Page 1 of 5
MSDS No: 00007
CAS No: 000577-11-7
Date: 03/10/2000
MATERIAL SAFETY DATA Supersedes: 07/01/1997
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
+
PRODUCT NAME: AEROSOL OT 100% Surfactant
SYNONYMS: Dioctyl sodium sulfosuccinate
CHEMICAL FAMILY: Ester
MOLECULAR FORMULA: C20H37O7NaS
MOLECULAR WGT: 444
USE: Process Chemical
MANUFACTURED BY: CYTEC INDUSTRIES INC., FIVE GARRET MOUNTAIN PLAZA,
WEST PATERSON, NEW JERSEY 07424, USA - 973/357-3100
SUPPLIED BY: CYTEC CANADA INC., GARNER ROAD, P.O. BOX 240,
NIAGARA FALLS, ONTARIO, CANADA L2E 6T4 1-905/356-9000
EMERGENCY PHONE: In CANADA: 905/356-8310 In USA: 1-800/424-9300 or 1-703/527-3887.
+ Trademark or registered Trademark
2. COMPOSITION/INFORMATION ON INGREDIENTS
WHMIS REGULATED COMPONENTS
COMPONENT CAS. NO. %(w/w) TWA/CEILING REFERENCE
Sodium dioctyl 000577-11-7 >97 not established
sulfosuccinate
3. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
APPEARANCE AND ODOR: White, waxy solid; faint odor
STATEMENTS OF HAZARD:
WARNING! CAUSES EYE AND SKIN IRRITATION
POTENTIAL HEALTH EFFECTS
EFFECTS OF EXPOSURE:
The acute oral (rat) and dermal (rabbit) LD50 values are 3.1 g/kg and greater than 10.0 g/kg, respectively.
The 4-hour LC50 (rat) value is estimated to be greater than 20 mg/L. This material produced no adverse
effects on reproductive function in rats administered it over 3 generations. No developmental effects were
observed in a teratology study in rats at doses which were not maternally toxic.
Direct contact with this material may cause moderate eye and skin irritation.
Refer to Section 11 for toxicology information on the WHMIS regulated components of this product.
4. FIRST AID MEASURES
Material is not expected to be harmful by ingestion. No specific first aid measures are required.
In case of skin contact, remove contaminated clothing without delay. Flush skin thoroughly with water. Do not
reuse clothing without laundering.
In case of eye contact, immediately irrigate with plenty of water for 15 minutes. Obtain medical attention if
irritation persists or if otherwise necessary.
AEROSOL+ OT 100% Surfactant MSDS No: 00007 Date: 03/10/2000 Page 2 of 5
5. FIRE FIGHTING MEASURES
FLAMMABLE PROPERTIES
FLASH POINT: Not applicable
FLAMMABLE LIMITS
(% BY VOL): Not applicable
AUTOIGNITION TEMP: Not available
DECOMPOSITION TEMP: Not available
MECHANICAL/STATIC SENSITIVITY: None
EXTINGUISHING MEDIA AND FIRE FIGHTING INSTRUCTIONS
Use water, carbon dioxide or dry chemical to extinguish fires. Wear self-contained, positive pressure
breathing apparatus and full firefighting protective clothing. See Section 8 (Exposure Controls/ Personal
Protection) for special protective clothing.
6. ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Where exposure level is not known, wear NIOSH approved, positive pressure, self-contained respirator. Where
exposure level is known, wear NIOSH approved respirator suitable for level of exposure. Wear same protective
clothing/equipment as in Section 8 (Exposure Controls Personal Protection.) Sweep up spills and place in a
waste disposal container. Flush area with water.
7. HANDLING AND STORAGE
Avoid contact with eyes, skin, and clothing. Wash thoroughly after handling.
