Search   
MSDS 
:
 Perfluoro(methylcyclohexane), 96%
CAS 
:
 355-02-2
SYNONYMS 
:
 Cyclohexane, Undecafluoro(trifluoromethyl)-.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 355-02-2 |Perfluoro(methylcyclohexane) | 96 | 206-573-5 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
The toxicological properties of this material have not been fully
investigated.

Potential Health Effects
Eye:
No information regarding eye irritation and other potential effects
was found.
Skin:
No information regarding skin irritation and other potential effects
was found.
Ingestion:
The toxicological properties of this substance have not been fully
investigated.
Inhalation:
The toxicological properties of this substance have not been fully
investigated.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Vapors may
be heavier than air. They can spread along the ground and collect
in low or confined areas. Runoff from fire control or dilution water
may cause pollution.
Extinguishing Media:
Use agent most appropriate to extinguish fire.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Clean up spills immediately,
observing precautions in the Protective Equipment section. Provide
ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Use with adequate ventilation. Avoid
contact with eyes, skin, and clothing. Keep container tightly closed.
Avoid ingestion and inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 355-02-2:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: clear, colorless
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 76 deg C @ 760.00mmHg
Freezing/Melting Point: - 37.00 - - 0.00 deg
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: 1.7880g/cm3
Molecular Formula: C7F14
Molecular Weight: 350.04

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, strong oxidants.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide, hydrogen fluoride gas.
Hazardous Polymerization: Has not been reported

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 355-02-2: GV7610000
LD50/LC50:
Not available.
Carcinogenicity:
Perfluoro(methylcyclohexane) -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 355-02-2: No information available.
Canada
CAS# 355-02-2 is listed on Canada's NDSL List.
CAS# 355-02-2 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 355-02-2 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 1/27/1998 Revision #3 Date: 2/07/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Dichlorodimethylsilane, 99% 75-78-5
2-Mesitylenesulfonyl Chloride, 99% 773-64-8
5-Norbornen-2-ol (mixture of endo and exo), 99% 13080-90-5
1,3-Dithiane, 97% 505-23-7
Alpha-D-Cellobiose Octaacetate 5346-90-7
4-Bromobiphenyl, 99% 92-66-0
1,2,3-Heptanetriol 103404-57-5
1-Bromononane, 97% 693-58-3
2-Vinylnaphthalene, 98% Stabilized with 0.4% P-Tert.-Butylcatechol 827-54-3
4-Nitrophenylhydrazine, 10-18% water added, 95% 100-16-3
2-Methyl-1-pentene, 99% 763-29-1
2,5-Dimethylanisole, 99% 1706-11-2
1-Decene, 95% 872-05-9
Methyl s-(-)-lactate, 98% 27871-49-4
3,5-Dibromo-O-Phenylenediamine Mono- Hydrochloride, 99% 75568-11-5
2'-Methylacetophenone, 98% 577-16-2
Ethyl 1-piperidineacetate, 98+% 23853-10-3
1,1,4,4-Tetraphenyl-1,3-Butadiene, Scintillation Grade, 99+% 1450-63-1
3-Chloropropanesulfonyl Chloride, 96% 1633-82-5
Nigrosine, water soluble 8005-03-6
Platinum(ii) iodide, 98.5% 7790-39-8
n-Benzyltropinone, 96% (tlc) 28957-72-4
Acetonylacetone, 97% 110-13-4
(1,4'-Bipiperidine)-4'-carboxamide, 99+% 39633-82-4
Tetraethyleneglycol Monomethyl Ether, 98% (GC) 23783-42-8
Metaldehyde 108-62-3
n-Butyl vinyl ether, 98% 111-34-2
Poly(Alpha-Methylstyrene) 25014-31-7
Copper(II) acetylacetonate, 99% 13395-16-9
Perfluoro(methylcyclohexane), 96% 355-02-2
4-Bromo-2-Fluorophenol, 98% 2105-94-4
2,4-Hexadienoic acid 110-44-1
4-Octyloxyaniline, 98% (Titr.) 39905-45-8
D(+)-galacturonic acid monohydrate, 99% 685-73-4
1,3,3-Trimethoxypropene, 96% (GC), Cis/Trans Mixture: 20/80, 17576-35-1
Sodium Omadine , 40% Aqueous Solution 3811-73-2
Dibenzothiophene sulfone, 97% 1016-05-3
Ethyl 3-Pyridylacetate, 99% 39931-77-6
Iodoacetamide, 98% 144-48-9
Sodium nitroferricyanide dihydrate, reagent ACS, crystals 13755-38-9
1,3-Propane sultone, 99% (gc) 1120-71-4
2-Bromo-4'-methoxyacetophenone, 98% 2632-13-5
2-Thiopheneglyoxylic acid, 97% 4075-59-6
2-Chloro-4-Fluorobenzylcyanide, 99+% 75279-56-0
2-Acetylthiazole, 99% 24295-03-2
2-(Trifluoromethyl)-phenothiazine, 97% 92-30-8
m-Anisic acid, 98% 586-38-9
2-(N-Butylperfluorooctanesulfonamido)ethyl acrylate, stabilized, 77% 383-07-3
3,4-Dichlorobenzaldehyde, 98% 6287-38-3
Silver Vanadate, 98% (Titr.) 13497-94-4

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net