**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 563-04-2 |Phosphoric Acid, Tris(3-Methylphenyl) | 93 | 209-241-8 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XN N
Risk Phrases: 21/22 51/53
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Harmful in contact with skin and if swallowed. Toxic to aquatic
organisms, may cause long-term adverse effects in the aquatic
environment.The toxicological properties of this material have not
been fully investigated.
Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Get medical aid. Do NOT induce vomiting. If conscious and alert,
rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry
chemical, carbon dioxide, or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up or absorb material, then place into a
suitable clean, dry, closed container for disposal. Provide
ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Avoid contact with
eyes, skin, and clothing. Keep container tightly closed. Avoid
ingestion and inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 563-04-2:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Clear liquid
Color: very slightly yellow to pink
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 275 deg C @ 17.00mm Hg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 210 deg C ( 410.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: insoluble
Specific Gravity/Density: 1.1600g/cm3
Molecular Formula: C21H21O4P
Molecular Weight: 368.36
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, excess heat, strong oxidants.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, oxides of phosphorus, irritating and toxic fumes and
gases, carbon dioxide.
Hazardous Polymerization: Has not been reported
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 563-04-2 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Phosphoric Acid, Tris(3-Methylphenyl) Ester -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XN N
Risk Phrases:
R 21/22 Harmful in contact with skin and if
swallowed.
R 51/53 Toxic to aquatic organisms, may cause
long-term adverse effects in the aquatic environment.
Safety Phrases:
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
S 61 Avoid release to the environment. Refer to
special instructions/safety data sheets.
WGK (Water Danger/Protection)
CAS# 563-04-2: No information available.
Canada
CAS# 563-04-2 is listed on Canada's DSL List.
CAS# 563-04-2 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 563-04-2 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 6/03/1999 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
3-Ethyl-3-methylglutaric anhydride, 97%
| 6970-57-6 |
|
2-Aminonicotinic Acid, 98%
| 5345-47-1 |
|
4,4'-Bis(Dimethylamino)Thiobenzophenone, 98% (UV-VIS)
| 1226-46-6 |
|
Benzoyl chloride-d5, 99+ atom% d
| 43019-90-5 |
|
1-Propanethiol, 98%
| 107-03-9 |
|
Diethyl Ethoxymethylenemalonate, 99+%
| 87-13-8 |
|
1,2-O-Isopropylidene-D-glucofuranose, 98%
| 18549-40-1 |
|
Podophyllotoxin, 95%(tlc)
| 518-28-5 |
|
S-Acetylthiocholine Bromide, 99%
| 25025-59-6 |
|
Ethyl p-dimethylaminobenzoate, 99+%
| 10287-53-3 |
|
1,7-Octadiyne, 99%
| 871-84-1 |
|
2,3-Dichlorobenzoic acid, 98%
| 50-45-3 |
|
1,2-O-Cyclohexylidene-Alpha-D-Xylopentodi- Aldo-1,4-Furanose, 98%
| 15356-27-1 |
|
Ethylenediaminetetraacetic acid, tetrasodium salt dihydrate
| 64-02-8 |
|
2,3,5-Trichlorophenol, 99%
| 933-78-8 |
|
(2S)-(+)-Glycidyl tosylate, 99+%
| 70987-78-9 |
|
(-)-alpha-Amino-gamma-butyrolactone hydroiodide, 98%
| 171736-85-9 |
|
alpha-Methylbenzyl cyanide, tech.
| 1823-91-2 |
|
Vinylidene chloride, 99.9%, stabilized with 200 ppm MEHQ
| 75-35-4 |
|
Dibutyl Phosphite, 96%
| 1809-19-4 |
|
Sodium phosphate monobasic dihydrate
| 7558-80-7 |
|
5-Chloro-2,4-Dimethoxyaniline, 99+%
| 97-50-7 |
|
Ascarite (II)-,CO2 Absorbent, 20-to 30 Mesh
| 81133-20-2 |
|
Tri-M-Tolyl Phosphate (Pract), 93% (GC)
| 563-04-2 |
|
2,3-Epoxypropyl 4'-methoxyphenyl ether, 99%
| 2211-94-1 |
|
O-Anisoyl Chloride, 99% (Titr.)
| 21615-34-9 |
|
1-Tridecene, 99%
| 2437-56-1 |
|
Benzoylferrocene 98%
| 1272-44-2 |
|
4-Bromophenylacetic acid, 99%
| 1878-68-8 |
|
Triphenylarsine Oxide
| 1153-05-5 |
|
Copper(i) oxide, 97%
| 1317-39-1 |
|
2-Iodopropane, 98+% stabilized over copper
| 75-30-9 |
|
Glycyrrhizic Acid, Monoammonium Salt Tri-Hydrate, 98%
| 53956-04-0 |
|
Methyl (s)-(-)-4-bromo-3-tert- butyldimethylsilyloxybutanoate
| 101703-35-9 |
|
2-Fluorobenzonitrile, 99%
| 394-47-8 |
|
3-Aminophenyl-Sulfone, 97%(TLC)
| 599-61-1 |
|
Ammonium Hexafluorophosphate, 99.5%
| 16941-11-0 |
|
2-Methyl-1-phenyl-2-propanol
| 100-86-7 |
|
Aluminum Phthalocyanine Chloride, 99% (UV-Vis)
| 14154-42-8 |
|
2-Amino-6-chloro-4-pyrimidinol hydrate, 95%
| 1194-21-4 |
|
Phenyl acetate, 97%
| 122-79-2 |
|
Oligomycin, Mixture of A, B and C
| 1404-19-9 |
|
Sodium atomic absorption standard solution, 1 mg/ml Na in 0.5N HNO3
| 7440-23-5 |
|
Bromodichloromethane, 98+%, stabilized with potassium carbonate
| 75-27-4 |
|
2,2,5-Trichloropentanal, 96%
| |
|
BOC-L-Glutamic Acid-5-Benzylester DCHA, 99.5+%
| 13574-84-0 |
|
3-Nitrophenylhydrazine hydrochloride, 98%
| 636-95-3 |
|
2,3-Dimercapto-1-propanol, 93% (GC)
| 59-52-9 |
|
4,6-Dimethyl-2-Mercaptopyrimidine, 99%
| 22325-27-5 |
|
2-Fluorobenzamide, 98%
| 445-28-3 |
|
|