UNITED 291
MATERIAL SAFETY DATA SHEET
320 37th Avenue, St. Charles, Illinois 60174 鈥? 214 Dolomite Drive, Downsview, Ontario M3J2N2 To Reorder Call:
www.unitedlabsinc.com 800-323-2594
1. PRODUCT AND COMPANY IDENTIFICATION FOR MEDICAL AND TRANSPORTATION EMERGENCIES
800-535-5053
24 Hour INFOTRAC (US and CANADA):
PRODUCT NAME USE/DESCRIPTION REVISION DATE
UNITED 291 SHINING ARMOR Acrylic Floor Finish March 6, 2008
1 0
HEALTH (0 = Maximum Safety) REACTIVITY (0 = Maximum Safety)
Always follow Label Directions and Cautions.
Susceptible to Release of Energy.
Always follow Label Directions and Cautions.
Always follow Label Directions and Cautions.
4 May detonate-vacate area if 2 Violent chemical change
4 Extreme 3 High 2 Moderate 1 Slight 0 Minimal
4 materials are exposed to fire. possible-use hose stream
3 Strong shock of heat may from distance
See Hazards Identification Section of this MSDS
detonate-use monitors from 1 Unstable if heated-use
for more detailed information.
behind explosion resistant precaution.
barriers. 0 Normally stable.
0
FLAMMABILITY (0 = Maximum Safety)
Susceptibility of Material to Burning.
PERSONAL PROTECTION: O
4 Extremely flammable. 1 Must be preheated
3 Ignites at normal temperature. to burn.
2 Ignites when moderately heated. 0 Will not burn.
2. COMPOSITION/INFORMATION ON INGREDIENTS
ACGIH OSHA LD50 LC50
Hazardous Ingredients CAS# %Range (TLV-TWA) (PEL-TWA) (Species/Route) (Species)
9210 mg/kg
Diethylene glycol methyl ether 111-77-3 2-7 NE NE NE
(Rat/oral)
3000 mg/kg
Tributoxyethyl phosphate 78-51-3 1-5 NE NE NE
(Rat/oral)
Zinc ammonium carbonate 38714-47-5 1-5 25 ppm 5 mg/m3 NE NE
3. HAZARDS IDENTIFICATION
Eyes: Can cause mild to moderate irritation.
Skin: May cause mild irritation. Prolonged or repeated contact may dry or defat skin leading to inflammation.
Inhalation: Excessive inhalation of vapors may cause nasal and respiratory irritation.
Ingestion: Can cause gastrointestinal irritation, nausea, vomiting and diarrhea.
4. FIRST AID MEASURES
Eyes: Immediately flush with plenty of water for at least 15 minutes. Get prompt medical attention.
Skin: Wash with soap and plenty of water. Wash clothing before reuse.
Inhalation: Remove to fresh air. If symptoms develop, seek immediate medical attention. If not breathing, give artificial respiration.
Ingestion: Get medical attention immediately. Unless advised otherwise by physician or poison center, induce vomiting by giving
either syrup of ipecac followed by 2 glasses of water or by sticking finger down throat. Do not give anything by mouth if person is drowsy,
unconscious or has no gag reflex.
5. FIRE FIGHTING MEASURES
Flash Point (TCC): None Explosive Limits: Lower (LEL): 1.9 Upper (UEL): 9.5
Flame Projection (Aerosol): N/A
Hazardous Products of Combustion: When ignited, as in a fire, this product may produce carbon monoxide and carbon dioxide.
Fire and Explosion Hazards: None known.
Extinguishing Media: Foam, carbon dioxide, dry chemical.
Fire Fighting Instructions: Wear self-contained breathing apparatus w/full protective clothing. Containers should be cooled with water
to prevent vapor pressure build up.
-1-
6. ACCIDENTAL RELEASE MEASURES
Small Spills: Soak up with an inert absorbent and place in designated disposal container. Wash area thoroughly. Do not flush to
sewer, stream or other bodies of water.
Large Spills: Contain material, if a substantial quantity is spilled, recover with pump or vacuum. Otherwise, soak up with an inert
absorbent and place in designated disposal container. Wash area thoroughly. Do not flush to sewer, stream or other bodies of water.
7. HANDLING AND STORAGE
Keep containers tightly closed when not in use. Store in a cool and dry area. Handle with reasonable care. Avoid breathing vapors.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Eyes: Safety goggles recommended.
Skin: Chemical resistant gloves recommended.
Respiratory: None required if good ventilation is maintained. If TLV is exceeded, a NIOSH/MSHA jointly approved air supplied
respirator is advised.
Engineering Controls: Mechanical ventilation recommended to reduce exposure.
Other Protective Equipment: Wear impervious clothing and boots.
9. PHYSICAL AND CHEMICAL PROPERTIES
Boiling Point: 212掳F/100掳C Specific Gravity: 1.05 (H2O=1) Vapor Pressure: 17.5 mmHg Melting Point: ND
Vapor Density: <1 (Air=1) Evaporation Rate: <1 (BA=1) Solubility in Water: Complete pH: 9-10
Appearance and Odor: Milky white with characteristic acrylic scent.
10. STABILITY AND REACTIVITY
Hazardous Polymerization: NA
Hazardous Decomposition: When strongly heated, as in a fire, this product may produce oxides of carbon.
Chemical Stability: Stable
Incompatibility: Oxidizing agents such as bleach.
11. TOXICOLOGICAL INFORMATION
Carcinogenicity (NTP/IARC/OSHA): None
California Proposition 65: Does this product contain chemical(s) known to the State of California to cause cancer and/or to cause birth
defects or other reproductive harm? None
12. ECOLOGICAL INFORMATION
ND
13. DISPOSAL CONSIDERATIONS
Consult your local, state, provincial and federal regulations for proper disposal guidelines. Disposal regulations may be different for each
state and/or locality.
14. TRANSPORT INFORMATION
DOT: Available upon request
TDG: Available upon request
UN: Availabale upon request
15. REGULATORY INFORMATION
VOC(Volatile Organic Compounds): < 5%
TSCA (Toxic Substances Control Act): Listed
SARA Title III Section 302 EHS: None
SARA Title III Section 311/312: ND
SARA Title III Section 313 Toxic Chemicals: Diethylene glycol methyl ether C#111-77-3
WHMIS Classification:
This product has been classified in accordance with the hazard criteria of the CPR (Controlled Products Regulations/ WHMIS) and the
MSDS contains all the information required by the CPR.
16. OTHER INFORMATION
Read and follow all label directions and precautions before using this product. These products are intended for industrial and institutional
use only. NOT FOR HOUSEHOLD USE OR RESALE. KEEP OUT OF REACH OF CHILDREN.
UNITED 291 SHINING ARMOR PREPARED BY: Sandy Kopacz
-2-
|