MATERIAL SAFETY DATA SHEET
TEMPCO ELECTRIC HEATER CORP.
607 N. CENTRAL AVE.
WOOD DALE, IL 60191
PRODUCT NAME: TEMPCO CML10010 SILICONE MOLD RELEASE
EMERGENCY TELEPHONE: 800-535-5053 REVISION DATE: 01-01-04
INFORMATION TELEPHONE: 630-350-2252 PRODUCT NUMBER: CML10010
FAX NUMBER: 630-350-0232
PREPARED BY: R. SACHS
SECTION I. IDENTIFICATION
CHEMICAL NAME: DIMETHYLPOLYSILOXANE
CHEMICAL FAMILY: SILICONE
FORMULA: 53126
SYNONYMS: ECONO-MIST
DOT HAZARD CLASSIFICATION: ORM-D
DOT SHIPPING MANE: CONSUMER COMMODITY
CHEMICAL ABSTRACT REGISTRY NUMBER: N/A , MIXTURE
IDENTIFICATION NUMBER: NONE
H.M.I.S. RATING: 1,3,0,B
SECTION II. PHYSICAL DATA
BOILING POINT: N/A
FREEZING POINT: <050鈥橣.
SPECIFIC GRAVITY (H20 =1): .81
WEIGHT PER GALLON @ 60 F.: 6.79
VAPOR PRESSURE @ 70 F. (MM HG): N/A
VAPOR DENSITY (AIR = 1): N/A
SOLUBILITY IN WATER, % BY WT.: NOT SOLUBLE
PERCENT VOLATILE BY WEIGHT: 97
EVAPORATION RATE (MINUTES): N/A
APPEARANCE AND ODOR: CLEAR, OILY, COLORLESS LIQUID, SLIGHT ETHEREAL ODOR.
SECTION III. HAZARDOUS INGREDIENTS
MATERIAL: APPROX. WEIGHT %: CAS NUMBER: PEL(OSHA)
DIMETHYLPOLYSILOXANE 1-5 63148-62-9 N/A
DIMETHYL ETHER 55-65 115-10-6 1000
1,2 DIFLUOROETHANE 15-20 75-37-6 1000
1,1,1,-CHLORODIFLUROETHANE 15-20 75-68-3 1000 PPM
ALL COMPONENTS OF THIS PRODUCT ARE LISTED ON THE TSCA DIRECTORY
SECTION IV. FIRE AND EXPLOSION HAZARD DATA
FLAMMABLE LIMITS IN AIR: LEL: UEL: (VOLUME %)
FLASH POINT: N/A
AEROSOL FLAME PROJECTION TEST: 18鈥? FLAME PROJECTION AS DETERMINED BY THE AEROSOL
FLAME PROJECTION TEST.
EXTINGUISHING MEDIA: DRY CHEMICAL, CO2, FOAM
SPECIAL FIRE FIGHTING PROCEDURES: SELF CONTAINED BREATHING APPARATUS
UNUSUAL FIRE & EXPLOSION HAZARDS: AEROSOLS MAY RUPTURE VIOLENTLY AT TEMPERATURES
ABOVE 120 DEGREES F.
SECTION V. REACTIVITY DATA
STABILITY: STABLE
INCOMPATIBILITY (MATERIALS TO AVOID): POWDERED OR ALKALINE EARTH METALS
HAZARDOUS COMBUSTION BY-PRODUCTS: HF AND OTHER FLUORINE COMPOUNDS
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR
CONDITIONS TO AVOID: OPEN FLAMES AND HIGH TEMPERATURES
MATERIAL SAFETY DATA SHEET TEMPCO ELECTRIC HEATER CORP. PAGE 2
CML10010
SECTION VI. HEALTH HAZARD DATA
THRESHOLD LIMIT VALUE: 1000 PPM
*EFFECTS OF OVEREXPOSURE*
INGESTION (SWALLOWING): N/A
INHALATION: EXVESSIVE INHALATION CAN PRODUCE DIZZINESS, NAUSEA, AND HEADACHE.
