METAFLOW
Page 1 of 4
January 4, 2007
MSDS Preparation Date:
MATERIAL SAFETY DATA SHEET
SECTION I - PRODUCT IDENTIFICATION
Product Name : METAFLOW
Pre/Co-Injection Embalming Chemical
Product Use :
Mixture.
Chemical Family :
Supplier鈥檚 name and address: Manufacturer鈥檚 name and address:
The Dodge Chemical Company (Canada) Ltd. Refer to Supplier
1265 Fewster Drive
Mississauga, Ontario, Canada
L4W 1A2
(905) 625 0311
(613) 996-6666 (CANUTEC) : This product is not a WHMIS
24 Hr. Emergency Tel # : WHMIS CLASS
controlled product in Canada.
SECTION II - HAZARDOUS INGREDIENTS
LD50 mg/kg
LC50(4hr)
(Rat, ihl.)
Ingredients CAS # Wt.% (Oral, rat) (Rabbit, dermal)
21,800
Propylene glycol N/Av
10.0 - 30.0
57-55-6 20,800
14,500
Dimethyl sulfoxide > 1600 mg/m3
1.0 - 5.0
67-68-5 N/Av
SECTION III - PHYSICAL DATA
Clear liquid. Slightly
Physical state :
viscous.
faint spice odour
Odour :
pink
:
Appearance
N/Av : 9.5 - 10.5
Odour threshold : pH
: 1.025 - 1.035
98 - 100掳C (208 - 212掳F)
Boiling point : Specific gravity
N/Av
Melting/Freezing point : Coefficient of water/oil distribution
: N/Av
: Complete
Vapour pressure (mmHg @ 20掳 C / 68掳 F) Solubility in water
: N/Av
>1
Vapour density (Air = 1) : Evaporation rate (n-Butyl acetate = 1)
: <1
96
Volatiles (% by weight) :
SECTION IV - FIRE AND EXPLOSION DATA
Fire hazards/conditions of flammability
: Not flammable under normal conditions of use. However, may ignite if exposed to
extreme heat and flame.
: > 93掳C (> 200掳F)
Flash point
: TCC : N/Av
Flash point Method Auto-ignition temperature
Upper flammable limit (% by vol.)
Lower flammable limit (% by vol.)
N/Av : N/Av
:
Use media suitable to the surrounding fire such as water fog or fine spray,
:
Means Of Extinction
alcohol foams, carbon dioxide and dry chemical.
Explosion data: Sensitivity to mechanical impact / static discharge
: Not expected to be sensitive to mechanical impact or static discharge.
Special fire-fighting procedures/equipment
: Firefighters should wear proper protective equipment and self contained breathing
apparatus with full face piece operated in positive pressure mode. Move containers
from fire area if safe to do so. Water spray may be useful in cooling equipment
exposed to heat and flame. Avoid spreading burning liquid with water spray used for
cooling purposes.
METAFLOW
Page 2 of 4
January 4, 2007
MSDS Preparation Date:
Unusual Fire and Explosion Hazards
Vapours are heavier than air and collect in confined and low-lying areas. Closed
:
containers may rupture if exposed to excess heat or flame due to a build-up of internal
pressure.
Hazardous combustion products
Carbon oxides; formaldehyde; organic sulfides; Sulphur oxides.
:
SECTION V - REACTIVITY DATA
Stable under the recommended storage and handling conditions prescribed. Dimethyl
Stability and reactivity :
sulfoxide decomposes slowly above 189掳C, forming methanethiol, formaldehyde,
water, bis(methylthilo)methane, dimethyl disulfide, dimethyl sulfone, dimethyl sulfide,
sulfur dioxide and other chemicals. Hazardous polymerisation does not occur.
Avoid excessive heat, sparks and open flame.
Conditions of reactivity :
Strong acids, alkalies, and oxidizers.
Incompatible materials :
Hazardous decomposition products
None known, refer to hazardous combustion products in Section 4.
:
SECTION VI - TOXICOLOGICAL PROPERTIES
*** Routes of exposure and acute/chronic effects ***
Exposure Limits
OSHA PEL
ACGIH TLV
TWA STEL PEL STEL
Ingredients
Propylene glycol *10 mg/m3 N/Av N/Av N/Av
Dimethyl sulfoxide N/Av N/Av N/Av
250 ppm (AIHA
WEEL)
*Note: The ACGIH TLV listed above for Propylene glycol is an AIHA WEEL.
: Skin contact; Eye contact; Ingestion; Inhalation.
Routes of exposure
: Mild eye irritant. Mild skin irritant.
Irritancy
Potential Acute Health Effects
Inhalation May cause irritation to upper respiratory system.
:
Harmful effects are not expected under normal usage. With lengthy exposures, may
Skin :
be absorbed and cause garlic-like breath and central nervous system effects.
Eyes : Mild stinging, redness, watering, and mucous discharge.
May cause irritation of mouth, throat, and stomach. Ingestion of large amounts may
Ingestion :
cause nausea, vomiting, diarrhea, as well as depression of the central nervous
system.
