Search   
MSDS 
:
 Sodium Omadine , 40% Aqueous Solution
CAS 
:
 3811-73-2
SYNONYMS 
:
 N-Hydroxy-2-Pyridinethione, Sodium Salt, Monohydrate;     2-Pyridinethiol-1-Oxide, sodium salt, monohydrate.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 3811-73-2 |Sodium Omadine | | 223-296-5 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 22 36/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Harmful if swallowed. Irritating to eyes and skin.Hygroscopic
(absorbs moisture from the air).Stench.

Potential Health Effects
Eye:
Causes eye irritation. May cause chemical conjunctivitis.
Skin:
Causes skin irritation.
Ingestion:
May cause irritation of the digestive tract.
Inhalation:
May cause respiratory tract irritation.
Chronic:
Effects may be delayed.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Vapors may
be heavier than air. They can spread along the ground and collect
in low or confined areas. Runoff from fire control or dilution water
may cause pollution.
Extinguishing Media:
Use water spray to cool fire-exposed containers. Do NOT get water
inside containers. Use water spray, dry chemical, carbon dioxide, or
appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Avoid runoff into storm sewers and ditches which lead to waterways.
Clean up spills immediately, observing precautions in the Protective
Equipment section. Absorb spill using an absorbent, non-combustible
material such as earth, sand, or vermiculite. Do not use combustible
materials such as sawdust. Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Avoid contact with eyes, skin, and clothing. Keep
container tightly closed. Avoid ingestion and inhalation. Use with
adequate ventilation.
Storage:
Keep container closed when not in use. Store in a cool, dry,
well-ventilated area away from incompatible substances. Store
protected from moisture.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use process enclosure,
local exhaust ventilation, or other engineering controls to control
airborne levels.
Exposure Limits
CAS# 3811-73-2:

Germany: 1 mg/m3 TWA
Germany: Skin absorber
Netherlands: 1 mg/m3 MAC

Personal Protective Equipment

Eyes:
Wear safety glasses and chemical goggles if splashing
is possible.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: clear colorless to almost colorless
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: > 260 deg C
Autoignition Temperature: Not available.
Flash Point: 482 deg F ( 250.00 deg C)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: soluble
Specific Gravity/Density:
Molecular Formula: C5H4NaNOS.H2O
Molecular Weight: 167.15

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, excess heat, strong oxidants, exposure to
moist air or water.
Incompatibilities with Other Materials:
Moisture, oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, oxides of sulfur, irritating and
toxic fumes and gases, carbon dioxide, nitrogen.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 3811-73-2: UT9000000
LD50/LC50:
CAS# 3811-73-2: Oral, mouse: LD50 = 870 mg/kg.
Carcinogenicity:
Sodium Omadine -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****

Ecotoxicity:
Water flea Daphnia: EC50 = 0.022 mg/L; 48 Hr.; Unspecified

**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 22 Harmful if swallowed.
R 36/38 Irritating to eyes and skin.
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 3811-73-2: No information available.
Canada
CAS# 3811-73-2 is listed on Canada's DSL List.
CAS# 3811-73-2 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 3811-73-2 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 7/07/1999 Revision #5 Date: 3/04/2004

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Dichlorodimethylsilane, 99% 75-78-5
2-Mesitylenesulfonyl Chloride, 99% 773-64-8
5-Norbornen-2-ol (mixture of endo and exo), 99% 13080-90-5
1,3-Dithiane, 97% 505-23-7
Alpha-D-Cellobiose Octaacetate 5346-90-7
4-Bromobiphenyl, 99% 92-66-0
1,2,3-Heptanetriol 103404-57-5
1-Bromononane, 97% 693-58-3
2-Vinylnaphthalene, 98% Stabilized with 0.4% P-Tert.-Butylcatechol 827-54-3
4-Nitrophenylhydrazine, 10-18% water added, 95% 100-16-3
2-Methyl-1-pentene, 99% 763-29-1
2,5-Dimethylanisole, 99% 1706-11-2
1-Decene, 95% 872-05-9
Methyl s-(-)-lactate, 98% 27871-49-4
3,5-Dibromo-O-Phenylenediamine Mono- Hydrochloride, 99% 75568-11-5
2'-Methylacetophenone, 98% 577-16-2
Ethyl 1-piperidineacetate, 98+% 23853-10-3
1,1,4,4-Tetraphenyl-1,3-Butadiene, Scintillation Grade, 99+% 1450-63-1
3-Chloropropanesulfonyl Chloride, 96% 1633-82-5
Nigrosine, water soluble 8005-03-6
Platinum(ii) iodide, 98.5% 7790-39-8
n-Benzyltropinone, 96% (tlc) 28957-72-4
Acetonylacetone, 97% 110-13-4
(1,4'-Bipiperidine)-4'-carboxamide, 99+% 39633-82-4
Tetraethyleneglycol Monomethyl Ether, 98% (GC) 23783-42-8
Metaldehyde 108-62-3
n-Butyl vinyl ether, 98% 111-34-2
Poly(Alpha-Methylstyrene) 25014-31-7
Copper(II) acetylacetonate, 99% 13395-16-9
Perfluoro(methylcyclohexane), 96% 355-02-2
4-Bromo-2-Fluorophenol, 98% 2105-94-4
2,4-Hexadienoic acid 110-44-1
4-Octyloxyaniline, 98% (Titr.) 39905-45-8
D(+)-galacturonic acid monohydrate, 99% 685-73-4
1,3,3-Trimethoxypropene, 96% (GC), Cis/Trans Mixture: 20/80, 17576-35-1
Sodium Omadine , 40% Aqueous Solution 3811-73-2
Dibenzothiophene sulfone, 97% 1016-05-3
Ethyl 3-Pyridylacetate, 99% 39931-77-6
Iodoacetamide, 98% 144-48-9
Sodium nitroferricyanide dihydrate, reagent ACS, crystals 13755-38-9
1,3-Propane sultone, 99% (gc) 1120-71-4
2-Bromo-4'-methoxyacetophenone, 98% 2632-13-5
2-Thiopheneglyoxylic acid, 97% 4075-59-6
2-Chloro-4-Fluorobenzylcyanide, 99+% 75279-56-0
2-Acetylthiazole, 99% 24295-03-2
2-(Trifluoromethyl)-phenothiazine, 97% 92-30-8
m-Anisic acid, 98% 586-38-9
2-(N-Butylperfluorooctanesulfonamido)ethyl acrylate, stabilized, 77% 383-07-3
3,4-Dichlorobenzaldehyde, 98% 6287-38-3
Silver Vanadate, 98% (Titr.) 13497-94-4

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net