MATERIAL SAFETY DATA SHEET
Prepared according to 29 CFR 1910.1200
N/A = Not applicable Revised 1/15/03
SECTION 1 - PRODUCT IDENTIFICATION Splash (eyes): Flush immediately with large amounts of water for at least 15
minutes, lifting upper and lower eyelids occasionally. Take to a physician for
medical treatment.
Trade Name: Safecoat AcryGlaze
Splash (skin): Remove with soap and water. Remove contaminated clothing.
Product I.D.# & Color: 1007 Clear
Supply copious amounts of fresh water to the skin areas to rinse material away.
Product Class: Waterborne Acrylic Polymer Emulsion
Ingestion (Swallowing): Consult with physician, hospital emergency room, or
Supplier's Name: American Formulating & Manufacturing
poison control center immediately. Only if conscious, give 2 glasses of water to
Telephone #: (619) 239-0321 Fax # 619-239-0565
drink.
Address: 3251 Third Avenue, San Diego, CA 92103
Notes to Physician: Any treatment that might be required for overexposure
Emergency Phone (MSDS Information): (619) 239-0321 or (562) 693-0872
should be directed at the control of symptoms and the clinical conditions.
D.O.T. Emergency Phone Number: (562) 693-0872
US DOT Hazard Shipping Class: Not regulated - aqueous
D.O.T. Labels/Placards Required: No SECTION 6 - REACTIVITY DATA
OSHA Class: 29CFR 1910.1200 Non-hazardous
SARA TITLE III Emergency & Community Right to Know: Stability: Stable, however avoid temperatures above 177掳C/350掳F, the onset of
Section 311/312 Categorizations (40 CFR 370): Not a hazardous chemical polymer decomposition.
Section 313 Information (40 CFR 372): This product does not contain a chemical Incompatibility (materials to avoid): Avoid materials that are water reactive,
which is listed in Section 313 above de minimis concentrations. highly alkaline or highly acidic.
Hazardous Decomposition by-products: Burning, including when heated by
SECTION 2 鈥? INGREDIENTS welding or cutting, will produce smoke, carbon monoxide and low molecular
weight organic compounds may be formed.
Hazardous Polymerization: Will not occur.
Water CAS #: 7732-18-5 Weight Percent: 65 鈥? 70
Acrylic Polymer Emulsion CAS #: Mixture Weight Percent: 20 鈥? 25 Conditions to Avoid: Excess heat may cause containers to rupture. Avoid
Vapor Pressure 24 mm Hg @ 77 F temperatures below 45掳F or freezing conditions.
Modified Acrylic Vinyl Emulsion CAS #: Mixture Weight Percent:
10 鈥? 15 SECTION 7 - SPILL, DISPOSAL PROCEDURES; ENVIRONMENTAL DATA
Aqueous Acrylic Emulsion CAS #: Mixture Weight Percent: < 3%
Vapor Pressure 17 mm Hg @ 68 F Steps to be taken in case material is released or spilled: Confine in small
area; contain and remove with inert absorbent (sand, earth, etc.). Place in proper
Suspected Cancer Agents: Federal OSHA: No NTP: NO IARC: No None container for proper disposal. CAUTION - Keep out of waterways, drains, sewers
known. by diking. Keep spectators away. Floor may be slippery. Use care to avoid
HMIS Codes: H-1 F-0 R-0 P-B falling.
Waste Disposal Method: Place contaminated material in suitable sealed metal
SECTION 3 - PHYSICAL DATA containers for disposal. Do not incinerate closed containers. Use non leaking
containers, seal tightly and label properly. Do not pour contaminated paint back
Physical Description: Liquid into unused paint. Do not throw liquid paint into the trash. Where allowed by
Boiling Range:......................................................................100 C/212 F local laws (check with local regulatory agencies) allow liquid waste materials to
Melting Point: .......................................................................N/A dry out before disposing into trash containers. Take all liquid unused paint that
Vapor Density:......................................................................Heavier than air cannot be used to approved recycling centers, paint roundups, or county facilities
% Volatile by Volume: ..........................................................83.80 that are approved to take unused paint at collection sites. Contact state, county,
% Volatile by Weight:鈥︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹??..83.42 city health services or fire departments to find nearest collection centers. Do not
LBS/GAL Theoretical: ..........................................................8.51 +or- .15 dispose of waste into water streams or storm water sewers. Do not mix with
Solubility in Water: ...............................................................Dilutable other kinds of waste. Dispose all waste in accordance with local, state and
Vapor Pressure, mmHg @ 20degC: ....................................N/A federal regulations.
