MATERIAL SAFETY DATA SHEET
Johnsens Professional Fuel Injector Cleaner
Trade Name:
4683
MSDS NO.
Revision Date: 04/24/2002
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Trade Name: Johnsens Professional Fuel Injector Cleaner
Chemical Family: Non-Chlorinated Hydrocarbon
Synonyms: None
Emergency Telephone (24 hr.): 24-Hour Emergency Information: CHEMTREC (800) 424-9300
Supplier:
Technical Chemical Company, P.O. Box 139, Cleburne, Texas 76033
2. COMPOSITION/INFORMATION ON INGREDIENTS
Ingredient/CAS No. wt. % OSHA PEL OSHA PEL ACGIH TLV ACGIH TLW
TWA Ceiling Limits TWA STEL
Petroleum Distillate (Naphtha) 55-70 None Established None Established None Established None Established
8008-20-6
Propane 10-20 1000 ppm Not Known 2500 ppm Not Known
74-98-6
Secondary Butyl Alcohol 5-15 150 ppm None Established 100 ppm None Established
78-92-2
Iso-Butane 5-10 None Established None Established None Established None Established
75-28-5
1,2,4-trimethylbenzene .5-2 Not Established Not Established Not Established Not Established
95-63-6
Naphthalene 0-2 10 ppm None Established 10 ppm 15 ppm
91-20-3
Xylene 0-.2 100 ppm Not Known 100 ppm 150 ppm
1330-20-7
Cumene 0-.2 50 ppm Not Established 50 ppm Not Established
98-82-8
This product does not contain Normal Hexane (N-Hexane).
3. HAZARDS IDENTIFICATION
Emergency Overview: Warning: Extremely Flammable. Content under pressure. This material is an eye and skin irritant. Keep away from heat,
sparks and flame. Gross inhalation overexposure may cuase: Central nervous system depression with dizziness,
confusion, incoordination, drowsiness or unconsciousness or death. Causes respiratory irritation. Aspiration into the lungs
may occur during ingestion or vomiting, resulting in lung injury.
4. FIRST AID MEASURES
Eye Contact: In case of contact, or suspected contact, immediately flush eyes with plenty of water for at least 15 minutes and get
medical attention immediately after flushing.
Ingestion: If swallowed, do NOT induce vomiting. Call a physician immediately. Never give anything by mouth to an unconscious
person. Get medical attention! If vomiting occurs, keep head lower than hips to prevent aspiration. Pulmonary aspiration
hazard if swallowed and/oil vomiting occurs - can enter lungs and cause damage.
Inhalation: If inhaled, remove to fresh air. If not breathing give artificial respiration, preferably mouth-to-mouth. If breathing is difficult
give oxygen. Get medical attention.
Skin Contact: Wash with soap and water for 15 minutes. If irritation persists or signs of toxicity occur, seek medical attention. Remove
contaminated clothing and launder before reuse.
5. FIRE FIGHTING MEASURES
Flammable Properties
Flash Point 掳F(掳C): -200 F (Lowest Component)
Flash Point Method: TAG Closed Cup
Flammable Limits in Air - Lower (%): 1.2% (Lowest Component)
Flammable Limits in Air - Upper (%): 6.7% (Lowest Component)
Autoignition Temperature 掳F(掳C): Not Determined
Extinguishing Media: Dry chemical. Carbon dioxide. Use water spray to keep containers cool that are exposed to heat or
Page 1 of 4
Trade Name: Johnsens Professional Fuel Injector Cleaner MSDS NO. 4683
flames.
Protection Of Fire-Fighters:
Special Fire-Fighting Procedures: Wear approved positive-pressure self-contained breathing apparatus and protective clothing. Vapor
may cause flash fire. Warning!! Contents under pressure. Container may rupture under fire
conditions. Decomposition may occur.
Hazardous Combustion Products: Carbon Dioxide. Carbon Monoxide.
Aerosol Comments: NFPA Level 3 Aerosol
6. ACCIDENTAL RELEASE MEASURES
Personal Precautions: Wear appropriate protective clothing and equipment to prevent skin and eye contact. Avoid breathing gas. When
airborne exposure limits are exceeded use NIOSH approved respiratory protection equipment appropriate to the
material and/or its components.
