Search   
MSDS 
:
 Aluminum, rods, 99.999%
CAS 
:
 7429-90-5
SYNONYMS 
:
 
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 7429-90-5 |Aluminum | 99.999 | 231-072-3 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Moisture sensitive.Air sensitive.

Potential Health Effects
Eye:
Causes eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract.
Inhalation:
Causes respiratory tract irritation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Antidote:
None reported.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Do NOT use water directly on fire. Use dry chemical to fight fire.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Minimize dust generation and
accumulation. Avoid contact with eyes, skin, and clothing. Keep
container tightly closed. Avoid ingestion and inhalation. Use with
adequate ventilation.
Storage:
Do not store near combustible materials. Store in a tightly closed
container. Store in a cool, dry, well-ventilated area away from
incompatible substances. Keep away from acids.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Good general ventilation should be sufficient to control airborne
levels.
Exposure Limits
CAS# 7429-90-5:
United Kingdom, WEL - TWA: 10 mg/m3 TWA (inhalable dust); 4 mg/m3
(respirable dust)
United Kingdom, WEL - STEL: 30 mg/m3 STEL (inhalable dust); 12 mg
STEL (respirable dust)
United States OSHA: 15 mg/m3 TWA (total dust); 5 mg/m3 TWA
(respirable fraction)
Belgium - TWA: 10 mg/m3 VLE (metal); 5 mg/m3 VLE (fume)
France - VME: 10 mg/m3 VME (metal); 5 mg/m3 VME (dust)
Japan: 0.5 mg/m3 OEL (respirable dust); 2 mg/m3 OEL (total dust)
Malaysia: 10 mg/m3 TWA (metal dust)
Netherlands: 10 mg/m3 MAC
Russia: 2 mg/m3 TWA
Spain: 10 mg/m3 VLA-ED (dust)

Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Solid
Color: silver
Odor: Odorless.
pH: Not available.
Vapor Pressure: 1 mm Hg @ 1284 deg
Viscosity: Not available.
Boiling Point: 2327 deg C
Freezing/Melting Point: 660 deg C
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water: Soluble in hot water.
Specific Gravity/Density: 2.7020g/cm3
Molecular Formula: Al
Molecular Weight: 26.97

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, exposure to air, exposure to moist air or
water.
Incompatibilities with Other Materials:
Oxidizing agents, acids, halogens, sodium hydroxide, acid chlorides.
Hazardous Decomposition Products:
Aluminum oxide.
Hazardous Polymerization: Has not been reported

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 7429-90-5: BD0330000 BD1020000
LD50/LC50:
Not available.
Carcinogenicity:
Aluminum -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****

Ecotoxicity:
Fish toxicity: LC50 (4 wk) rainbow trout 0.56 mg/l.
Lowest observed
effective concentration (3 wk) longnose sucker, brook trout 0.1 and
0.2 mg/l, respectively.
Yolk fry of Atlantic salmon exposed to 135
??g/l at pH 5 and 1C for +/- 30 day caused +/- 6% mortality.
Acidification increased aluminum accumulation but +/- 60% of
aluminum was absorbed by the fish body surface and was lost early
during depuration.
Invertebrate toxicity: Asellus aquaticus LC50
(48-96 hr): 6.57-4.37 mg/l specific toxicological reaction to
mobility.
Daphnia magna EC50 (48 hr): 1.4 mg/l.