Store in a cool, dry environment.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
ENGINEERING CONTROLS AND PERSONAL PROTECTIVE EQUIPMENT (PPE)
Where this material is not used in a closed system, good enclosure and local exhaust ventilation should be
provided to control exposure. Food, beverages, and tobacco products should not be carried, stored, or
consumed where this material is in use. Before eating, drinking, or smoking, wash face and hands with soap
and water. Avoid skin contact. Protective clothing such as impervious gloves, apron, workpants, long sleeve
work shirt, or disposable coveralls are recommended to prevent skin contact. For operations where eye or face
contact can occur, wear eye protection such as chemical splash proof goggles or face shield. Eyewash
equipment and safety shower should be provided in areas of potential exposure. For operations where
inhalation exposure can occur, a NIOSH approved respirator recommended by an industrial hygienist may be
necessary. A full facepiece respirator also provides eye and face protection.
9. PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE AND ODOR: White, waxy solid; faint odor
BOILING POINT: Not available
MELTING POINT: 307-315 F; 153-157 C
VAPOR PRESSURE: Not applicable
SPECIFIC GRAVITY: 1.1
VAPOR DENSITY: Not applicable
% VOLATILE (BY WT): Negligible
pH: Not applicable
AEROSOL+ OT 100% Surfactant MSDS No: 00007 Date: 03/10/2000 Page 3 of 5
SATURATION IN AIR (% BY VOL): Not applicable
EVAPORATION RATE: Not applicable
SOLUBILITY IN WATER: 1.5 g/100 g @ 25 C
ODOR THRESHOLD: See section 2 for permissible exposure limits.
10. STABILITY AND REACTIVITY
STABILITY: Stable
CONDITIONS TO AVOID: None known
POLYMERIZATION: Will Not Occur
CONDITIONS TO AVOID: None known
INCOMPATIBLE MATERIALS: Strong acids and alkalies cause hydrolysis. Aqueous solutions of this product
corrode steel.
HAZARDOUS DECOMPOSITION/ COMBUSTION PRODUCTS: Thermal decomposition or combustion may
produce carbon monoxide, carbon dioxide and/or oxides of sulfur.
11. TOXICOLOGICAL INFORMATION
Toxicological information for the product is found under Section 3. HAZARDS IDENTIFICATION. Toxicological
information on the WHMIS regulated components of this product is as follows:
Sodium dioctyl sulfosuccinate (DSS) has an average oral (rat) LD50 of 3.1 g/kg, based on measured values of
1.9 g/kg, 3.08 g/kg, and 4.3 g/kg. The dermal dermal (rabbit) LD50 is >10 g/kg. DSS has caused moderate skin
and eye irritation in animals, to varying extents, depending on the formulation of the tested material (e.g. solid
vs. solution), the tested concentration, and the the exposure duration. Following 24-hour dermal application
(rabbits) of 8 - 10 g/kg solid DSS, the only effect observed was mild erythema. In other other rabbit skin irritation
tests, the primary irritation score for 100% DSS was 鈭? 4 and that for 80% DSS with propylene glycol was 鈭?3,
both resulting in a moderate irritant classification. Solid DSS applied to the eyes of rabbits produced moderate
irritation. Solutions of DSS appear to cause irritation at lower concentrations than the solid material. In rabbits, a
concentration of 1% was the lowest reported effective dose necessary to produce slight dermal erythema and at
concentrations from 5 - 25% moderate dermal irritation occurred. Mild eye irritation in rabbits occurred following
treatment with concentrations between 0.1 and 0.5% DSS. Humans appear to be less sensitive to DSS for skin
irritation. In humans, a concentration of 1% was the highest no-effect level observed for skin irritation following a
24-hr patch test. In a modified Draize- Shelanski repeat-insult patch test, DSS showed little evidence of irritation
and and no evidence of illiciting an allergic response in human subjects. Results from a 90-day subacute oral
diet (rat) study indicate a NOEL of 0.94 g/kg/day and results from a 6-month subchronic oral diet (rat) study
indicate a LOEL of of 0.87 g/kg/day. No indication of significant gross or microscopic adverse effects were
reported. Chronic toxicity studies in rats (2-yr) and dogs (1-yr) also reported no significant adverse effects at the
doses administered. No adverse effect on reproductive function or fetal development were observed in rats
treated with DSS at 0.5 and 1.0% doses, which were not maternally toxic.