SKIN CONTACT: CONCENTRATED SPRAY MAY CAUSE FREEZING OF SKIN AREA
EYE CONTACT: TEMPORARY IRRITATION
*EMERGENCY AND FIRST AID PROCEDURES*
SKIN: WASH WITH SOAP AND WATER
INHALATION: REMOVE TO FRESH AIR LOCATION
EYES: FLUSH WITH PLENTY OF WATER, CALL PHYSICIAN
SECTION VII. SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: REMOVE LEAKING CONTAINER TO
OUTSIDE DISPOSAL SITE.
WASTE DISPOSAL METHOD: EMPTY FULLY, INCLUDING GAS PRESSURE. DO NOT PUNCTURE OR
INCINERATE. CAN BE RECYCLED OR ALTERNATIVELY REMOVED TO A SANITARY LANDFILL IN
MOST LOCALITIES. CHECK APPLICABLE REGULATIONS.
SECTION VIII. SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION (SPECIFY TYPE): NOT NEEDED WITH ADEQUATE VENTILATION.
VENTILATION: ADEQUATE VENTILATION NEEDED.
PROTECTIVE GLOVES: RECOMMENDED BUT NOT REQUIRED.
EYE PROTECTION: PROPER EYE CARE SHOULD BE PRACTICED IN ALL INDUSTRIAL OPERATIONS.
OTHER PROTECTIVE EQUIPMENT: AS YOUR COMPANY REQUIRES.
SECTION IX. SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: STORE INDOORS AWAY FROM DIRECT
SUNLIGHT, BELOW 120鈥橣. DO NOT DROP, PUNCTURE, OR INCINERATE. CONTAINS 142b, A
SUBSTANCE WHICH CAN HARM PUBLIC HEALTH AND THE ENVIRONMENT BY DESTROYING OZONE
IN THE UPPER ATMOSPHERE. DESTRUCTION OF THE OZONE LAYER CAN LEAD TO INCREASED
ULTRAVIOLET RADIATION WHICH, WITH EXVESS EXPOSURE TO SUNLIGHT, CAN CAUSE AN
INCREASE IN SKIN CANCER AND EYE CATARACTS.
OTHER PRECAUTIONS: DO NOT SPRAY DIRECTLY INTO FLAME. DO NOT SMOKE WHILE USING
PRODUCT. DO NOT SPRAY ON FLOORS.
SECTION X. CARCINOGENIC HAZARD
NO COMPONENT IN THIS PRODUCT HAS BEEN LISTED AS A CARCINOGEN BY IARU, N.T.P., OSHA OR
ACGIH.
SECTION X. CARCINOGENIC HAZARD
THIS DATA IS OFFERED IN GOOD FAITH AS TYPICAL VALUES AND NOT AS A PRODUCT
SPECIFICATION. NO WARRANTY, EXPRESS OR IMPLIED, IS HEREBY MADE. THE RECOMMENDED
INDUSTRIAL HYGIENE AND SAFE HANDLING PROCEDURES ARE BELIEVED TO BE GENERALLY
APPLICABLE. HOWEVER, EACH USER SHOULD REVIEW THESE RECOMMENDATIONS IN THE
SPECIFIC CONTEXT OF THE INTENDED USE, AND DETERMINE WHETHER THEY ARE APPROPRIATE .
THE INFORMATION CONTAINED IN THIS MATERIAL SAFETY DATA SHEET IS BELIEVED TO BE
CORRECT AS OF THIS DATE. THE REGULATIONS PROMULGATED BY OSHA FOR HAZARD
COMMUNICATION, 20 CFR 1910.1200, AS WELL S SEVERAL STATE AND LOCAL LAWS AND
REGULATIONS, HAVE BEEN CONSULTED IN PREPARING THIS M.S.D.S.
|