**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 7429-90-5: 0
Canada
CAS# 7429-90-5 is listed on Canada's DSL List.
CAS# 7429-90-5 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 7429-90-5 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 9/21/1998 Revision #3 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
alpha-Bromo-3-iodo-4-nitrotoluene, 97% 214279-41-1
Aluminum, rods, 99.999% 7429-90-5
Triphenylarsine, 97% 603-32-7
2-Nitrophenylacetylene, 97% 16433-96-8
Ethyl 3,5-Bis(Trifluoromethyl)Benzoate, 97% 96617-71-9
Pentafluorophenoxyacetic Acid, 97% 14892-14-9
Acetonitrile 75-05-8
Pentafluorophenoxyacetyl Chloride, 97% 55502-53-9
Methyl 4-Amino-3-Chlorobenzoate, 97% 84228-44-4
Acetic acid, ammonium salt, anhydrous, p.a. 631-61-8
1-Iodo-2-methylpropane, 97%, stabilized with copper 513-38-2
4-Chloro-2-Methyl-6-Nitroaniline, 97% 62790-50-5
Ammonium hydrogen difluoride, technical grade, crystalline 1341-49-7
Ammonium Bromide, P.A. 12124-97-9
Ammonium Carbonate, P.A. 506-87-6
3,3'-Diethyloxatricarbocyanine Iodide, Laser Grade, 99% (UV-Vis) 15185-43-0
(3R-cis)-7a-Methyl-3-phenyltetrahydropyrrolo-[2,1-b]oxazol-5(6H)-one 137869-70-6
(3R-cis)-3,7a-Diphenyltetrahydropyrrolo-[2,1-b]oxazol-5(6H)-one 132959-39-8
Ammonium Chloride, P.A. 12125-02-9
(3S-Cis)-(-)-3-Phenyltetrahydropyrrolo-[2,1-B]Oxazol-5(6H)-One 122383-34-0
(3R-Cis)-(-)-3-Phenyltetrahydropyrrolo-[2,1-B]Oxazol-5(6H)-One, 97% 133007-27-9
Ammonium dichromate, 99% 7789-09-5
Acetophenone 98-86-2
Ammonium Fluoride, Reagent ACS 12125-01-8
Ammonium Formate, 99% (titr.) 540-69-2
Copper (II) Ethyl Acetoacetate, 99% (Titr.) 14284-06-1
Ethyl Acetate, ECD Tested for Pesticide Analysis 141-78-6
Methyl alcohol, ECD tested for pesticide analysis 67-56-1
n-Pentane, ECD tested for pesticide analysis 109-66-0
Water 7732-18-5
N-Hexane, ECD Tested for Pesticide Analysis, Residue <0.0003% 110-54-3
n-Heptane, ECD tested for pesticide analysis, sulfur low, 99.4+% 108-87-2
epsilon-Caprolactone monomer 502-44-3
Acetone, ECD Tested Halocarbons Free Grade 67-64-1
Petroleum Ether 40-60, ECD Tested Halocarbons Free Grade 8032-32-4
Petroleum Ether 40-60, ECD Tested Lindane/ DDT < 5 ng/l, Residue 8032-32-4
N-Acetyl-DL-Penicillamine, 98% 59-53-0
2-Bromophenylhydrazine Hydrochloride, 95% 50709-33-6
Acetone, Tested for Trace Analysis of Polyaromatic Hydrocarbons 67-64-1
Dichloromethane, Tested for Trace Analysis of Polyaromatic 75-09-2
n-Heptane, tested for trace analysis of polyaromatic hydrocarbons 108-87-2
Ammonium hydroxide water solution, >14N NH4OH (>25% as ammonia, NH3) 1336-21-6
N-Hexane, Tested for Trace Analysis of Polyaromatic Hydrocarbons 110-54-3
Petroleum Ether 40-60, Tested for Trace Analysis of Polyaromatic 8032-32-4
Ammonium Persulfate, Reagent ACS, (Crystals), 98+% (Titr.) 7727-54-0
Ammonium Dihydrogen Phosphate, P.A. 7722-76-1
Acetone, Extra Dry, Water <50 ppm 67-64-1
sec-Butyllithium, 1.3m solution in cyclohexane/hexane (92/8) 598-30-1
Chloroform, Extra Dry, Water <50 ppm 67-66-3
Ammonium Phosphate, Dibasic, Reagent ACS (Powder) 7783-28-0

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net