**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 766-09-6 |1-Ethylpiperidine | 99 | 212-161-6 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: F C
Risk Phrases: 11 22 34
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Highly flammable. Harmful if swallowed. Causes burns.
Potential Health Effects
Eye:
Causes eye irritation. Low vapor concentrations may cause a
temporary visual disturbance known as 'blue haze' or 'halo vision'.
May cause chemical conjunctivitis and corneal damage.
Skin:
Causes skin irritation. May cause dermatitis. May cause cyanosis of
the extremities.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. Ingestion of large amounts may cause CNS depression.
Inhalation:
Causes respiratory tract irritation. Aspiration may lead to
pulmonary edema. Vapors may cause dizziness or suffocation. May
cause burning sensation in the chest.
Chronic:
Effects may be delayed.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid immediately. Do NOT induce vomiting. If conscious and alert,
rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh
air immediately. If not breathing, give artificial respiration. If
breathing is difficult, give oxygen.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors may form an explosive mixture with air.
Vapors can travel to a source of ignition and flash back. During a
fire, irritating and highly toxic gases may be generated by thermal
decomposition or combustion. Will burn if involved in a fire. Use
water spray to keep fire-exposed containers cool. Containers may
explode in the heat of a fire. Flammable liquid and vapor. Vapors
may be heavier than air. They can spread along the ground and
collect in low or confined areas.
Extinguishing Media:
For small fires, use dry chemical, carbon dioxide, water spray or
alcohol-resistant foam. For large fires, use water spray, fog, or
alcohol-resistant foam. In case of fire, use water, dry chemical,
chemical foam, or alcohol-resistant foam. Use water spray to cool
fire-exposed containers. Water may be ineffective. Use agent most
appropriate to extinguish fire. Do NOT use straight streams of
water. Use water spray, dry chemical, carbon dioxide, or appropriate
foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Remove all sources of ignition.
Use a spark-proof tool. Provide ventilation. A vapor suppressing
foam may be used to reduce vapors.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Use only in a well-ventilated area. Ground and bond containers when
transferring material. Use spark-proof tools and explosion proof
equipment. Avoid contact with eyes, skin, and clothing. Empty
containers retain product residue, (liquid and/or vapor), and can be
dangerous. Keep container tightly closed. Keep away from heat,
sparks and flame. Avoid ingestion and inhalation. Wash clothing
before reuse. Do not pressurize, cut, weld, braze, solder, drill,
grind, or expose empty containers to heat, sparks or open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
Flammables-area.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate general or
local explosion-proof ventilation to keep airborne levels to
acceptable levels.
Exposure Limits
CAS# 766-09-6:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Clear liquid
Color: clear, colorless
Odor: None reported.
pH: Not available.
Vapor Pressure: 40 hPa @ 50 C
Viscosity: Not available.
Boiling Point: 131 deg C @ 760.00mm Hg
Freezing/Melting Point: Not available.
Autoignition Temperature: 230 deg C ( 446.00 deg F)
Flash Point: 19 deg C ( 66.20 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: Not available.
Solubility in water: 40 g/l (27 c)
Specific Gravity/Density: .8240g/cm3
Molecular Formula: C7H15N
Molecular Weight: 113.20
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Ignition sources, excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents, acids, acid chlorides, carbon dioxide.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, carbon dioxide, nitrogen.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 766-09-6: TN0250000
LD50/LC50:
CAS# 766-09-6: Draize test, rabbit, eye: 50 mg/5M.
Carcinogenicity:
1-Ethylpiperidine -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: 1-ETHYLPIPERIDINE
Hazard Class: 3 (8)
UN Number: 2386
Packing Group: II
IMO
Shipping Name: 1-ETHYLPIPERIDINE
Hazard Class: 3.2 (8)
UN Number: 2386
Packing Group: II
RID/ADR
Shipping Name: 1-ETHYLPIPERIDINE
Hazard Class: 3
UN Number: 2386
Packing group: II
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: F C
Risk Phrases:
R 11 Highly flammable.
R 22 Harmful if swallowed.
R 34 Causes burns.
Safety Phrases:
S 9 Keep container in a well-ventilated place.
S 16 Keep away from sources of ignition - No
smoking.
S 27 Take off immediately all contaminated clothing.