Evaporation Rate:.................................................................Slower than ether RCRA Classification: As produced, this product is not a waste. If discarded as
VOC Material:.......................................................................9 g/l, 0.08 lb./gal is, it is not classified a 鈥淗azardous鈥? waste under RCRA. This product is not
VOC Material less H20: ......................................................54 g/l, 0.45 lb./gal ignitable, corrosive, reactive, or toxic; therefore is not defined as hazardous by the
Specific Gravity (H20 = 1):鈥︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹?︹??.1.02 EPA.
Environmental Hazards: None known.
SECTION 4 - FIRE & EXPLOSION HAZARD DATA
SECTION 8 - SPECIAL PROTECTION INFORMATION
Flash Point: 212掳F
Flammable limits in air, volume % - lower LEL: N/A Upper UEL: N/A Respiratory Protection: If applied by spraying, use an appropriate, properly
Fire Extinguishing Media: Water, carbon dioxide, dry chemical fitted NIOSH/MSHA approved respirator to remove spray mist. Good room
Personal Protective Equipment: Self-contained breathing apparatus (pressure- (mechanical) ventilation should be sufficient protection against vapors from
demand MSHA/NIOSH approved or equivalent) and full protective gear may be product. If further protection is desired or if persons are sensitive to vapors, use
worn if desired, but not necessary for normal use. a respirator with a NIOSH/MSHA approval number TC-23C-860 or TC-23C-87 or
Autoignition Temp.: N/A an equivalent. Refer to OSHA 29 CFR 1910.134, 鈥淩espiratory Protection鈥?.
Ventilation: General (mechanical) room ventilation is expected to be
Special Fire Fighting Procedures: Use water (fog) to cool closed containers.
satisfactory.
Wear self contained breathing apparatus.
Protective Gloves: None required under most conditions. If protection is
Unusual Fire & Explosion Hazards: Closed containers may explode due to the
desired, plastic, nitrile or latex rubber will provide adequate protection.
build up of steam pressure when exposed to extreme heat. Material can splatter
Eye Protection: Safety glasses or goggles with side shields if splashing may
above 100掳C/212掳F. Polymer film can burn.
occur. Use goggles when spraying, ANSI Z87.1 or approved equivalent.
Other Protection: Eye wash or copious amounts of water as a precautionary
SECTION 5 - HEALTH HAZARD INFORMATION & FIRST AID
measure is suggested. Other equipment not likely to be needed.
Threshold Limit Value: See Section 2 for hazardous ingredient information
SECTION 9 - STORAGE & SPECIAL HANDLING
Symptoms of Overexposure
Symptoms and Effects of Short Term Exposure: Acute. Primary route of
Storage Temperature: Min. 45degF - Max. 120degF/Indoor and outdoor = OK
entry:
This product should be stored at room temperature to prolong shelf life. Keep
Swallowing: May cause gastrointestinal irritation, nausea, vomiting and
containers in a cool, dry place. Avoid subjecting this product to extreme
diarrhea.
temperature variations and freezing. Adverse conditions can cause emulsion
Inhalation: Inhalation-spray mists may cause mild respiratory irritation.
coagulation.
Eye Contact: Liquid splashed into the eye may cause transient eye
KEEP CONTAINER CLOSED. KEEP OUT OF REACH OF CHILDREN. DO
irritation.
Skin Absorption: None known. NOT TAKE INTERNALLY. DO NOT GET IN EYES. IF PRODUCT IS
Symptoms and Effects of Repeated Overexposure: Chronic - None known. SPRAYED, PREVENT PROLONGED OR REPEATED BREATHING OF SPRAY
Medical Conditions Generally Aggravated by Exposure: None known. MIST. USE ADEQUATE VENTILATION WHEN USING THIS PRODUCT. USE
Emergency & First Aid Procedures: GOOD HYGIENE PRACTICES AND WASH AFTER USING PRODUCT.
Inhalation: Remove from exposure. Provide plenty of fresh air.
NOTICE: The data and recommendations presented herein are based upon our
research and the research of others, and are believed to be accurate. No
guarantee of their accuracy is made, however, and the product discussed is
distributed without warranty, expressed or implied, and the person receiving such
product shall make his own determination of the suitability thereof for his
particular purpose. The use of this information and the conditions and use of this
product are controlled by the user, and it is the responsibility and obligation of the
user to determine the conditions of safe use of this product. If persons using this
product are chemically sensitive, a test for personal tolerance is recommended.
|