Spill Procedures: Contain any liquid from leaking containers. Avoid all sources of ignition; heat, sparks and open flames.
Do not puncture or incinerate container. Contents under pressure. Wear proper protective equipment as specified in
the protective equipment section. Remove sources of ignition. Leaking containers should be removed to an isolated,
well-ventilated area and transferred to other suitable containers. Wipe, scrape, or soak up in an inert material and put
in a container intended for flammable materials for disposal.
Environmental Precautions: Do not allow to enter sanitary drains, sewer or surface and subsurface waters. Keep out of lakes, ponds or streams.
7. HANDLING AND STORAGE
Handling and Caution: Contents under pressure. Keep away from heat and open flame. Use only in a well ventilated area. Avoid breathing
Storage: vapors, if exposed to high vapor concentration, leave area at once. Avoid contact with skin and eyes. Do not puncture, incenerate or
store above 120 F. Exposure to high temperatures may cuase bursting. DO NOT store in the passenger compartment of an
automobile.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Engineering Controls: Use in a well ventilated area. Local exhaust ventilation as necessary to maintain exposures to within applicable
limits.
Eyes: Chemical goggles; also wear a face shield if splashing hazard exists.
Skin Protection: Avoid skin contact. Wear protective clothing and gloves.
Respiratory Protection: Do not breath mist or vapor. Use in a well ventilated area. Appropriate respiratory protection shall be worn when
applied engineering controls are not adequate to protect against inhalation exposure.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Colorless to pale yellow liquid
Odor: MILD pH Value: Essentially neutral
Vapor Pressure: .37 psia @ 100 F (Liquid) Vapor Density (Air=1): .37 Approximate
Boiling Point (掳F): Not Determined Melting/Freezing Point: Not determined.
Solubility in Water: NEGLIGIBLE Bulk Density at 20掳C: 5.8 lb/gal (liquid)
Molecular Weight: Mixture Evaporation Rate: >1 (liquid)
Viscosity: Not Determined Specific Gravity (H20=1): .79 - .80 @ 60 F
VOC Content(%): >94% Decomposition Temperature: Not Determined
10. STABILITY AND REACTIVITY
Chemical Stability: STABLE.
Conditions to Avoid: Keep away from heat,sparks and flame. Avoid any source of ignition. Do not expose to heat or store at
temperatures above 120'f.
Materials to Avoid: Contact with oxidizing agents. Concentrated oxygen.
Hazardous Decomposition Products: Carbon monoxide. Carbon dioxide.
Hazardous Polymerization: WILL NOT OCCUR
11. TOXICOLOGICAL INFORMATION
Toxicological Data:
Ingredient/CAS No. wt. % Route Species Dose
Petroleum Distillate (Naphtha) 55-70 NA NA Not known.
8008-20-6
Propane 10-20 NA NA Not known.
74-98-6
Secondary Butyl Alcohol 5-15 Oral Rats LD50 6480 mg/kg
78-92-2
Iso-Butane 5-10 Inhalation Rats LC50 57 pph/15M
75-28-5
1,2,4-trimethylbenzene .5-2 Inhalation Rats LC50 18 gm/m3/4H
95-63-6
Naphthalene 0-2 Inhalation Rats LC50 340 mg/m3/1H
91-20-3
Page 2 of 4
Trade Name: Johnsens Professional Fuel Injector Cleaner MSDS NO. 4683
Xylene 0-.2 Inhalation Rats LC50 5000 ppm
1330-20-7
Cumene 0-.2 Inhalation Mice LC50 10 gm/m3/7H
98-82-8
Carcinogenicity:
Ingredient/CAS No. wt. % IARC NTP OSHA
Petroleum Distillate (Naphtha) 55-70 Not Listed Not Listed Not Listed
8008-20-6
Propane 10-20 Not Listed Not Listed Not Listed
74-98-6
Secondary Butyl Alcohol 5-15 Not Listed Not Listed Not Listed
78-92-2
Iso-Butane 5-10 Not Listed Not Listed Not Listed
75-28-5
1,2,4-trimethylbenzene .5-2 Not Listed Not Listed Not Listed
95-63-6
Naphthalene 0-2 Not Listed Not Listed Not Listed
91-20-3
Xylene 0-.2 Gruop 3 (not classifiable) Not Listed Not Listed
1330-20-7
Cumene 0-.2 Not Listed Not Listed Not Listed
98-82-8
12. ECOLOGICAL INFORMATION
Ecological testing has not been conducted on this product.
