**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 536-74-3 |Phenylacetylene | 98.0 | 208-645-1 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: F
Risk Phrases: 10
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Flammable.The toxicological properties of this material have not
been fully investigated.
Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
None
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid if irritation develops or persists. Flush skin with
plenty of soap and water.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid.
Inhalation:
Remove from exposure and move to fresh air immediately. Get medical
aid if cough or other symptoms appear.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
Containers can build up pressure if exposed to heat and/or fire. As
in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors may form an explosive mixture with air.
Vapors can travel to a source of ignition and flash back. Flammable
liquid and vapor. Vapors may be heavier than air. They can spread
along the ground and collect in low or confined areas.
Extinguishing Media:
For small fires, use water spray, dry chemical, carbon dioxide or
chemical foam. For large fires, use water spray, fog or
alcohol-resistant foam. Do NOT use straight streams of water.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Remove all sources of ignition.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use with adequate ventilation.
Ground and bond containers when transferring material. Avoid contact
with eyes, skin, and clothing. Empty containers retain product
residue, (liquid and/or vapor), and can be dangerous. Keep container
tightly closed. Keep away from heat, sparks and flame. Avoid
ingestion and inhalation. Do not pressurize, cut, weld, braze,
solder, drill, grind, or expose empty containers to heat, sparks or
open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use adequate ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 536-74-3:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: clear yellow
Odor: None reported.
pH: Not available.
Vapor Pressure: 17.6 mmHg @ 37.
Viscosity: Not available.
Boiling Point: 142 deg C @ 760.00m
Freezing/Melting Point: -45 deg C
Autoignition Temperature: Not available.
Flash Point: 31 deg C ( 87.80 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: insoluble
Specific Gravity/Density: .9300g/cm3
Molecular Formula: C8H6
Molecular Weight: 102.14
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, strong oxidants.
Incompatibilities with Other Materials:
Acids - oxidizing agents - halogens - alkali metals, perchloric acid.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide.
Hazardous Polymerization: May occur.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 536-74-3: DA0780000
LD50/LC50:
Not available.
Carcinogenicity:
Phenylacetylene -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: FLAMMABLE LIQUID, N.O.S.*
Hazard Class: 3
UN Number: 1993
Packing Group: III
IMO
Shipping Name: FLAMMABLE LIQUID, N.O.S.
Hazard Class: 3.3
UN Number: 1993
Packing Group: III
RID/ADR
Shipping Name: FLAMMABLE LIQUID, N.O.S.
Hazard Class: 3
UN Number: 1993
Packing group: III
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: F
Risk Phrases:
R 10 Flammable.
Safety Phrases:
S 16 Keep away from sources of ignition - No
smoking.
WGK (Water Danger/Protection)
CAS# 536-74-3: No information available.
Canada
CAS# 536-74-3 is listed on Canada's DSL List.
CAS# 536-74-3 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 536-74-3 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 9/02/1997 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
1-Aminobenzimidazole-2-sulfonic acid, 99%
| 120341-04-0 |
|
Cytochalasin E
| 36011-19-5 |
|
n-Methyl-2-phenylacetamide
| 6830-82-6 |
|
D(+)-cellobiose, 98%
| 528-50-7 |
|
Ammonium tetrachloropalladate(ii)
| 13820-40-1 |
|
Phenylacetylene, 98%
| 536-74-3 |
|
Polyoxyethylene Non-Ionic Detergents Kit
| 0-01-1 |
|
Nitric acid-d, 68 wt. % solution in d2o, 99+ atom % d
| 13587-52-5 |
|
4-Vinylbenzyl Alcohol, Tech. 85% (GC), Stabilized with 0.1%
| 1074-61-9 |
|
3-Amino-3-phenyl-1-propanol, 94%
| 14593-04-5 |
|
2-Methyl-1,3-cyclopentanedione, 98%
| 765-69-5 |
|
5-Nitroso-2,4,6-triaminopyrimidine
| 1006-23-1 |
|
2-Chlorostyrene, 99%, stabilized with 0.1% tert-butylcatechol
| 98-29-3 |
|
1-Heptanesulfonic Acid Sodium Salt
| 22767-50-6 |
|
(1S,3S)-3-Acetyl-2,2-dimethylcyclobutane acetonitrile, 98%, mixt.
| 28353-00-6 |
|
7-(Trifluoromethyl)-4-quinolinol, 97%
| 322-97-4 |
|
1-Hexanesulfonic acid sodium salt
| 2832-45-3 |
|
4-Allylanisole, 98%
| 140-67-0 |
|
Nylon 6
| 25038-54-4 |
|
l(+)-Tartaric acid, diammonium salt, 99%
| 3164-29-2 |
|
Benzyldimethylphenylammonium chloride, monohydrate, 98% (titr.)
| 3204-68-0 |
|
5-Azacytosine
| 931-86-2 |
|
3-Ethylthio-1,2-Propanediol, 97%
| 60763-78-2 |
|
3-Isopropoxypropylamine, 98+%
| 2906-12-9 |
|
Potassium Tetrafluoroborate, C.P.
| 14075-53-7 |
|
Dl-methylsuccinic acid, 99%
| 498-21-5 |
|
Tetrachloro-1,4-Benzoquinone (Pract.)
| 118-75-2 |
|
3-(4-Methoxyphenoxy)Benzaldehyde, 95%
| 62373-80-2 |
|
Ethyl Oxamate, 99%
| 617-36-7 |
|
Terbium Trifluoride, 99.5%
| 13708-63-9 |
|
1-Hexadecanol, 90% (gc)
| 36653-82-4 |
|
1-Naphthol >98%
| 90-15-3 |
|
Iron(iii) acetylacetonate, 99+%
| 14024-18-1 |
|
Ethyl (methylthio)acetate, 95%
| 4455-13-4 |
|
3,4-Dihydroxy-1,5-hexadiene, 98%, mixture of DL and Meso, stab. with
| 1069-23-4 |
|
4-Tert.-butylcyclohexanone, 99%
| 98-53-3 |
|
Montmorillonite ksf
| 1318-93-0 |
|
Ethyl 2-(bromomethyl)acrylate, 97%
| 17435-72-2 |
|
2-Chloro-5-Nitrobenzophenone, 99%
| 34052-37-4 |
|
3-Chloro-6-methoxypyridazine, 97%
| 1722-10-7 |
|
Diethyl Cyanomethylphosphonate, 96%
| 2537-48-6 |
|
(Chloromethyl)-Triphenylphosphonium Chloride, Tech., 95%(Titr.)
| 5293-84-5 |
|
3,3-Dimethylacryloyl Chloride, 97%
| 3350-78-5 |
|
1-Pentanesulfonic Acid Sodium Salt
| 22767-49-3 |
|
2,2-Difluorotetrachloroethane, 97%
| 76-11-9 |
|
4-Chloro-3-methylanisole, 99%
| 13334-71-9 |
|
Poly(ethylenimine), 50wt% aq. solution, average m.w. 50-60.000
| 7732-18-5 |
|
Mesitaldehyde, 98%
| 487-68-3 |
|
Poly(caprolactone) triol
| 54735-63-6 |
|
D,l-Arabinose, 98%
| 20235-19-2 |
|
|