MATERIAL SAFETY Agate Lacquer Tri-Nat, LLC HMIS
824 South Avenue
DATA SHEET 2
HEALTH
Middlesex, NJ 08846 3
FLAMMABILITY
0
REACTIVITY
(732) 968-1080 J
PROTECTION
SECTION I
PRODUCT NAME: AGATEEN Air Dry Thinner #1
PRODUCT CODE: #1 Thinner
DATE REVISED: 1/20/04 PREPARED BY: lpt
SECTION II - INGREDIENTS
OCCUPATIONAL VAPOR WEIGHT
COMPONENT CAS. NO. EXPOSURE LIMITS PRESSURE PRECENT
TLV STEL PEL LEL
Hazardous Ingredients
Toluol 108-88-3 1.3 45-50%
50 ppm
N-Butyl Alcohol 71-36-3 1.4 15-20%
50 ppm
N-Amyl Acetate 628-63-71 1.1 5-10%
100 ppm
N-Butyl Acetate 123-86-4 1.7 20-25%
150 ppm
N-Propyl Acetate 109-60-4 2.0 1-4%
200 ppm
*Indicates toxic chemical(s) subject to
the reporting requirements of section
313 of Title III and of 40 CFR 372.
SECTION III - PHYSICAL DATA
WT/GAL: 7.06 lb
BOILING /MELTING POINT: 225-310掳 F
COATING V.O.C. 7.17 lb./gal minus water/ SPECIFIC GRAVITY:
Grams/liter
VAPOR DENSITY : Is heavier than air EVAPORATION RATE: Is slower than ether
SOLUBILITY IN WATER: % VOLATILE VOLUME: 100%
APPEARANCE: ODOR: characteristic
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
FLASH POINT : 45掳 F
FLAMMABILITY LIMITS IN AIR (% BY VOL) LOWER: UPPER:
EXTINGUISHING Foam, Alcohol, CO2, Dry Chemical, Water Fog
MEDIA
SPECIAL Respiratory equipment should be worn to avoid inhalation of concentrated
FIREFIGHTING vapors. Water should not be used except as fog to keep nearby containers
PROCEDURES cool.
Handle as flammable liquid. Vapors form an explosive mixture in air between the upper and lower
UNUSUAL FIRE
explosive limits. These vapors can be ignited by many sources such as pilot lights, open flames,
AND EXPLOSION electrical motors and switches. When this material burns toxic degradation products can be produced.
HAZARDS Firefighters should use a self contained air supply.
EMERGENCY TELEPHONE NUMBER
CHEMTREC 1-800-424-9300
SECTION V - HEALTH DATA
Inhalation Health Risks and Symptoms of Exposure: Dizziness, breathing difficulty, headaches and loss of
coordination.
Skin and Eye Contact Health Risks and Symptoms of Exposure: Severe irritation, tearing, redness and blurred vision.
Skin Absorption Health Risks and Symptoms of Exposure: Can dry and defat skin causing cracks, irritation, and
dermatitis.
Ingestion Health Risks and Symptoms of Exposure: Can cause gastrointestinal irritation, vomiting, nausea, and
diarrhea.
Health Hazards (Acute and Chronic): Acute: Dizziness, headaches, loss of coordination, breathing difficulty, eye
irritation, defatting of skin, dermatitis, nausea, vomiting. Chronic: Prolonged or repeated exposure to solvents may
cause central nervous system damage, liver abnormalities, lung damage, spleen damage.
Carcinogenicity: NTP? No IARC Monographs? No
Medical Conditions Generally Aggravated By Exposure: Anesthesia, respiratory tract irritation, dermatitis, nausea,
vomiting.
Emergency First Aid Procedures:
Inhalation Overexposure: Move person to fresh air. If breathing stops, administer artificial respiration
and seek immediate medical attention.
Eye Contact: Flush with large quantities of water for 15 minutes.
Skin Contact: Wash thoroughly with soap and water.
Ingestion: DO NOT INDUCE VOMITING. Can cause chemical pneumonitis and pulmonary edema.
Contact physician immediately.
SECTION VI - REACTIVITY DATA
STABILITY: Stable
CONDITIONS TO AVOID: Heat, sparks, sources of ignition, open flames.
CHEMICAL INCOMPATIBILITY (Materials to Avoid): alkaline materials, strong acids, oxidizing
materials.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: Carbon monoxide, carbon dioxide, oxides of nitrogen.
HAZARDOUS POLYMERIZATION: Will not occur.
CONDITIONS TO AVOID:
SECTION VII - SPECIAL PROTECTION
RESPIRATORY PROTECTION: Wear appropriate, properly fitted respirator(NIOSH/MSHA approved) during and after
application unless air monitoring demonstrates vapor/mist levels are below application limits. Follow respirator manufacturers
directions for use. In poorly ventilated and confined spaces, use a self contained breathing apparatus.
EYE PROTECTION: Use chemical safety glasses with side shields or goggles.
PROTECTIVE CLOTHING: Use impermeable aprons and protective clothing whenever possible to prevent
skin contact.
VENTILATION: General mechanical ventilation local exhaust should be suitable to keep vapor concentrations below TLV.
Ventilation equipment must be explosion proof.
OTHER: Eye washes and safety showers in the work place are recommended.
SECTION VIII - ENVIRONMENTAL DATA
OTHER PRECAUTIONS: Empty container may retain product residues (vapor or liquid). All precautions must be observed. All
equipment should be grounded.
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Eliminate all sources of ignition. Wear safety
equipment as described in Sec. VII; assume for all hazardous ingredients listed that TLV, and LEL limits will be exceeded.
Absorb on inert material and dispose.
WASTE DISPOSAL METHOD: In accordance with Federal, State, and local regulations.
DOT information 49 CFR 172.101
TRANSPORTATION:
DOT description: Paint Related Material, 3, NA1263, II
HANDLING AND STORAGE: Use non-sparking utensils when handling this material. Avoid hot metal surfaces. Use in cool,
well ventilated areas. Keep containers closed when not in use. Keep away from excessive heat and open flame.
DISCLAIMER
While Agate Lacquer believes that the data contained herein are accurate and derived from qualified sources,
the data are not to be taken as a warranty or representation for which Agate Lacquer assumes legal
responsibility. They are offered solely for your consideration, investigation, and verification.
|