13. DISPOSAL CONSIDERATION
Waste Classification: Residues and spilled material are hazardous waste due to ignitability.
Waste Management: Not determined.
Disposal should be made in accordance with federal, state and local regulations.
14. TRANSPORTATION INFORMATION
U.S. DOT:
Proper Shipping Name: ORM-D CONSUMER COMMODITY
Hazard Class: ORM-D
UN/NA Number: Not Applicable
DOT Packing Group: Not Applicable
IMDG:
Proper Shipping Name: Aeroslols (Limited Quantity)
Hazard Class: 2.1
Hazard Subclass: Not determined.
UN No.: UN1950
Packing Group: PG II
Marine Pollutant: No
15. REGULATORY INFORMATION
US Federal Regulations:
Page 3 of 4
Trade Name: Johnsens Professional Fuel Injector Cleaner MSDS NO. 4683
Ingredient/CAS No. wt. % SARA 313 SARA 302 RQ TPQ
Petroleum Distillate (Naphtha) 55-70 Not Listed Not Listed NA NA
8008-20-6
Propane 10-20 Not Listed Not Listed NA NA
74-98-6
Secondary Butyl Alcohol 5-15 Listed Not listed NA NA
78-92-2
Iso-Butane 5-10 Not Listed Not Listed NA NA
75-28-5
1,2,4-trimethylbenzene .5-2 Listed Not Listed NA NA
95-63-6
Naphthalene 0-2 Listed Not Listed 100 lbs NA
91-20-3
Xylene 0-.2 Listed Not Listed 100 NA
1330-20-7
Cumene 0-.2 Listed Not Listed 5000 lbs. NA
98-82-8
Hazardous per OSHA 29 CFR 1910.1200
SARA 311/312 Hazard Catagories: Not Determined.
State Regulations:
Ingredient/CAS No. wt. % California Prop. 65 California Prop. 65 California Prop. 65 California Prop. 65
Cancer list Developmental Reproductive Female Reproductive Male
Toxicity
Petroleum Distillate (Naphtha) 55-70 Not Listed Not Listed Not Listed Not Listed
8008-20-6
Propane 10-20 Not Listed Not Listed Not Listed Not Listed
74-98-6
Secondary Butyl Alcohol 5-15 Not Listed Not Listed Not Listed Not Listed
78-92-2
Iso-Butane 5-10 Not Listed Not Listed Not Listed Not Listed
75-28-5
1,2,4-trimethylbenzene .5-2 Not Listed Not Listed Not Listed Not Listed
95-63-6
Naphthalene 0-2 Not Listed Not Listed Not Listed Not Listed
91-20-3
Xylene 0-.2 Not Listed Not Listed Not Listed Not Listed
1330-20-7
Cumene 0-.2 Not Listed Not Listed Not Listed Not Listed
98-82-8
U.S. TSCA: The components of this product are listed on the TSCA Inventory.
16. OTHER INFORMATION
General Notes: Do not allow undiluted material or large quantities to reach groundwater, bodies of water or sewer system.
Disclaimer:
The information and recommendations contained herein are based upon tests believed to be reliable. However, Technical Chemical Company does not
guarantee their accuracy or completeness NOR SHALL ANY OF THIS INFORMATION CONSTITUTE A WARRANTY, WHETHER EXPRESSED OR
IMPLIED, AS TO THE SAFETY OF THE GOODS, THE MERCHANTABILITY OF THE GOODS, OR THE FITNESS OF THE GOODS FOR A
PARTICULAR PURPOSE. Adjustment to conform to actual conditions of usage may be required. Technical Chemical Company assumes no
responsibility for results obtained or for incidental or consequential damages, including lost profits, arising from the use of these data. No warranty
against infringement of any patent, copyright or trademark is made or implied.
Page 4 of 4
|