**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 2114-39-8 |2-Bromo-1-Phenylpropane | 98% | 218-315-9 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.The toxicological
properties of this material have not been fully investigated.
Potential Health Effects
Eye:
No information regarding eye irritation and other potential effects
was found.
Skin:
No information regarding skin irritation and other potential effects
was found.
Ingestion:
The toxicological properties of this substance have not been fully
investigated.
Inhalation:
The toxicological properties of this substance have not been fully
investigated.
Chronic:
Not available.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid immediately. Flush skin with plenty of water for at
least 15 minutes while removing contaminated clothing and shoes.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh
air immediately. If not breathing, give artificial respiration. If
breathing is difficult, give oxygen.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors may form an explosive mixture with air.
Vapors can travel to a source of ignition and flash back.
Combustible liquid.
Extinguishing Media:
Use water fog, dry chemical, carbon dioxide, or regular foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use only in a well-ventilated area.
Ground and bond containers when transferring material. Avoid contact
with eyes, skin, and clothing. Empty containers retain product
residue, (liquid and/or vapor), and can be dangerous. Do not
pressurize, cut, weld, braze, solder, drill, grind, or expose empty
containers to heat, sparks or open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use adequate ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 2114-39-8:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: yellow
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 107 - 109 deg C @ 16.00mm Hg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 90 deg C ( 194.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: 1.2910g/cm3
Molecular Formula: C9H11Br
Molecular Weight: 199.09
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Ignition sources, excess heat, electrical sparks, exposure to flame.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong bases.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide, hydrogen bromide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 2114-39-8 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
2-Bromo-1-Phenylpropane -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 37/39 Wear suitable gloves and eye/face
protection.
WGK (Water Danger/Protection)
CAS# 2114-39-8: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 2114-39-8 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 2114-39-8 is not listed on the TSCA inventory.
It is for research and development use only.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 9/02/1997 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Tropylium Hexafluorophosphate
| 29663-54-5 |
|
3-(4-Cyanobenzoyl)-5,7-Dimethoxycoumarin
| 83179-55-9 |
|
Adenine-9-Beta-D-Arabinofuranoside- 5'-Monophosphate, 98%
| 29984-33-6 |
|
4-Tert-Butylaniline, 99%
| 769-92-6 |
|
4,4'-Dicyanobibenzyl
| |
|
Isoquinoline, 99% (GC)
| 119-65-3 |
|
(2-Naphthoxy)Acetic Acid, N-Hydroxysuccinimide Ester, 98%
| 81012-92-2 |
|
Pentafluorophenylhydrazine, 97%
| 828-73-9 |
|
Diphenyl Phosphate, 99%
| 838-85-7 |
|
Manganese(II) bromide tetrahydrate, 98%
| 10031-20-6 |
|
Sulfur trioxide, stabilized, 99%
| 7446-11-9 |
|
epsilon-Caprolactam
| 105-60-2 |
|
2-Bromo-1-Phenylpropane, 98%
| 2114-39-8 |
|
1,1-Bis(Methylseleno)-Ethane
| 56051-04-8 |
|
4-Chloro-2-methylthiopyrimidine, 98%
| 49844-90-8 |
|
4-Cyanobenzoic Acid, 99%
| 619-65-8 |
|
2,2'-Diaminobibenzyl, 96%
| 0-00-1 |
|
(-)-Dihydrocarvyl acetate, mixture of isomers, 99%
| 20777-49-5 |
|
Cyclobutanecarboxylic Acid Chloride, 99%
| 5006-22-4 |
|
4-Methoxybenzylisothiocyanate
| 3694-57-3 |
|
Bis(MSB), scintillation grade, 99.5%
| 13280-61-0 |
|
1-Octene, 97%
| 111-66-0 |
|
Bromoacetaldehyde dimethyl acetal, 97%, stabilized with 0.2%
| 7252-83-7 |
|
d-Histidine hydrochloride monohydrate 99%
| 6341-24-8 |
|
Pimelic acid, 98%
| 111-16-0 |
|
Trans-Beta-Hydromuconic Acid, 98%
| 4436-74-2 |
|
Nickel(ii) acetylacetonate dihydrate, 99+% (titr.)
| 3264-82-2 |
|
Ethyl Allophanate
| 626-36-8 |
|
2,6-Dimethylpyrazine, ca 96% (nmr), balanc e 2,5-isomer
| 108-50-9 |
|
(1,3-Dioxolan-2-ylmethyl)triphenyl phosphonium bromide, 98%
| 52509-14-5 |
|
3,3'-Thiodipropanol, 98%
| 10595-09-2 |
|
2-Imidazolidinethione, paraffinic oil coated powder
| 96-45-7 |
|
Coumarin 7, Laser Grade, 99% (UV-Vis)
| 27425-55-4 |
|
Bemegride, 99+%
| 64-65-3 |
|
DL-3(Methylthio)-2-Butanone 99%
| 53475-15-3 |
|
Methyl (trimethylsilyl)acetate, 98%
| 2916-76-9 |
|
3-Methylindole, 98%
| 83-34-1 |
|
Titanium(IV) isopropoxide, 98+%
| 546-68-9 |
|
2-Hydroxy-4,5-Dimethylacetophenone, 98%
| 36436-65-4 |
|
Allyl sulfide, 97%
| 592-88-1 |
|
Dehydroacetic acid, 98%
| 520-26-3 |
|
Lactulose, 50 Wt% Solution in Water
| 4618-18-2 |
|
Ethylene/propylene copolymer, low molecular weight
| 9010-79-1 |
|
D-(+)-Altrose, 99%
| 1990-29-0 |
|
Ftorafur, 99%
| 17902-23-7 |
|
L(-)-Perillaldehyde, 90% (Titr.)
| 18031-40-8 |
|
3-Amino-5-Methylisoxazole, 98+%
| 1072-67-9 |
|
Yttrium atomic absorption standard solution, 1 mg/ml Y in 2% HNO3
| 7440-65-5 |
|
1,6-Dibromo-2-Naphthol, 99%
| 16239-18-2 |
|
4,4'-Dimethoxytrityl chloride 98%
| 40615-36-9 |
|
|