Prolonged skin contact may cause dermatitis (rash), characterized by red, dry, itching
Effects of Chronic Exposure :
skin.
No components are listed as carcinogens by ACGIH, IARC, OSHA or NTP.
Carcinogenicity :
Not expected to have other reproductive effects.
Reproductive effects :
: Not expected to be a teratogen.
Teratogenicity
: Not expected to be mutagenic in humans.
Mutagenicity
: Not expected to be a skin or respiratory sensitizer.
Sensitization to material
: Dimethyl sulfoxide may significantly enhance the absorption of numerous chemicals
Synergistic materials
and drugs.
Medical Conditions Aggravated By Overexposure
: None known or reported by the manufacturer.
SECTION VII - FIRST AID
Remove exposed person to fresh air if adverse effects, such as breathing difficulty
Inhalation :
arise. Obtain medical attention if symptoms develop and persist.
Immediately flush with plenty of water, while removing contaminated clothing. If
Skin contact :
irritation or symptoms develop, seek medical attention. Wash contaminated clothing
before re-use.
Immediately flush eye(s) with plenty of water. If irritation persists, seek prompt
Eye contact :
medical attention.
METAFLOW
Page 3 of 4
January 4, 2007
MSDS Preparation Date:
: Do NOT induce vomiting. If conscious, give the victim plenty of water to drink.
Ingestion
Never give anything by mouth to an unconscious person. Consult a physician.
SECTION VIII - PREVENTIVE MEASURES
Individuals involved in the cleanup must wear appropriate personal protective
Spill response/cleanup :
equipment. Remove all sources of ignition. Ventilate area of release. Stop the spill at
source if it is safe to do so. Contain and absorb spilled material with inert,
non-combustible absorbent material, such as sand. Place absorbent material in a
suitable, closed and labelled container for later disposal (see below). Ensure spilled
product does not enter drains, sewers, waterways, or confined spaces. Notify the
appropriate authorities as required.
Handle according to recommendations listed below. Improper disposal can cause
Methods of Disposal :
damage to the environment. Dispose of in accordance with federal, provincial and
local hazardous waste laws.
*** PROTECTIVE EQUIPMENT ***
Ventilation and engineering measures
: None required under normal conditions. Provide sufficient ventilation to keep vapour
concentration below the given TLV and/or PEL.
: Use in a well ventilated area. If the TLV is exceeded, a NIOSH/MSHA-approved
Respiratory protection
respirator is advised. Advice should be sought from respiratory protection
specialists.
: Gloves impervious to the material are recommended. Advice should be sought from
Skin protection
glove suppliers.
: None required when used as intended. If splashing might occur, wear eye protection
Eye / face protection
such as safety glasses with side shields.
An eyewash station and safety shower should be made available in the immediate
Other protective equipment :
working area. Depending on conditions of use, an impervious apron should be worn.
*** STORAGE & HANDLING ***
Wear chemically resistant protective equipment during handling. Do not inhale vapour
Safe Handling procedures :
or mist. Avoid contact with skin, eyes and clothing. Keep away from heat and sources
of ignition. Keep away from acids and other incompatibles. Keep containers closed
when not in use. Wash thoroughly after handling.
Store in a cool, dry, well-ventilated area. Store away from incompatible materials.
Storage requirements :
Storage area should be clearly identified, clear of obstruction and accessible only to
trained and authorized personnel. Inspect periodically for damage or leaks.
Special Shipping Information
Packing
Regulatory
Group
UN Number Shipping Name Class
Information Label
Not regulated
None Not regulated.
TDG none
None.
TDG
Additional
information
SECTION IX - PREPARATION INFORMATION
METAFLOW
Page 4 of 4
January 4, 2007
MSDS Preparation Date:
ACGIH: American Conference of Governmental Industrial Hygienists
Legend :
AIHA: American Industrial Hygiene Association
CAS: Chemical Abstract Services
IARC: International Agency for Research on Cancer
Inh: Inhalation
MSHA: Mine Safety and Health Administration
N/Ap: not applicable
N/Av: not available
NTP: National Toxicology Program
NIOSH: National Institute of Occupational Safety and Health
OSHA: Occupational Safety and Health Administration
PEL: Permissible exposure limit
STEL: Short Term Exposure Limit
TCC: Tagliabue Closed Cup
TDG: Canadian Transportation of Dangerous Goods Act & Regulations
TLV: Threshold Limit Values
TWA: Time Weighted Average
WEEL: Workplace Environmental Exposure Level
WHMIS: Workplace Hazardous Materials Identification System
1. ACGIH, Threshold Limit Values and Biological Exposure Indices for 2006.
References :
2. International Agency for Research on Cancer Monographs, searched 2006.
3. Canadian Centre for Occupational Health and Safety, CCInfoWeb databases,
2006 (Chempendium and RTECs).
4. Material Safety Data Sheet from manufacturer.
January 4, 2007
Preparation Date: :
Prepared by:
The Dodge Chemical Company (Canada) Ltd.
1265 Fewster Drive
Mississauga, Ontario, Canada L4W 1A2
Phone (905) 625 0311
http://www.dodgeco.com
END OF DOCUMENT
|