S 33 Take precautionary measures against static
discharges.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 766-09-6: 1
Canada
CAS# 766-09-6 is listed on Canada's DSL List.
CAS# 766-09-6 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 766-09-6 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 9/02/1997 Revision #5 Date: 10/18/2002
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Manganese(IV) Oxide, 99+%, -100 Mesh
| 1313-13-9 |
|
Manganese (II) Sulfate Monohydrate, P. A.
| 10034-96-5 |
|
D-(+)-Mannitol, 98%
| 69-65-8 |
|
D-Mannitol, Reagent ACS
| 69-65-8 |
|
Mercuric acetate, 98%
| 1600-27-7 |
|
Mercury(II) chloride, p.a.
| 7487-94-7 |
|
Mercury (II) Nitrate Monohydrate, P.A.
| 7783-34-8 |
|
Mercury (II) Oxide, Red, 99%
| 21908-53-2 |
|
Mercury (II) Oxide, Yellow
| 21908-53-2 |
|
Mercury (II) Sulfate, 99+%
| 7783-35-9 |
|
Furan, stabilized with 0.025 to 0.04% BHT, 98%
| 110-00-9 |
|
Dimethyl maleate, 96%
| 624-48-6 |
|
Furan
| 110-00-9 |
|
Mercury, 99.999%
| 7439-97-6 |
|
4,4'- Methylenebis-(n,n-dimethylaniline) 99+% (titr.)
| 101-61-1 |
|
2-Methoxyethanol, spectrophotometric grade, 99+%
| 109-86-4 |
|
Methyl cellulose (viscosity: ca 15 cP(2% solution in water))
| 9004-67-5 |
|
5-Amino-1H-Tetrazole Monohydrate, 99%
| 4418-61-5 |
|
Rhenium Heptasulfide, 99%
| 12038-67-4 |
|
4-Methyl-2-Pentanone, 99.5%
| 108-10-1 |
|
Glutaric acid, 99%
| 110-94-1 |
|
4-Methyl-2-Pentanone, P.A.
| 108-10-1 |
|
4-Methyl-2-pentanone
| 108-10-1 |
|
Methyl methacrylate, 99%, stabilized with 10 - 20 ppm MEHQ
| 80-62-6 |
|
1-Ethylpiperidine, 99%
| 766-09-6 |
|
Methyl P-Hydroxybenzoate, 99%
| 99-76-3 |
|
Hydrazine hydrate, 80% (Hydrazine, 51%)
| 302-01-2 |
|
Methyl Red, indicator, p.a.
| 493-52-7 |
|
Methyl Salicylate, 98%
| 119-36-8 |
|
Dichloromethane, stabilized with amylene
| 75-09-2 |
|
Dichloromethane, 99.8%, Spectr. Grade, Stab. With 50 ppm Amylene
| 75-09-2 |
|
Dichloromethane for HPLC, Stabilized With 50 ppm Amylene
| 75-09-2 |
|
Dichloromethane, >99% (GC)
| 75-09-2 |
|
Dichloromethane, Reagent ACS, 99.5% (GC)
| 75-09-2 |
|
Dichloromethane, Reagent ACS, Spectro Grade, 99.5% (GC)
| 75-09-2 |
|
Aniline-2-sulfonic acid, tech., 83%
| 88-21-1 |
|
Ninhydrin, spectrophotometric grade
| 485-47-2 |
|
Cineole, 99%
| 470-82-6 |
|
Phenyl isothiocyanate
| 103-72-0 |
|
Sodium phosphate, monobasic, monohydrate, p.a.
| 7558-80-7 |
|
Morpholine, 99+%
| 110-91-8 |
|
N-Amyl Acetate, 98%
| 628-63-7 |
|
Tetrabutylammonium Phosphate, HPLC Grade, 99% (Titr.)
| 5574-97-0 |
|
n-Butyl acetate, 99+%
| 123-86-4 |
|
4'-Hydroxy-2'-methylacetophenone, 97%
| 875-59-2 |
|
1-Butanol, 99%
| 71-36-3 |
|
1-Bromobutane, 99%
| 109-65-9 |
|
1-Chlorobutane, 99+%
| 109-69-3 |
|
Normal-Butylamine, 99.5% (GC)
| 109-73-9 |
|
3,5-Diiodo-l-tyrosine,dihydrate, 99%
| 300-39-0 |
|
|