**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 36653-82-4 |1-Hexadecanol | 90 | 253-149-0 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.
Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea.
Inhalation:
Causes irritation of mucous membrane. Causes upper respiratory tract
irritation.
Chronic:
Prolonged or repeated skin contact may cause dermatitis.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Immediately flush skin with plenty of water for at
least 15 minutes while removing contaminated clothing and shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4
cupfuls of milk or water. Never give anything by mouth to an
unconscious person. Get medical aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors can travel to a source of ignition and flash
back. During a fire, irritating and highly toxic gases may be
generated by thermal decomposition or combustion. Vapors may be
heavier than air. They can spread along the ground and collect in
low or confined areas.
Extinguishing Media:
Use dry chemical, carbon dioxide, or alcohol-resistant foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up, then place into a suitable container for
disposal. Avoid generating dusty conditions.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use with adequate ventilation. Avoid
contact with eyes, skin, and clothing. Avoid ingestion and
inhalation.
Storage:
Keep away from heat, sparks, and flame. Keep container closed when
not in use. Store in a cool, dry, well-ventilated area away from
incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use adequate general or local exhaust ventilation to keep airborne
concentrations below the permissible exposure limits.
Exposure Limits
CAS# 36653-82-4:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Crystals
Color: white
Odor: faint odor
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 334 deg C @ 15.00mm
Freezing/Melting Point: 49.3 deg C
Autoignition Temperature: Not available.
Flash Point: > 110 deg C (> 230.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: Insoluble.
Specific Gravity/Density: 0.8120 @ 50C/4C
Molecular Formula: C16H34O
Molecular Weight: 242.45
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong acids.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide, acrid smoke and fumes.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 36653-82-4: MM0225000
LD50/LC50:
CAS# 36653-82-4: Draize test, rabbit, eye: 82 mg Mild; Draize test,
rabbit, skin: 2600 mg/24H Mild; Draize test, rabbit, skin: 100
mg/24H Severe; Oral, mouse: LD50 = 3200 mg/kg; Oral, rat: LD50 = 5
gm/kg; Skin, rabbit: LD50 = >2600 mg/kg.
Carcinogenicity:
1-Hexadecanol -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 36/37/39 Wear suitable protective clothing, gloves
and eye/face protection.
WGK (Water Danger/Protection)
CAS# 36653-82-4: 0
Canada
CAS# 36653-82-4 is listed on Canada's DSL List.
CAS# 36653-82-4 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 36653-82-4 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 3/10/1998 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
1-Aminobenzimidazole-2-sulfonic acid, 99%
| 120341-04-0 |
|
Cytochalasin E
| 36011-19-5 |
|
n-Methyl-2-phenylacetamide
| 6830-82-6 |
|
D(+)-cellobiose, 98%
| 528-50-7 |
|
Ammonium tetrachloropalladate(ii)
| 13820-40-1 |
|
Phenylacetylene, 98%
| 536-74-3 |
|
Polyoxyethylene Non-Ionic Detergents Kit
| 0-01-1 |
|
Nitric acid-d, 68 wt. % solution in d2o, 99+ atom % d
| 13587-52-5 |
|
4-Vinylbenzyl Alcohol, Tech. 85% (GC), Stabilized with 0.1%
| 1074-61-9 |
|
3-Amino-3-phenyl-1-propanol, 94%
| 14593-04-5 |
|
2-Methyl-1,3-cyclopentanedione, 98%
| 765-69-5 |
|
5-Nitroso-2,4,6-triaminopyrimidine
| 1006-23-1 |
|
2-Chlorostyrene, 99%, stabilized with 0.1% tert-butylcatechol
| 98-29-3 |
|
1-Heptanesulfonic Acid Sodium Salt
| 22767-50-6 |
|
(1S,3S)-3-Acetyl-2,2-dimethylcyclobutane acetonitrile, 98%, mixt.
| 28353-00-6 |
|
7-(Trifluoromethyl)-4-quinolinol, 97%
| 322-97-4 |
|
1-Hexanesulfonic acid sodium salt
| 2832-45-3 |
|
4-Allylanisole, 98%
| 140-67-0 |
|
Nylon 6
| 25038-54-4 |
|
l(+)-Tartaric acid, diammonium salt, 99%
| 3164-29-2 |
|
Benzyldimethylphenylammonium chloride, monohydrate, 98% (titr.)
| 3204-68-0 |
|
5-Azacytosine
| 931-86-2 |
|
3-Ethylthio-1,2-Propanediol, 97%
| 60763-78-2 |
|
3-Isopropoxypropylamine, 98+%
| 2906-12-9 |
|
Potassium Tetrafluoroborate, C.P.
| 14075-53-7 |
|
Dl-methylsuccinic acid, 99%
| 498-21-5 |
|
Tetrachloro-1,4-Benzoquinone (Pract.)
| 118-75-2 |
|
3-(4-Methoxyphenoxy)Benzaldehyde, 95%
| 62373-80-2 |
|
Ethyl Oxamate, 99%
| 617-36-7 |
|
Terbium Trifluoride, 99.5%
| 13708-63-9 |
|
1-Hexadecanol, 90% (gc)
| 36653-82-4 |
|
1-Naphthol >98%
| 90-15-3 |
|
Iron(iii) acetylacetonate, 99+%
| 14024-18-1 |
|
Ethyl (methylthio)acetate, 95%
| 4455-13-4 |
|
3,4-Dihydroxy-1,5-hexadiene, 98%, mixture of DL and Meso, stab. with
| 1069-23-4 |
|
4-Tert.-butylcyclohexanone, 99%
| 98-53-3 |
|
Montmorillonite ksf
| 1318-93-0 |
|
Ethyl 2-(bromomethyl)acrylate, 97%
| 17435-72-2 |
|
2-Chloro-5-Nitrobenzophenone, 99%
| 34052-37-4 |
|
3-Chloro-6-methoxypyridazine, 97%
| 1722-10-7 |
|
Diethyl Cyanomethylphosphonate, 96%
| 2537-48-6 |
|
(Chloromethyl)-Triphenylphosphonium Chloride, Tech., 95%(Titr.)
| 5293-84-5 |
|
3,3-Dimethylacryloyl Chloride, 97%
| 3350-78-5 |
|
1-Pentanesulfonic Acid Sodium Salt
| 22767-49-3 |
|
2,2-Difluorotetrachloroethane, 97%
| 76-11-9 |
|
4-Chloro-3-methylanisole, 99%
| 13334-71-9 |
|
Poly(ethylenimine), 50wt% aq. solution, average m.w. 50-60.000
| 7732-18-5 |
|
Mesitaldehyde, 98%
| 487-68-3 |
|
Poly(caprolactone) triol
| 54735-63-6 |
|
D,l-Arabinose, 98%
| 20235-19-2 |
|
|