98%
| 171736-85-9 |
|
alpha-Methylbenzyl cyanide, tech.
| 1823-91-2 |
|
Vinylidene chloride, 99.9%, stabilized with 200 ppm MEHQ
| 75-35-4 |
|
Dibutyl Phosphite, 96%
| 1809-19-4 |
|
Sodium phosphate monobasic dihydrate
| 7558-80-7 |
|
5-Chloro-2,4-Dimethoxyaniline, 99+%
| 97-50-7 |
|
Ascarite (II)-,CO2 Absorbent, 20-to 30 Mesh
| 81133-20-2 |
|
Tri-M-Tolyl Phosphate (Pract), 93% (GC)
| 563-04-2 |
|
2,3-Epoxypropyl 4'-methoxyphenyl ether, 99%
| 2211-94-1 |
|
O-Anisoyl Chloride, 99% (Titr.)
| 21615-34-9 |
|
1-Tridecene, 99%
| 2437-56-1 |
|
Benzoylferrocene 98%
| 1272-44-2 |
|
4-Bromophenylacetic acid, 99%
| 1878-68-8 |
|
Triphenylarsine Oxide
| 1153-05-5 |
|
Copper(i) oxide, 97%
| 1317-39-1 |
|
2-Iodopropane, 98+% stabilized over copper
| 75-30-9 |
|
Glycyrrhizic Acid, Monoammonium Salt Tri-Hydrate, 98%
| 53956-04-0 |
|
Methyl (s)-(-)-4-bromo-3-tert- butyldimethylsilyloxybutanoate
| 101703-35-9 |
|
2-Fluorobenzonitrile, 99%
| 394-47-8 |
|
3-Aminophenyl-Sulfone, 97%(TLC)
| 599-61-1 |
|
Ammonium Hexafluorophosphate, 99.5%
| 16941-11-0 |
|
2-Methyl-1-phenyl-2-propanol
| 100-86-7 |
|
Aluminum Phthalocyanine Chloride, 99% (UV-Vis)
| 14154-42-8 |
|
2-Amino-6-chloro-4-pyrimidinol hydrate, 95%
| 1194-21-4 |
|
Phenyl acetate, 97%
| 122-79-2 |
|
Oligomycin, Mixture of A, B and C
| 1404-19-9 |
|
Sodium atomic absorption standard solution, 1 mg/ml Na in 0.5N HNO3
| 7440-23-5 |
|
Bromodichloromethane, 98+%, stabilized with potassium carbonate
| 75-27-4 |
|
2,2,5-Trichloropentanal, 96%
| |
|
BOC-L-Glutamic Acid-5-Benzylester DCHA, 99.5+%
| 13574-84-0 |
|
3-Nitrophenylhydrazine hydrochloride, 98%
| 636-95-3 |
|
2,3-Dimercapto-1-propanol, 93% (GC)
| 59-52-9 |
|
4,6-Dimethyl-2-Mercaptopyrimidine, 99%
| 22325-27-5 |
|
2-Fluorobenzamide, 98%
| 445-28-3 |
|
|