UNITED 286
MATERIAL SAFETY DATA SHEET
LABORATORIES 320 37th Avenue 鈥? St. Charles, Illinois 60174 鈥? To Reorder, Call 800-323-2594
PRODUCT IDENTIFICATION USE / DESCRIPTION REVISION DATE FOR MEDICAL AND
August 10, 2007
UNITED 286 Instant Soldering Paste TRANSPORTATION EMERGENCIES:
QUICKSILVER INFOTRAC: 800-535-5053
HEALTH (0 = Maximum Safety) REACTIVITY (0 = Maximum Safety)
1 0
Always follow Label Directions and Cautions. Susceptible to Release of Energy.
4 Extreme. 3 High. 2 Moderate. 1 Slight. 0 Minimal. 4 May detonate-vacate area if 2 Violent chemical change
Materials are exposed to fire. possible-use hose stream
See Health Hazard Data Section of this M.S.D.S.
3 Strong shock of heat may from distance
for more detailed information. detonate-use monitors from 1 Unstable if heated-use
behind explosion resistant precaution.
FLAMMABILITY (0 = Maximum Safety) barriers. 0 Normally stable.
1
Susceptibility of Material to Burning.
4 Extremely flammable. 1 Must be preheated to burn.
PERSONAL
3 Ignites at normal temperature. 0 Will not burn.
PROTECTION
2 Ignites when moderately heated.
HAZARDOUS COMPONENTS
IDENTITY, EXPOSURE LIMITS AND S.A.R.A. TITLE III INFORMATION
HAZARDOUS CAS ACGIH ACGIH OSHA OTHER S.A.R.A. TITLE III
COMPONENTS NUMBER TWA STEL PEL RECOMMENDED LIMITS QUANTITIES
2 mg/m 3 2 mg/m 3
Tin 7440-31-5 Not None None
established
100 ug/m 3 100 ug/m 3
Silver 7440-22-4 Not None None
established
Bismuth 7440-69-9 Not Not Not None None
established established established
Petroleum 8009-03-8 Not Not Not None None
established established established
10 mg/m 3
Glycerine 56-81-5 Not Not None None
established established
1 mg/m 3 1 mgFU/ME/m 3
Zinc ammonia chloride 7646-85-7 Not None None
established
This product is not controlled under Canada鈥檚 WHMIS.
PHYSICAL / CHEMICAL CHARACTERISTICS
BOILING POINT SPECIFIC GRAVITY (H20 = 1)
Not determined 2.42 Approximately
VAPOR PRESSURE (mm Hg.) MELTING POINT
(At 77掳 F) Not determined 430掳F
VAPOR DENSITY (Air = 1) EVAPORATION RATE
Not determined (Butyl Acetate = 1) Not determined
SOLUBILITY IN WATER VOLATILE ORGANIC COMPOUNDS (V.O.C.)
Less than 2% (Pounds Per Gallon Of Product) None
APPEARANCE AND ODOR pH:
Gray paste with bland odor Not applicable
FIRE AND EXPLOSION HAZARD DATA
FLASH POINT (Method Used) FLAMMABLE LIMITS LEL UEL
400掳F Not determined Not determined Not determined
EXTINGUISHING MEDIA
Dry chemical, alcohol, foam, carbon dioxide
SPECIAL FIRE FIGHTING PROCEDURES
Firefighters should wear full protective equipment and NIOSH-approved self-contained breathing apparatus.
UNUSUAL FIRE AND EXPLOSION HAZARDS
Heated containers may rupture violently. Cool with water mist to prevent overheating.
PAGE (1) (CONTINUED ON REVERSE SIDE)
REACTIVITY DATA
STABILITY: STABLE X CONDITIONS TO AVOID
Excessive heat over long periods of time
UNSTABLE X
INCOMPATIBILITY (Materials To Avoid)
Acids, oxidizing agents, sulfur chlorine
HAZARDOUS DECOMPOSITION OR BY PRODUCTS
When strongly heated, as in a fire, may produce carbon monoxide, carbon dioxide
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR X CONDITIONS TO AVOID
None known
MAY OCCUR X
HEALTH HAZARD DATA
HEALTH HAZARDS
EYES: May cause irritation or sensitization. SKIN: May cause irritation INHALATION: Mists, if produced, are extremely irritating
IF SWALLOWED: May result in irritation to gastrointestinal tract
No No No
CARCINOGENICITY: NTP? IARC MONOGRAPHS? OSHA REGULATED?
No
This product contains a chemical known to the state of California to cause cancer or reproductive toxicity?
SIGNS AND SYMPTOMS OF OVEREXPOSURE
EYES: Irritation SKIN: Irritation IF SWALLOWED: Upset stomach, vomiting, diarreha
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY OVEREXPOSURE
None known
TARGET ORGANS
None known
EMERGENCY AND FIRST AID PROCEDURES
EYES: Immediately flush eyes in clear running water for at least 15 minutes lifting upper and lower lids periodically. GET MEDICAL ATTENTION IMMEDIATELY.
SKIN: Flush skin with plenty of water for at least 15 minutes. INHALATION: Remove victim to fresh air. If breathing has stopped, administer artificial respiration.
If breathing does not return to normal within a few minutes, GET MEDICAL ATTENTION IMMEDIATELY.
IF SWALLOWED: Do not induce vomiting. GET MEDICAL ATTENTION IMMEDIATELY.
PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Absorb on inert materials such as clay, vermiculite or sand. Place in container for proper disposal.
WASTE DISPOSAL METHOD
Contact local, state, and federal authorities for proper disposal guidelines.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Store away from sources of heat, spark, and flame. Do not store with or near acids or oxidizing materials.
CONTROL MEASURES
FOR USE WHERE SIGNIFICANT EYE, SKIN OR INHALATION EXPOSURE IS LIKELY
RESPIRATORY PROTECTION (Specify Type)
For exposure below TLV and PEL valves, particle mask is recommended.
VENTILATION: MECHANICAL (General) LOCAL EXHAUST
Provide adequate ventilation Not normally required
PROTECTIVE GLOVES EYE PROTECTION
Rubber or Neoprene gloves recommended Safety glasses
OTHER PROTECTIVE CLOTHING OR EQUIPMENT
None
WORK HYGENIC PRACTICES
Wash hands and face with soap and water after handling this product.
PAGE (2)
UNITED 286 QUICKSILVER
|