12. ECOLOGICAL INFORMATION
LC50
BLUEGILL, 96 HOUR: 37 mg/L
TROUT 96 HOUR: 28 mg/L
DAPHNIA, 48 HOUR: 36 mg/L
BOD
28 Day: 66.7 %
OCTANOL/H2 O PARTITION COEF.: Not available
AEROSOL+ OT 100% Surfactant MSDS No: 00007 Date: 03/10/2000 Page 4 of 5
13. DISPOSAL CONSIDERATIONS
Cytec encourages the recycle, recovery and reuse of materials, where permitted, as an alternative to disposal
as a waste. Cytec recommends that organic materials classified as hazardous waste according to the relevant
local or national regulations be disposed of by thermal treatment or incineration at approved facilities. All local
and national regulations should be followed.
14. TRANSPORT This section provides basic shipping classification information. Refer to appropriate
transportation regulations for specific requirements.
INFORMATION
TRANSPORT CANADA ICAO/IATA
SHIPPING NOT APPLICABLE/NOT REGULATED NOT APPLICABLE/NOT REGULATED
NAME:
HAZARD CLASS: Not Applicable Not Applicable
SUBSIDIARY Not Applicable Not Applicable
CLASS:
UN / ID Not Applicable Not Applicable
NUMBER:
PACKING Not Applicable Not Applicable
GROUP:
TRANSPORT None Required None Required
LABEL
REQUIRED:
PACKING INSTR: Not Applicable Not Applicable
PASSENGER
Not Applicable
CARGO
MAX NET QTY: Not Applicable Not Applicable
PASSENGER
Not Applicable
CARGO
D.O.T. IMO
SHIPPING INFORMATION SHIPPING INFORMATION
SHIPPING NOT APPLICABLE/NOT REGULATED NOT APPLICABLE/NOT REGULATED
NAME:
HAZARD CLASS/ Not Applicable Not Applicable
PACKING
GROUP:
UN NUMBER: Not Applicable Not Applicable
IMDG PAGE: Not Applicable Not Applicable
D.O.T. Not Applicable
(PRODUCT REPORTABLE QUANTITY)
HAZARDOUS Not Applicable
SUBSTANCES:
TRANSPORT None Required None Required
LABEL
REQUIRED:
ADDITIONAL TRANSPORT INFORMATION
TECHNICAL Not Applicable
NAME (N.O.S.):
AEROSOL+ OT 100% Surfactant MSDS No: 00007 Date: 03/10/2000 Page 5 of 5
15. REGULATORY INFORMATION
This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations and this
Material Safety Data Sheet contains all the information required by the Controlled Products Regulations.
WHMIS CLASSIFICATION: CLASS D DIVISION 2B TOXIC
INVENTORY INFORMATION
CANADA DSL: Components of this product have been reported to Environment Canada in accordance
with subsection 25 of the Canadian Environmental Protection Act and are included on the
Domestic Substances List.
US TSCA: All components of this product are included on the TSCA Inventory in compliance with the
Toxic Substances Control Act, 15 U. S. C. 2601 et. seq.
This product contains a chemical substance that is subject to export notification under
Section 12 (b) of the Toxic Substances Control Act, 15 U. S. C. 2601 et. seq. (This
requirement applies to exports from the United States only.)
EEC EINECS: All components of this product are included in the European Inventory of Existing
Chemical Substances (EINECS) in compliance with Council Directive 67/548/EEC and its
amendments.
16. OTHER INFORMATION
NFPA HAZARD RATING (National Fire Protection Association)
FIRE: Materials that must be preheated before ignition can occur.
Fire
1 HEALTH: Materials which on intense or continued exposure could cause temporary
Health 2 0 Reactivity incapacitation or possible residual injury unless prompt medical treatment is given
鈥? REACTIVITY: Materials which in themselves are normally stable, even under fire
Special exposure conditions, and which are not reactive with water.
REASON FOR ISSUE:
Revised Sections 3 & 11
Randy Deskin, Ph.D., DABT
Cytec Industries Inc.: 973/357-3100
This information is given without any warranty or representation. We do not assume any legal responsibility for same, nor do we
give permission, inducement, or recommendation to practice any patented invention without a license. It is offered solely for your
consideration, investigation and verification. Before using any product, read its label.
|